A fully work-hardened Aluminum blank of 100mm diameter and 1.2 mm thickness has a constant flow Stress of 350 MPa. It is deep drawn in a constant thickness Process to a cylindrical cup of somm mid-wall diameter. The blank-holder force is 30 KN and the friction Coufficient is 0.1 -- what is the final height? b-what is the approximate value of the maximum Punch force ? Aus/a-37.5mm, b-57KN

Q: Von mises and tresca agree in pure shear

A: In machine design, mainly five failure theories are used to relate stress with the strength of…

Q: Sketch Mohr's circles for Uniaxial tension Hydrostatic compression Pure shear.

A:

Q: Rolling: A rolling operation is performed on a 5 mm thick sheet of low carbon steel (K=530, n=0.26…

A: Given:To find:

Q: a) Each cylinder in a four-cylinder car engine has a bore diameter of 63.53 mm and the stroke for…

A:

Q: is recreating rolling The large stone columns by animal power and pivot points cut into the center…

A: (a) Draw a free-body diagram of stone column.

Q: Whoop- ニフ P:?

A:

Q: For the drawing operation of Problem 3 (Cup Drawing), the tensile strength of the sheet metal…

A:

Q: - 400 mm wide 25 mm thick strip is fed through a rolling mill with two powered olls each of radius…

A:

Q: A double riveted single cover butt joint (zig zag arrangement), is used for connecting two plates…

A: Given:- Permissible shearing stress in rivets = 120 MPa- Permissible tensile stress in plate = 150…

Q: How do i determine the shear diameter of a shear pin made from 0.20C cold drawn mild steel using…

A: Given: The material is 0.20C cold drawn mild steel. And the tensile yield strength of the 0.20C cold…

Q: (3) A machine part of uniform thickness t = b/2.5 is shaped as shown and machined all over from AISI…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: Each cylinder in a four-cylinder car engine has a bore diameter of 63.53 mm and the stroke for each…

A:

Q: A rigid block (neglect its weight) is to be supported by three equally spaced rods (spaced by a…

A: The schematic diagram is Free body diagram of the rigid block

Q: A 1-in diameter hole is to be punched through a 1/8-in thick annealed titanium-alloy  Ti-6Al-4V…

A:

Q: Need help on all questions. Please include all units, steps to the problem and information such as…

A: I

Q: A mechanical press is used in a forging operation of a 13.5mm in diameter cylinder. The press is…

A: Given Data The initial diameter is: Di=13.5 mm The Motor power is: P=26.4 kW The velocity is: V=308…

Power Transmission Elements

It is defined as the energy transfer from one location to another location. The energy will start moving from the energy generation source to the energy applied position to obtain the work output. From this method, a large amount of electric energy moves from the power station to various electrical substations.