A six-lane divided miltilane highway (three lanes in each direction) has a measured FFS of 70 mi/h. It is on rolling terrain with a traffic stream consisting of 17% heavy vehicles. One direction of the highway currently operates at maximum LOS C conditions, and it is known that the highway has PHF = 0.70. How many vehicles can be added to this highway (ignore capacity), assuming the proportion of vehicle types remain

A six-lane divided miltilane highway (three lanes in each direction) has a measured FFS of 70 mi/h. It is on rolling terrain with a traffic stream consisting of 17% heavy vehicles. One direction of the highway currently operates at maximum LOS C conditions, and it is known that the highway has PHF = 0.70. How many vehicles can be added to this highway (ignore capacity), assuming the proportion of vehicle types remain

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Andeng highway can accommodate speed of 80 kph under free-flowing conditions. On average, front bumper-to-bumper spacing of 1.20m is occuring on the highway such that the flow stops completely. Determine the flow of traffic on Andeng Highway if the average speed of the vehicles is 36 kph. final answer is 16,500
A six-lane freeway (three lanes in each direction) in a scenic area has a measured free-flow speed of 55 mi/h. The peak-hour factor is 0.80, and there are 8% large trucks and buses and 6% recreational vehicles in the traffic stream. One upgrade is 5% and 0.5 mi long. An analyst has determined that the freeway is operating at capacity on this upgrade during the peak hour. If the peak-hour traffic volume is 3900 vehicles, what value for the driver population factor was used?
A four-lane freeway carries 2,200 vehicles northbound (NB) in the peak hour. The freeway is relatively steep (2 miles of +4.5% grade NB). Free flow speed is measured at 68.2 mph. 15% of the vehicles are heavy trucks and 30% of those heavy trucks are SUT and the other 70% are TT. The PHF is 0.90. Determine ET, fhv, vp, BP, c, S, D, and the Level of Service (LoS)
A four-lane rural freeway segment has a 510 m grade length of 2% upgrade followed by a 630 m grade length of 3%. The freeway has 3.4-m lane, 1.5m left-shoulder lateral clearances and interchanges spaced at every 25 km. During the peak hour, there are 6% trucks, 2% buses, 2% recreational vehicles and the rest are passenger cars. Driver population adjustment is determined to be 0.90, peak hour factor is 0.90 and the BFFS is 110 km/h. At present, the freeway operates at capacity during the peak hour in the direction in question. If an additional 3.4 m lane is introduced, and all other factors stay the same, what will be the new level of service?
A 6-lane urban freeway is suggested to be designed with the following data: F.ADT = 45000 vpd, design hour factor= 0.12 and directional split = 65%. Rolling terrain, 10% trucks, 5% buses, 6% Rvs, PHF is 0.91 and all traffic are commuters. Then based on the HCM 2000 procedure, the equivalent passenger- car hourly flow rate is about
A 5% upgrade on a six-lane freeway (three lanes in each direction) is 1.25 mi long. On this segment of freeway, there is 3% SUTS and 7% TTs, and the peak-hour factor is 0.90. The lanes are 12 ft wide, there are no lateral obstructions within 6 ft of the roadway, and the total ramp density is 1.0 ramps per mile. What is the maximum directional peak-hour volume that can be accommodated without exceeding LOS C operating conditions in veh/h? Round of your answer to whole number. Blank 1
A four-lane freeway with the following characteristics: ten foot travel lanes lateral obstructions at 0 feet at the roadside total ramp density is 4.5 ramps/mile rolling terrain The roadway has a current peak demand volume of 3500 veh/h. The peak hour factor is 0.95 and there are no trucks, buses, or RVs in the traffic stream because the roadway is classified as a parkway and such vehicles are prohibited. At what level of service will the freeway operate during its peak period of demand?
If Vf = 2327 VPH with 9% trucks, VR1 = 653 VPH with 5% trucks, and VR2 = 594 VPH with 8% trucks, what is the passenger car equivalents (Vpcph) of the onramp? Assume that the roadway is urban.
A six-lane freeway (three lanes in each direction) currently operates at maximum LOS C conditions. The lanes are 11 ft wide, the right-side shoulder is 4 ft wide, and there are two ramps within three miles upstream of the segment midpoint and one ramp within three miles downstream of the segment midpoint. The highway is on rolling terrain with 10% heavy vehicles, and the peak-hour factor is 0.90. Determine the hourly volume for these conditions in veh/h. Round of your answer to whole number. fLW = 1.9, fRLC = 0.80, PHF = 0.90, N = 3 lanes PT = 0.10, ET = 3.0.