A highway is projected to carry 16,000 vehicles per day (10% of which will be 3-axle trucks with an axle load equivalency factor of 0.088) upon opening and 4% growth rate over the next 25 years. If an estimated 40% of traffic is to be in the design lane, the number of ESALS to be used in pavement design is: O 1.84 x 106 O 2.57 x 106 O 2.57 x 107 O 8.57 x 105 O 6.42 x 106

A highway is projected to carry 16,000 vehicles per day (10% of which will be 3-axle trucks with an axle load equivalency factor of 0.088) upon opening and 4% growth rate over the next 25 years. If an estimated 40% of traffic is to be in the design lane, the number of ESALS to be used in pavement design is: O 1.84 x 106 O 2.57 x 106 O 2.57 x 107 O 8.57 x 105 O 6.42 x 106

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

need it correctly
A rural principal arterial is expected to carry an ESAL of 0.188×106 during the first year of operation with an expected annual growth of 6% over the 20-year design life. If the subgrade has resilient modulus of 15,000 psi, design a suitable pavement consisting of a granular subbase with a layer coefficient of 0.13, a granular base layer with a layer coefficient of 0.14, and an asphalt concrete surface with an elastic modulus of 400,000 psi. Assume all m; values = 1 and the percent of traffic on the design lane is 47%. Use reliability level of 99%, standard deviation of 0.4, and APSI of 2.0. If the minimum required thickness of asphalt surface and aggregate base course is used, what is the design thickness of subbase?
A flexible pavement has the following class loads during a particular hour of the day. i. ii. 80 buses with 2-axles (each axle load of 40 kN) ; ii. 160 trucks with 2-axles (from and rear axle loads of 40 kN and 80 kN, respectively) Find the equivalent standard axle load repetitions for this vehicle combination as per IRC 37-2012.
Viko
The data given below pertain to the design of a flexible pavement. Initial trafic = 1213 cvpd Traffic growth rate = 8 percent per annum Design life = 12 years Vehicle damage factor = 2.5 Distribution factor = 1.0 The design traffic in terms of million standard axles (msa) to be catered would be
A flexible pavement has the following class of loads during a particular hour of the day, i. 80 buses with 2-axles (each axle load of 40 KN): ii. 160 trucks with 2-axles (front and rear axle loads of 40 kN and 80 kN, respectively) The equivalent standard axle load repetitions for this vehicle combination as per IRC:37-2012 would be A. 320 B. 250 C. 240 D. 180
Q. 4 a) Why should the effective structural capacity of an existing pavement earmarked for rehabilitation to extend its service life be evaluated? b) The following expression is associated with the use of the Falling Weight Deflectometer (FWD) on pavements earmarked for rehabilitation. 1.5pa d, = Mg MR %3D E, i. What is the structural transformation required to make the use of the above expression possible? Which parameters in the expression relate to the transformation? I1. Identify the parameters in the expression which are obtained from the FWD test and briefly III. describe how the setup of the test enables those parameters to be obtained. [You may use any relevant expression(s) or equation(s) to support your explanation.]
What is the average skid resistance of the pavement surface when a vehicle travelling at a speed of 36 kmph was stopped by applying brakes fully? (Assume the skid marks were 8 m in Length.)
Problem 2 only
A pavement designer has arrived at a design traffic of 100 million standard axles for a newly developing national highway as per IRC:37 guidelines using the following data: design life = 15 years, commercial vehicle count before pavement construction = 4500 vehicles/day, annual traffic growth rate = 8%. The vehicle damage factor used in the calculation was A B с 1.53 2.24 3.66 D 4.14
Q: What is Strategic Highway Research Program? What are the main causes of asphalt aging? Discuss in detail. Subject: Pavement Structure and design. Program: MS in Transportation Engineering.
A flexible pavement has the following class of loads during a particular hour of the day. i. 80 buses with 2-axles (each axle load of 40 KN); ii. 160 trucks with 2-axles (front and rear axle loads of 40 kN and 80 kN, respectively) The equivalent standard axle load repetitions for this vehicle combination as per IRC: 37-2012 would be