A method for analysis of codeine in prescription drugs yielded the following results when applied to a codeine- free blank: 0.01, -0.2, 0.3, 0.2, 0.0, -0.1 mg codeine. Calculate the detection limit (in terms of miligrams in codeine) at 99% confidence level, based upon the mean.

A method for analysis of codeine in prescription drugs yielded the following results when applied to a codeine- free blank: 0.01, -0.2, 0.3, 0.2, 0.0, -0.1 mg codeine. Calculate the detection limit (in terms of miligrams in codeine) at 99% confidence level, based upon the mean.

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter2: Basic Statistical Analysis With Excel

Section: Chapter Questions

Problem 10P

See similar textbooks

Related questions

Q: The following results were obtained in the replicate determination of the lead content of a blood…

A: Relative standard deviation ( S) is 3.76× 10^-3 ppm. coefficient of variation is 0.5 ppm.

Q: The same chloride analysis but using a new method for which the standard deviation was not known,…

Q: An analysis of city drinking water for total hardness was done by two students in the laboratory and…

A: The solution is given below -

Q: The followng set of chloride analysis on seperate all quots af a pette pooled Serum obtained from…

A: We can perform Grubbs outlier test to solve this problem.

Q: 100 ml boiled cooled and filtered water sample takes 9.6 ml of M/50 EDTA in titration. The…

A: The hardness degree can be calculated in term of CaCO3 equivalent asDegree of Hardness=Wt. of…

Q: The amount of caffeine in an analgesic tablet was determined by HPLC using a normal calibration…

A: A question based on quantitative analysis, which is to be accomplished.

Q: In a volumetric determination of an analyte A, the data obtained and their standard deviations are…

A: The coefficient of variation, CV is the ratio of standard deviation to the mean. The titrant volume…

Q: In the determination of Pb in a contaminated fishmeal, 5.08 g of sample was weighed. Digestion with…

A: Here we are required to find the concentration of Pb in the sample in ug/kg and the % of Pb in…

Q: concentration

Q: Calculate the average and standard deviations for each solution (and solvent).

Q: Felodipine calcium channel blocker standard (0.251mg/ml) and felodipine sample (0.245mg/ml)…

A: Given that: concentration of felodipine standard = 0.251mg/ml concentration of felodipine sample =…

Q: I. Data & Results 4.0 mglmL Concentration of stock solution (include units): Table 1- Beer's Law…

A: concentration of stock solution = 4mg/mL A. 8mg/mL 0.084 B. 16mg/mL 0.173 C. 24mg/mL…

Q: The following results were obtained in the replicate determination of the lead content of a blood…

A: Please find your solution below : Standard deviation is a measure of amount of variation of a set of…

Q: 15.5 mg of Anthracene was dissolved in 200 mL of cyclohexane to prepare the stock solution. 10 mL of…

A: Molar mass of anthracene = 178.23 g/mol Mass of anthracene = 15.5 mg or 0.0155 g Volume = 200 mL or…

Q: 3. Seven analyses for the phosphorus content of a fertilizer resulted in 16.2, 17.5, 15.4, 15.9,…

Q: Using the data table given below, calculate the molar concentration for a sample dye solution with a…

A: Absorbance of dye is 0.304 We have to find concentration of dye which has absorbance 0.304 A = ϵ b…

Q: (Concentration) You are tasked to prepare 300.000 ppb of a sodium carbonate standard for a…

A: Parts per billion (ppb) concentration is defined as: mass of solute (in grams)volume of solution (in…

Q: 1) To estimate the accuracy and precision of the method of determination of glucose in a blo sample,…

A: Accuracy can be defined as how close the reading is to actual reading . It can be measured by…

Q: d. A 30.0 mL portion of the water sample was titrated with the standardized EDTA solution. Total…

A: Mean is the average of the numbers, i.e., add up all the numbers, then divide by how manynumbers…

Q: an AUDIO tutorial is available for this problem. Species of arsenic found in drinking water include…

A: A) 0.37, 0.38, 0.35, 0.39, 0.39, 0.35nd 0.38 Mg/L mean = sum of all terms / no of terms means =…

Q: Replicate water samples are analyzed for water hardness with the following results: 102.2, 102.8,…

A: Data measurements:

Q: A volumetric calcium analysis on samples of the blood serum of a patient believed to be suffering…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Pd (11), Au (III) methiomeprazine (C19 H24 N2S2) with the complex. A mixture of their complexes is…

A: Given: The molar absorptivity of Pd(II) and Au(III) at 480 nm is 3550 and 2960, respectively. The…

Q: The spectroscopic data in the table is generated with five solutions of known concentration.…

A: According to Lambert-Beer's law, the absorbance of the solution is directly proportional to the path…

Q: The detecton limits reported for Al with ICP-AES and GF-AAS are 2 ppb and 5 picograms, respectivly.…

A: Given:Al with ICP-AES = 2 ppb = 2 µg/L = 2×10-6 g/L.Mass of Al with GF-AAS = 5 picogram = 5×10-12…

Q: 25 ml of pickled brine was taken from an apple pickled with vinegar and diluted to 500 ml, 25 ml of…

A: The dilution law is shown below: N1V1 = N2V2 where; N1 = normality of unknown acid/base V1 = volume…

Q: f an instrument gives a response of 1240 for a standard containing 8 ppm of a substance, how much if…

A: The given question can be solved by using the unitary method. The assumption that we are taking is-…

Q: According to the information given below, compute the correlation coefficient and the covariance…

A: Given Standard deviation of the portfolio (stock A and stock B) : 0.37 Standard deviation of the…

Q: A solution is prepared by diluting 2.79 mL of the blue dye stock solution to 25.00 mL. The measured…

A: Given , volume of blue dye stock solution = 2.79 mL. and the final volume is = 25.00 mL. Blue dye…

Q: If the standard addition intercept is the major source of uncertainty, find the uncertainty in the…

A: Given:

Q: Find the mean sand standard deviation of each sample.

A: Let x1, x2, x3, x4....xn-1, xn are the experimental value. Mean value (x) is given by - x = x1…

Q: 3. In a preliminary experiment, a solution containing 0.083M X and 0.0666M S gave peak areas of A, =…

A: Given data: For solution: Ax = 423 As = 347 For the mixture: Ax = 553 As = 582

Q: After determining the absorbance of several standards of known concentration, the trendline for a…

A: The equation for a straight line is given by y=mx+c where m is the slope and c is the y-intercept.…

Q: Replicate tests showed the following lead content results of a blood sample: 0.752, 0.756, 0.752,…

Question

2. A method for analysis of codeine in prescription drugs yielded the following results when applied to a codeine- free blank: 0.01, -0.2, 0.3, 0.2, 0.0, -0.1 mg codeine. Calculate the detection limit (in terms of miligrams in codeine) at 99% confidence level, based upon the mean.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Quality Assurance and Calibration Methods

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Felodipine calcium channel blocker standard (0.251mg/ml) and felodipine sample (0.245mg/ml) solutions were prepared and injected to the HPLC. The peak area of felodipine standard is 275428 and the sample is 272982. The potency (purity) of felodipine standard is 98.9%. What is the assay percentage of felodipine? a. 102.23 b. 98.71 c. 101.07 d. 100.42
15.5 mg of Anthracene was dissolved in 200 mL of cyclohexane to prepare thestock solution. 10 mL of the stock solution was transferred to a 1000 mLvolumetric flask and made up to the mark with cyclohexane. The concentrationof the diluted Anthracene solution was measured by Fluorescence spectroscopyand showed to be 740 ppb. Calculate the % error
The same chloride analysis but using a new method for which the standard deviation was not known, gave the following replicate results, mean and estimated standard deviation: Chloride (ppm) = 346, 359, 350; Mean = 351.67 ppm; Standard deviation = 6.66ppm. Solve for the CI for the 3 determinations at 95% probability level.
SPECTROPHOTOMETRY 1.) Slope of regression line or Molar absorptivity (µM -1cm-1) is 0.0253 and absorbance of unknown solution is 0.131. What is the concentration of the unknown solution (µM )?
Please answer all required.
The following results were obtained in the replicate determination of the lead content of a blood sample: 0.752, 0.756, 0.752, 0.751, and 0.760 ppm Pb. Calculate the relative standard deviation and coefficient of variation of this set of data
Please don't provide hand writtten solution....
1. Data & Results 4.0 mglmL Concentration of stock solution (include units): Table 1-Beer's Law Plot Data V Volume of standard solution dispensed (mL) M, Diluted concentration (include units) Sample Absorbance A 2.00 mL 0.084 4.00 mL 0.173 l6.00 mL 0.259 8.00 mL 0.340 E 10.00 mL 0.418 Equation of trendline from Beer's Law plot: whats the diluted concentration and equation of trendline from the beers law plot once created?
None
Plot a professional quality standard curve (absorbance vs. protein amount in µg) with an appropriate title and caption underneath the plot from the data give above. The caption should include the best-fit data.
Corrects the ones that are marked wrong(6a, 6e, and 7) completely and SHOW ALL CALCULATIONS:
Please provide solutions to these questions: