A fluid enters a device steadily at 35 m/s, 200 kPa and 65C and exits at 240 m/s and 95 kPa. The heat transferred from the device to the surrounds at 17C is founded to be 3 kJ/kg. If the exit velocity is varying from 100 to 300 m/s, determine the exit temperature and exergy destroyed and plot the results. Take the fluid is Air. Please solve the above question with EES only.

A fluid enters a device steadily at 35 m/s, 200 kPa and 65C and exits at 240 m/s and 95 kPa. The heat transferred from the device to the surrounds at 17C is founded to be 3 kJ/kg. If the exit velocity is varying from 100 to 300 m/s, determine the exit temperature and exergy destroyed and plot the results. Take the fluid is Air. Please solve the above question with EES only.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The velocity through the throat of a venturi meter is four times that of the velocity through a pipe that has a diameter of 0.5 m. How much is the deflection of the mercury levels in mm if the reported discharge is 0.01 m³/s? Use cp = 0.6. Pressure-sensing holes Throat section Deflection Mercury
m7
W.done
A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4 inches of carbon tetracloride (SG=1.59), 2 inches of water and 12 inches of syrup (SG= 1.31). The aire chamber in the tank is pressurized at 1296 psf. A.) Determine the pressure at the interface of carbon tetrachloride and syrup. B.)Determine the difference in pressure between the interface of water and syrup and the interface of carbon tetrachloride and syrup. C.)Compute the hydrostatic pressure (in psf) acting at the bottom of the tank.
I need the answer as soon as possible
Q2// Consider a special ball made of steel (p- 5000 kg/m', Cp- 300 J/kg. k, A= 60 m²). The initial temperature of the ball is 300 K. It is immersed in a large oil tank at 400 K. The convective heat transfer coefficient, h at the sphere surface is 3000 W/m³. k. Assume that there is no radial temperature gradient inside the ball. Use Euler's method to find the temperature of the sphere at t = 15 sec after it was immersed in the oil tank. Use a step size of h= 5 sec. The energy balance equation of the ball is given by the following equation: dT pCp -=-hA(T-T₂) dt
Quick please
Above is a pressure vessel with air in the form of gas. If the pressure vessel is used in the air vehicle, please provide at least two recommendations that can be applied in the system to ensure that the gas pressure inside does not change in the event of a temperature change due to a change in altitude
A fluid of specific gravity 0.8 and dynamic viscosity 15 x 10-4 Pa.s is flowing in a 15 mm diameter straight galvanized iron pipe (e = 0.3 mm, C = 130) of length 160 m. The flow velocity is 0.163 m/s. Calculate the friction head loss using Darcy-Weisbach and Hazen-Williams formulas.
Can you please help with the below Qs?
11. Please answer no. 11 thank you!
Calculate the density of water vapor at 350 kPa abs and 20 °C if its gas constant (R) is 0.462 kPa m³/kg · K.