assume that the pressure is 1.00 atm and is being kept constant at 1.00 atm in the process below. the initial temperature of a helium gas in a ballow is T1 = 350.0 k and the volume is V1= 50.0 L. if the temperature of a gas in a ballom increases from 350.p k to 500.0 k what will the final volume V2 of the balloon be %3D

assume that the pressure is 1.00 atm and is being kept constant at 1.00 atm in the process below. the initial temperature of a helium gas in a ballow is T1 = 350.0 k and the volume is V1= 50.0 L. if the temperature of a gas in a ballom increases from 350.p k to 500.0 k what will the final volume V2 of the balloon be %3D

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

For the following reaction: C3H8(g) + 3CO₂(g) + 4H₂O(1) 502(g) The change in gaseous moles, An = To maximize the product yield, the volume of the container should ◆ , so that the pressure will be (> →
Calculate the volume occupied by 1.5 moles of an ideal gas at 25 C and a pressure of 0.80 atm. (R=0.08206 L. atm/(mol.K).
Hot gaes Expanding A mixture hot gases expands, changing volume from 2.45 L to 6.82 L, against a constant pressure of 3.22 atm. The P-Vwork involved is Latm .
Please answer the question Below.
4. At 5°C and 1 atm, x L of O2 gas is required to react with 0.51 g of glucose, what is the value of x? The unbalanced reaction is shown below: C6H12O6 (s) + O2(g) → CO2(g) + H2O(l)
A student experimentally determines the gas law constant, R, by reacting a small piece of magnesium with excess hydrochloric acid and then collecting the hydrogen gas over water in a eudiometer. Based L-atm on experimentally collected data, the student calculates R to equal 0.0832 mol·K L-atm Ideal gas law constant from literature: 0.08206 mol·K (a) Determine the percent error for the student's R-value. Percent error = % (b) For the statements below, identify the possible source(s) of error for this student's trial. The student notices a large air bubble in the eudiometer after collecting the hydrogen gas, but does not dislodge it. The student does not clean the zinc metal with sand paper. The student does not equilibrate the water levels within the eudiometer and the beaker at the end of the reaction. The water level in the eudiometer is 1-inch above the water level in the beaker. The student uses the barometric pressure for the lab to calculate R.
Consider the following samples of gas: sample composition pressure temperature A 2.0mol Xe (g) 1.7atm 228.°C B 2.0mol Xe (g) 1.4atm 258.°C C 2.0mol Xe (g) 1.6atm 280.°C sample composition pressure temperature D 1.5mol He (g) 1.5atm 41.°C E 1.5mol Ar (g) 2.4atm 41.°C F 1.5mol Ne (g) 1.2atm 41.°C Draw the set of graphs below that show the distributions of the speed of the atoms in each sample.
7. When detern ing the mass of a liquid, ras in a hurry and did not allow enough time for the temperature of the flask to reach the temperature of the boiling water bath. The student recorded the temperature of the gas as 100.0°C when it was only 80.0°C, Is the molar mass calculated by the student higher or lower than the accepted molar mass, or does this error have no effect on the calculated result? Briefly explain your answer # 2/HB Office DEPOTS b) If the student assumed the volume of the flask was 125 mL (as marked by the side of the flask) rather than measuring the volume experimentally, would the unknown's calculated molar mass be too high, too low, or unaffected? Explain. # 2/HB 4
What is kinetic energy of one mole of an ideal gas st 25C?
Please see question 28, just the top one. I figure in this system the pressure is changing and my answer is the original pressure divided by the final pressure is equal to X. Do I have this correct? pv= nRT N and T and R are constants thus P1V1 = P2V2.