A load of 10kN falls 6 mm on the end of a vertical bar 200mm long and 2500mm²cross- sectional area.(a) Calculate the instantaneous compression and stress (b) if the same load was gradually applied - find the stress (c) if suddenly applied find the stress [E = 195 GPa]

Q: 2. A load of 12 kN falls 5 mm onto the end of a vertical bar 250 mm heigh and 2500 mm² cross-…

A:

Q: The pin-connectsed structure consists of a rigid bar ABCD and two bronze alloy [E = 100 GPa] bares,…

A: GivenE=100GPaA=340mm2L1=810mmL2=1080mma=480mmb=38mmc=600mmσlim=165MPa

Q: least factor of safety if the material is cold-d

A: Sfhh

Q: For the rigid bar (AB) and rod (BC) system, the normal stress in rod BC can't exceed 30 ksi. The…

A:

Q: A specimen of a methacrylate plastic is tested in tension at room temperature (see figure),…

A:

Q: A rubber block with dimensions 120x120x120 mm is a rigid mold It is compressed with a vertical force…

A: Given data: The dimensions of the rubber block are 120 mm×120 mm×120 mm. The vertical force acting…

Q: See the figure below. AD is a member with varying diameters. There are three axial loads applied at…

A: Given data: The magnitude of the force acting at the point B is; F1=10 lbs. The magnitude of the…

Q: Q2: Figure (2) shows an isometric view of a crankshaft that is actuated by the vertical force acting…

A:

Q: 650 mm (2) 650 mm 870 mm 650 mm 55 kN B Try One (1) 800 mm X Bar properties 550 mm² 160 GPa 250 mm²…

A:

Q: A circular tube is subjected to torsion by torques T applied at the ends. The bar is 0.75 m long and…

A: The above question is based on Torsion due to Torque which is applied at the ends.

Thermal Properties of Materials

In mechanical engineering, the thermal property is represented as the physical quantity that is relevant to the application of heat. The thermal properties are evaluated by variations in any specific material due to low heat or high heat. The quantities that influence the thermal property of the materials are mass, density, temperature, and many others.