A radioactive isotope has an unknown half-life. Initially, there was 10 mg of the isotope in the sample. After 90 minutes, 8.2 mg remained. a.) Determine a base e function to model the amount of isotope that remains after t hours.   b.) How quickly is the amount of isotope remaining changing when 3 mg the original amount remains? Round to 1 decimal place.

Q: The figure below shows the soybean oil production process. In the  Soybean oil production is used…

A: Given that

Q: Salt is being used to preserve salmon. You need to determine the time required for the salt…

A: The problem above mentioned is the case of mass transfer of salt inside the salmon fish. The…

Q: What is the half-life of the reactant in the concentration vs time plot below?

A:

Q: The sedimentation rate of red blood cells (RBC's) in blood diluted with water and anticoagulant is…

A: Introduction The sedimentation rate is a blood check that examines inflammation in your body. It’s…

Q: Reconsider Prob. 14–54. Using EES (or other) software, plot the highest rate of hydrogen loss as a…

A: Given data: Thickness of the pipe = 1 cm Inner Diameter of pipe = 3 m Pressure = 500 kPa Mole…

Q: 4. Condensed milk is manufactured by evaporating sweetened milk. The condensed milk contains 8% fat,…

A:

Q: The following three dialysis units are set up to purify urea from the raffinate stream. For these…

A: The following parameters are given,,Total area, Permeability, Number of stages for scenario 1,

Q: An oil sample from Ares field was subjected to flash vaporization, differential and separator tests.…

A: Given :Table 1: Flash Vaporization dataTable 2: Differential Vaporization Table 3: Separator test

Q: A three-stage extraction of dilute solutions that uses pure solvent in every stage is able to…

A: Given: Three-stage extractionPure solvent used in every stageTotal solute fraction recovered = 86…

Q: Question 15 Increasing the concentrations of the reactants in a chemical reaction increases the rate…

A: Note: Since you have asked multiple questions, we will solve the first question for you. If you want…

Units and Dimensions

Dimensions are the basic concepts of the measurement of quantities. Units are the means of expressing the dimensions. For instance, an area has a dimension of L2 and a unit of m2.