A eight-lane multilane highway (four lanes in each direction) currently operates at maximum LOS C conditions. The measured FFS is 60 mi/h. The highway is on rolling terrain with 12% SUTS and 12% TTs, and the peak-hour factor is 0.92. If 13.2% of all directional traffic occurs during the peak hour, determine the total directional traffic volume.

A eight-lane multilane highway (four lanes in each direction) currently operates at maximum LOS C conditions. The measured FFS is 60 mi/h. The highway is on rolling terrain with 12% SUTS and 12% TTs, and the peak-hour factor is 0.92. If 13.2% of all directional traffic occurs during the peak hour, determine the total directional traffic volume.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An urban freeway is to be designed using the following information. AADT = 52,500 veh/day K (proportion of AADT occurring during the peak hour): D (proportion of peak hour traffic traveling in the peak direction): Trucks: PHF = 0.94 Lane width: Shoulder width: Total ramp density: Terrain: 3 Determine the number of lanes in the peak direction required to provide LOS C. (Assume commuter traffic and assume no RVs.) lanes. 0.12 0.65 8% of peak hour volume demand flow rate 12 ft 10 ft 0.5 interchange/mile; all interchanges are to be cloverleaf interchanges rolling HV' Show all calculations required. (Calculate your answers for the peak direction only. Enter fy, the peak hour volume in veh/h, the free flow speed in mi/h, the demand flow rate in pc/h/In, the mean speed in mi/h, and the density in pc/mi/ln.) fHV peak hour volume 0.893 free flow speed mean speed density 6300 X Your response differs from the correct answer by more than 10%. Double check your calculations. veh/h 1500 X Your…
Transportation Engineering
Tubibi Highway is a Class II Two-lane highway that is considered a level terrain. Based on the data, 1,631 passenger cars travel on average per hour for both directions with a directional split of 50/50. A maximum of 388 passenger cars is recorded within a 15-min time segment of the peak hour. The traffic stream contains 2% large trucks, 3% buses, and 3% recreational vehicles. Determine the opposing direction flow rate in pc/hr. Answer in two decimal places. 2,953.65 776 margin of error +/- 0.5
A multilane highway (three lanes in each direction) is on level terrain. The free flow speed has been measured at 50mph. The peak-hour directional volume is 1500 vehicles with 10% heavy vehicles, and PHF is 0.9. If the proportion of vehicles types and peak-hour factor remains constant, how many vehicles can be added to the directional volume before capacity is reached?
A six-lane freeway (three lanes in each direction) in rolling terrain has 11-ft lanes and obstructions 4 ft from the right edge of the traveled pavement. There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. A directional peak-hour volume of 2000 vehicles (primarily commuters) is observed, with 600 vehicles arriving in the highest 15-min flow rate period. The traffic stream contains 12% large trucks and buses and 6% recreational vehicles. What is the density of the traffic stream (in pc/mi/In)? A) 16.5 B) 14.2 13.8 D 15.3
A multi-lane Minor Arterial is being designed through a level urban area. The current daily volume = 8000 vpd in both directions with 10% Trucks, peak hourly factor 90%and a 60% directional distribution factor. How many lanes are required?
Eight lane urban freeway is on mountainous terrain with lane width of 12 ft, right shoulder lateral clearance of 4 ft, and 12 ramps over the 6-mi analysis segment. The traffic stream consists of familiar road users. Peak hour volume for a directional weekday of 5200 vehicles is observed with 500 vehicles arriving in the most congested 15-min period. If the traffic stream has 10% large trucks and 12% buses and 10% recreational vehicles, determine the density in pc/mi/In. Round your answer to 3 decimal places. Exclude the unit in the answer box.
Determine the value of PTSF for a 6-mile two-lane highway in rolling terrain. Traffic data are as follows: • Volume = 1600 veh/h (two-way) • Percent trucks = 14% • Percent RVs = 4% • Peak hour factor = 0.95 • Percent directional split = 50 - 50 • Percent no-passing zones = 50
A new section of a freeway is to be designed with a free-flow-speed of 65 mph along of 0.75 mile on 5% upgrade. The expected traffic volume is 4200 v/hr. The traffic composition is 15% trucks, 5% recreational vehicles, and 10% buses. The peak hourly factor is 0.9, the unfamiliar driver factor is 0.95. If the design requirement is to target a level of service (B), how many lanes must be provided to satisfy the design requirement?
A new section of a freeway is to be designed with a free-flow-speed of 65 mph along of 0.75 mile on 5% upgrade. The expected traffic volume is 4200 v/hr. The traffic composition is 15% trucks, 5% recreational vehicles, and 10% buses. The peak hourly factor is 0.9, the unfamiliar driver factor is 0.95. If the design requirement is to target a level of service (B), how many lanes must be provided to satisfy the design requirement?
A Class I two-lane highway has a base free-flow speed of 110 km/h. Lane width is 3.6 m, and shoulder width is 2.4 m. There are six access points per kilometre. The roadway is located in rolling terrain with 40 percent no-passing zones. The two-way traffic volume is 1000 veh/h, with a PHF of 0.90. The directional split is 70:30. Traffic includes 10 percent trucks and 5 percent recreational vehicles. The length of the analysis segment is 9.5 km. Compute service flow rate for the two-way segment.
An existing four-lane freeway in rural area is with the following :information Lane width 3.5m, 0.9m lateral clearance, 1800 veh/hr peak hour volume, PHF=0.9, interchange density =0.90, 5% trucks, 5% buses and the road is within a mountainous terrain. Then based on the HCM procedure, the service flow rate (pc/h/In) is