A rigid bar AB is supported by three rods. If a load P = 200 kN is applied to the bar, modulus of elasticity of copper is 110 x 106 kN/m² and modulus of elasticity of steel is 200 x 106 kN/m2, determine the a. the stress in the steel rod in MPa, b. the stress in the copper rod in MPa, and c. the deformation in the rods in mm. Steel rod Steel rod A = 900 sq. mm A = 900 2 m sq. mm Copper A = 1200 2 m sq. mm B 1m 1m P = 200 kN

Q: The compound bar has an assembly shown. AB is steel (E,-200GPaa, =11.7x106/C) BC is brass (Ep =105…

A:

Q: SITUATION. As shown in the figure below, a rigid bar with negligible mass is pinned at O and…

A: Given data: Allowable stress in steel =120 MPa Allowable stress in bronze=60 MPa a=1.8 m b=1.3 m…

Q: The moment M acting on the cross section of the tee beam is oriented at an angle of 0-64° as shown.…

A: A tee section is undergoing biaxial bending.The angle made by the moment axis with the vertical…

Q: Two cylindrical rods AB and BC are welded together at B and loaded as shown. Knowing that the…

A: Given data- Normal stress in AB- σAB=175 MPa, Normal stress in BC- σBC=150 MPa, To Find- The values…

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.