A pin-jointed truss ABC shown below consists of two links AB and BC. These links are 6 mm thick and 20 mm wide as shown. There are support brackets at A and C. All pins are 12 mm in diameter and a vertical force, P = 9 kN is applied at pin B as shown. The angle 0 =38 deg. and the angle ẞ = 0 + 20 deg. The normal stress in link AB is (The result is accurate to one decimal place, in the unit MPa. Please write down only the value of your final result) · 12mm -1·0m- 20mm

Q: Determine the thickness of a 2" x 2" angle bar for members BD, BC and DE of truss as shown in the…

A: Consider the FBD of the truss:

Q: PROBLEM 07: The figure shows a truss and the sequence of assembly of members at pins H, G, and F.…

A: YyggggfcfKhhlhHkBbNjfcjjjcfRitititviyj

Q: In a 2D truss, a two-force member has two possible forces, they are .(select correct response) or…

A: In a 2D truss, a two-force member has two possible forces, they are tension or compression. In a…

Q: All members of the aluminum truss have the same cross-sectional area. Member AD and CD are made of…

A: Data Given: ∆T = 80° - 20° = 60°Cαsteel = 11.7 × 10-6/°Cαaluminium = 23.1 × 10-6/°CEsteel = 200…

Q: The steel bar AB has a diameter of 30mm and is connected to the brass bar BC. The two bars are fixed…

A:

Q: D 900 mm E a 300 mm 20 mm 50 mm 25 mm")25 mm 25 mm Section a - a

A: Given data  Dimensions  Radius  Maximum allowable stress

Q: A simple pin-connected truss is loaded and supported as shown. The truss is constructed from three…

A: Cross section are of each member area=1480 mm2. To find Normal stress in member AB and BC