A rectangular plate 50 mm × 10 mm with a hole 10 mm diameter is subjected to an axial load of 10kN Taking stress concentration into account, find the maximum stress induced. [Ans. 50 MPa]

Q: The compressive strength of alumina quartz (Al2O3) is 2.1 GPa. A quartz tube is being used for a…

A:

Q: A body is subjected to uniaxial tensile stress of 20 MPa in the y-direction as well as a temperature…

A: Find the strain in x ,y and z directions.

Q: The is a rope that just cannot stretch more than 0.6 cm from a tensile force of 500N without…

A: Given: Tensile force applied on the rope, T=500 N mass of the rope, m=0.5 kg length of the rope,…

Q: Below is the stress (o = Ee) vs strain (e = 4) behavior of oxygen-free copper (OFC) wires (W8) at…

A:

Q: 2. Find what direct tensile stress load if suddenly applied on a bar 40mm diameter and 3m long would…

A:

Q: ngineering of materials need hel

A:

Q: With a thick walled cyclinder the inner radius is 0.05m and out radius is 0.2m. The internal…

A: Thick and thin cylinder: The pressure vessels are categorized according to there diameter to…

Q: A load of 500 N is applied on a cylindrical wire of 3.0 mm diameter and 2.5 x 10* mm length. The…

A: Solution: Given Data: P = 500 N d = 3 mm L = 25000 mm E = 107 GPa     To Find: Elongation in the…

Q: 1. Calculate the elongation of the cable due to load, if a steel cable of 4em diameter is used to…

A:

Q: Problem 2.11 3 of 7 > II Review Part A The plastic distorts as shown by the dashed lines. (Figure 1)…

A:

Q: consider a cylindrical nickle wire 1.9 mm in diameter and 3.0*104 mm long. calculate its elongation…

A:

Q: Problem 2. A block of cast iron was wrapped in the thin aluminum foil as shown on the figure. At…

A: Solution: Given Data: *The initial stress in the foil, σi=0 *The temperature of the Nitrogen is,…

Q: For the applied load of -10ON give your strain measurement in microstrains for strain gauge 5,…

A: Strain is defined as the ratio of change in length to the original length. As this is a…

Q: A steel [E = 200 GPa] rod with a circular cross section is 9-m long. Determine the minimum diameter…

A:

Q: The elongation of a bar of uniform cross section subjected to an axial force is given by the…

A: Elongation of the bar of uniform cross-section, δ=PLAE Here, δ is the elongation of the bar, P is…

Q: When a tensile load of 20kN is applied to a rod of length 5 cm changes its length by 1 mm. The…

A:

Thermal Properties of Materials

In mechanical engineering, the thermal property is represented as the physical quantity that is relevant to the application of heat. The thermal properties are evaluated by variations in any specific material due to low heat or high heat. The quantities that influence the thermal property of the materials are mass, density, temperature, and many others.