A gas is confined to a container with a massless piston at the top. (Figure 2) A massless wire is attached to the piston. When an external pressure of 2.03 bar is applied to the wire, the gas compresses from 5.40 to 2.70 L . When the external pressure is increased to 2.53 bar, the gas further compresses from 2.70 to 2.16 L. In a separate experiment with the same initial conditions, a pressure of 2.53 bar was applied to the gas, decreasing its volume from 5.40 to 2.16 L in one step. If the final temperature was the same for both processes, what is the difference betweer q for the two-step process and q for the one-step process in joules? Express vour answer with the appropriate units.

A gas is confined to a container with a massless piston at the top. (Figure 2) A massless wire is attached to the piston. When an external pressure of 2.03 bar is applied to the wire, the gas compresses from 5.40 to 2.70 L . When the external pressure is increased to 2.53 bar, the gas further compresses from 2.70 to 2.16 L. In a separate experiment with the same initial conditions, a pressure of 2.53 bar was applied to the gas, decreasing its volume from 5.40 to 2.16 L in one step. If the final temperature was the same for both processes, what is the difference betweer q for the two-step process and q for the one-step process in joules? Express vour answer with the appropriate units.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Using the ideal gas law (PV=nRT), calculate the temperature of a gas in a canister 10.4 L in volume. The pressure is 234,567 Pa and there are 32 moles. (R= 0.0821 L atm/ mol K) (101,325 Pa/1 atm).
5. The barometric pressure is generally given in units of inHg. Convert inHg to atm. Recall that 2.54cm = linch. Use dimensional analysis.
15.0 L of an ideal gas at 298.0 K and 3.36 bar are heated to 350.0 K with a new pressure of 4.40 bar. What is the new volume in litres?
The volume of a 0.5333-g sample of gas was measured at 298 K and pressures of 0.059, 0.143, 0.288, 0.341, and 0.489 bar with the results V = 14.8, 6.07, 2.99, 2.45, and 1.75 dm3. What is the molar mass of the gas? Identify which of the following gases is the correct gas sample – N2, H2O, O2 , or NH3? Note: Quantities with specific units must carry the correct units.
A gas sample has a mass of 1.211 g and occupies a volume of 677 mL. The temperature in the laboratory is 23 ⁰C and the gas pressure is 100. kPa. What is the molar mass of the gas?
Potassium chlorate upon heating melts at 355 °C and decomposes at 480 °C. In the presence of Mn02(s) catalyst, KC1O3(s) completely decomposes into O2(g) and KCl(s). However, Mn02(s) itself does not take part in the overall chemical reaction. In an experiment to determine the gas constant, 1.300 g of pure KC103(s) and 100. mg of MnO2(s) were mixed in a testube and heated over a Bunsen burner. The resulting O2(g) product was bubbled in distilled water that is at exactly 25 °C (or 298.15 K) and collected in a 100- mL eudiometer. The experiment was done under a barometric pressure of 755 torr. The vapor pressure of water vapor at 25 °C is 23.8 mmHg. After the reaction was completed, the contents of the testube containing the MnO2(s) catalyst and the KCl(s) product was weighed to be 1.285 g. The level of the liquid inside the eudiometer rests 1.36 cm below the water level in the reservoir. The graduation on the eudiometer (not shown here) indicates that the trapped gas is 88.57 mL. a. Using…
a) From the temperature-pressure data graphed in Part A, visually determine the gas pressure at a temperature of 350 K, including units. (b)From the temperature-pressure data graphed in Part A, determine the equation of the line of best fit. (C) What are the units for the slope of the line of best fit determined in question 2? (D) From the equation of the line of best fit determined in Question 2, algebraically determine the gas pressure at a temperature of 350 K, including units and a unit analysis. Note: I only need su part D solve please
8. ) ( delete 8. 9.
15.0 L of an ideal gas at 298.0 K and 3.36 bar are heated to 350.0 K with a new pressure of 4.15 bar. What is the new volume in litres?
A gas sample occupies 200 mL at standard pressure (101.3 kPa). Calculate the volume it will occupy at 91.0 kPa.
‏You are working in an oil refinery . Where you use hydrocarbon gases like methane ( CH4 ) , ethane ( C2H5 , and propane ( C3Hg ) and prepared a mixture . When measured the pressure at 25 ° C it turns out to be 7.50 am This gas mixture was then also used in a mass spectrophotometer and the following data was obtained Based on this information find the partial pressure of each gas and report respectively as their name .appeared in the question
Combustion of hydrocarbons such as pentane (C5H12) produces carbon dioxide, a "greenhouse gas." Greenhouse gases in the Earth's atmosphere can trap the Sun's heat, raising the average temperature of the Earth. For this reason there has been a great deal of international discussion about whether to regulate the production of carbon dioxide. A.) suppose 0.100 kg of pentane are burned in air at a pressure of exactly 1 atm and a temperature of 13°C. Calculate the volume of carbon dioxide gas that is produced. Round your answer to three significant digits.