A hollow cylinder with inner radius of 30 mm and outer radius of 50 mm is heated at the inner surface at a rate of 10^5m^2W and dissipated heat by convection from outer surface into a fluid at 80∘C with h=400 m2 KW. There is no energy generation and thermal conductivity of the material is constant at 15mKW. Calculate the temperature of inside and outside surfaces of cylinder.

A hollow cylinder with inner radius of 30 mm and outer radius of 50 mm is heated at the inner surface at a rate of 10^5m^2W and dissipated heat by convection from outer surface into a fluid at 80∘C with h=400 m2 KW. There is no energy generation and thermal conductivity of the material is constant at 15mKW. Calculate the temperature of inside and outside surfaces of cylinder.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A room is initially at the same temperature as the air outdoors, 10°C. A heater whichconsumes 1kW of electricity is switched on inside the room. If the exposed surfacearea of the room is 30m^2 and the convection heat transfer coefficient from theoutside of the room to the surroundings is 6 W/m^2.°C, calculate the equilibriumtemperature reached in the room, assuming that the heater is 95% efficient. Neglectany heat transfer out of the room by conduction and radiation
At winter design conditions, a house is projected to lose heat at a rate of 60,000 Btu/h. The internal heat gain from people, lights, and appliances is estimated to be 6000 Btu/h. If this house is to be heated by electric resistance heaters, deter- mine the required rated power of these heaters in kW to main- tain the house at constant temperature.
Q6- A 1.0-kW heater is constructed of a glass plate with an electrically conducting film that produces a constant heat flux. The plate is 60 cm by 60 cm and placed in an airstream at 27°C, 1 atm with uxo = 5 m/s. Calculate the average temperature difference along the plate
THERMOFLUID A student living in a 3-m X 4-m X 4-m dormitory room turns on her 100-W fan before she leaves the room on a summer day, hoping that the room will be cooler when she comes back in the evening. Assuming all the doors and heat trans windows are tightly closed and disregarding any heat fer let through the walls and the windows, determine the temperature in the room when she comes back 8 h later. Use specific heat values at room temperature, and assume room to be at 100 kPa and 20°C in the morning she leaves.
IP Heat Transport in the Human Body The core temperature of the human body is 37.0 ∘C∘C, and the skin, with a surface area of 1.40 m2m2, has a temperature of 34.0 ∘C∘C. Find the rate of heat transfer out of the body under the following assumptions: (i) The average thickness of tissue between the core and the skin is 1.20 cmcm; (ii) the thermal conductivity of the tissue is that of water. Express your answer using two significant figures. Without repeating the calculation of part A, what rate of heat transfer would you expect if the skin temperature were to fall to 31.0 ∘C∘C? Express your answer using two significant figures.
The wall of a house, 7 m wide and 6 m high is made from 0.3 m thick brick withk=0.6 W/m.K. The surface temperature on the inside of the wall is 16C and that onthe outside 6C. Find the heat flux through the wall and the total heat loss through it.
Envision a solar water heater, a device which receives energy from the sun (solar radiation or thermal energy) and is used to heat water. The system is installed on the roof of a building where is receives energy from the sun at a rate of 500 Watts for every 1 m² of surface area. About 35% of the incoming thermal energy is lost to the surrounding environment. The remaining energy is absorbed by the liquid water and the temperature changes from 30 °C to 60 °C. Assuming the system is operating at steady state, find the amount of water (m) that this device can supply at 60 °C if the total surface area of the device is 3 m². Ignore any changes in kinetic energy, potential energy, or change in pressure that might occur in the system.
(c) Find the maximum possible thermal efficiency for a heat engine operating between two reservoirs at 750°C and 27°C. (2 pts)
ACarnot heat pump is used to heat and maintain a residential building at 22°C. An energy analysis of the house reveals that it loses heat at a rate of 2500 ki/h°C temperature difference between indoors and outdoors. For an outdoor temperature of4“C, determine (2)the COP.and (b) the power required to run the heat pump.
A cylindrical container, 6m in radius and 3m long, with a lid holds 1.657 x 107 moles of water at 30 °C has a turbine inside of it that delivers work to the water in the container at a constant rate of 3000 KW. Assume no heat can escape through the lid or the sides of the container. How quickly will the water reach 50 °C? If, at 50 °C the lid is lifted and heat escapes at a constant rate of 50KW/m2 at the surface of the water, will the pot reach its original temperature, and if so how quickly? (Density of water: 1g/cm3 , Heat capacity of water: Cp = 4.18 KJ/kg/°C)
A household freezer operates in a room at 20°C. Heat must be transferred from the cold space at a rate of 2 kW to maintain its temperature at -20°C. What is the theoretically the smallest (power) mo- tor required for operation of this freezer?
A solar radiant heat flux of 700 W/m2 is absorbed in a metal plate that is perfectly insulated on the back side. The convection heat- transfer coefficient on the plate is 11 W/m2 • C, and the ambient air temperature is 30 -C. Calculate the temperature of the plate in deg F under equilibrium conditions.