A simply supported beam 3 meters long has a cross-section as shown in figure (i). The beam carries two loads of equal magnitude as shown in figure (ii). If the maximum compressive and tensile stresses are not to exceed 100 N/mm² and 120 N/mm² respectively, determine the maximum value of W. 80 mm 60 mm 120 mm 160 mm (i) Cross-section diagram W 1m 1m 1m 3 m W (ii)

A simply supported beam 3 meters long has a cross-section as shown in figure (i). The beam carries two loads of equal magnitude as shown in figure (ii). If the maximum compressive and tensile stresses are not to exceed 100 N/mm² and 120 N/mm² respectively, determine the maximum value of W. 80 mm 60 mm 120 mm 160 mm (i) Cross-section diagram W 1m 1m 1m 3 m W (ii)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The cross section of the AB part of the welded pipe part given in the figure is a hollow pipe and the cross section of the BC part is a circle with a solid body. The inner diameter of the pipe section is 20mm and the outer diameter is 28mm, while the diameter of the full body part is 12mm. Determine the average normal stress at the D and E points accordingly.
Answer number 2 only
4.48 A thin rod of 10 mm diameter is subjected to a tensile force of 7850 N. What are the principal: stresses and maximum shear stress? (a) 70 MPa, 50 MPa, 10 MPa (b) 100 MPa, zero, 50 MPa (c) 100 MPa, 50 MPa, 25 MPa (d) 100 MPa, zero, zero
Q1: The beam shown in Figure 1 is subjected to a vertical force Pv and a horizontal force Ph. The data for Pv, Ph, a,L,and e are shown in Table 1. Determine the maximum compressive and tensile stresses under the vertical force (at a distance a from the left support.) Pv = 80k N a = G0o 6 omm e %3D 26 K N 120 mm L =3600 mm Figure 1 250 mm
Question 3 A pair of lateral load is applied to a 3 m steel beam as in Figure Q3a to bend it plastically. The beam has a solid rectangular cross-section (30mm x 50mm) as in Figure Q3b. The steel behaves in elastic-perfectly plastic behavior with Yield Stress of 200 MPa. When 50% plastic condition at critical section, determine: a. the value of load P b. the Yielded Length, Lp corresponding to condition in part (a). 1.5P P 1m 1m Figure Q3a 1m 30mm 50mm Figure Q3b
Consider a point in a structural member that is subjected to plane stress. Normal and shear stresses acting on horizontal and vertical planes at the point are shown. Assume'stress magnitudes of 5,-80 MPa, S - 220 MPa. Sy For the given state of stress at a point in a structural member, determine the center Cand the radius R of Mohr's circle. Answers: C- MPa, R- i MPa. Save for Later Part 3 Determine the principal stresses (api > Op2 ) for this state of stress. Answers: Opl = MPa, o,2 = MPa Save for Later Part 4 For this Mohr's circle, determine the magnitude of the central angle between: (a) pointxand the point representing the principal stress opl- (b) point x and the point representing the principal stress Op2. (a) Angle - i (b) Angle - i
1.3 Civil Engineering/ Structural Theory