An assistant pumps all the soccer ball for a tournament to 8.5 psi in the hot locker room before bringing them outside in the cold to be used. Which of the follow would happen?   The soccer balls will be within regulation pressure since temperature plays no role in the pressure.  The soccer balls will explode from increased pressure The soccer balls will deflate from decreased pressure

Q: How much bleaching powder is needed to chlorinate 5000l of water whose chlorine demand is 2 mg/l,…

A:

Q: The temperature and pressure of nitrogen in a tank are 28 °C and 600 kPa abs, respectively.…

A: The temperature of nitrogen in a tank, T=28 °C. The pressure of nitrogen in a tank, P=600 kpa. Gas…

Q: Help solve both of these for my homework. Please

A: Q5Q6

Q: Three liquids that will not mix are poured into a cylindrical container. The volumes and densities…

A:

Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…

A: Given: Temperature of carbon tetrachloride = 68°F Avg. diameter = 230 µm = 230*10-6 m Required:…

Q: potassium acetate

A:

Q: QUESTION # 2 A brass cube 6 in on a side weighs 67 Ib. We want to hold this cube in equilibrium…

A:

Q: A liquid which is compressed in a cylinder has a volume of 1 liter at 2Mpa, and a volume of 990…

A: Given data : V1 = 1000 cu.cm , V2 = 990 cu.cm , P1 = 2 Mpa , P2 = 2.5 Mpa Find : Coefficient of…

Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…

A: The diameter of the carbon tetrachloride droplet,To determine the pressure difference between the…

Q: the answer for a is 40.3 degree Celsius. please answer letter B only. thank you

A: Given data in question Length Aluminum rests freely on ground. Steel bar is 5mm longer Coefficient…

Q: Q2: A hot concrete slab comes from a furnace at an inatial temperature of 85 C. To cool down the…

A:

Q: Draw a graph showing the emulsification breaker effect over time points (W X Y Z) .

A:

Q: An activated-carbon bed that is 12 ft x 6 ft x 2 ft deep is used in a benzene recovery system. The…

A: Solution; Given data; Depth of bed D = 2 ft Void fraction ε = 0.40 Gas viscosity µ = 0.047 lb/ft-hr…

Q: Explain briefly how you would determine if the flow in a pipe was certain to be laminar

A: Laminar flow:It is assumed that each liquid layer passes the adjacent layer without excessively…

Q: 5. Pressure variation for compressible fluid is maximum for which kind of process? a) Isothermal b)…

A:

Q: Ammonia enters the expansion valve of a refrigeration system at a pressure of 10 bar and a…

A:

Q: The concentration of VSS in the returned flow rate to the aeration tank = 4000 mg/L while the MLVSS…

A: Given data- Aeration Tank-VSS concentration= 4000 mg/LMLVSS concentration= 2500 mg/LMLSS…

Q: Glycerin (specific gravity 1.26) in a processing plant flows in a pipe at a rate of 805 L/s. At a…

A: Given data:

Q: 1.47 A cylinder contains 12.5 ft³ of air at 120 °F and 40 psia. The air is then compressed to 2.50…

A:

Q: Determine the pressure at the interface of carbon tetrachloride and syrup b.) Determine the…

A: Z

Q: 20-mm diameter 0.3 m 0.6 m 60-mm dameter

A:

Q: Due to rise in temperature, the viscosity and unit weight of percolating fluid are reduced to 70%…

A: The given data is: The reduction in viscosity=70 % The reduction in unit weight of percolating…

Q: Derive the relation for adiabatic compressibility for ideal gas.

A: Here is the proof for adiabatic compressibility for ideal gas

Q: venturi meter with a throat diameter of 100 mm is installed in a 250 mm pipe. Air @ atmospheric…

A:

Q: Thermometer measures the latent heat. Select one: O True O False

A: Thermometer measures the latent heat.

Q: Surface Nozzle Fluid stream F1 Surface Nozzle Fluid stream F2

A: Write the component of force F1 in x-direction. F1=-ρA1V121-cosθ=-ρA1V121-cos90°=-ρA1V12 Write the…

Q: What is the system pressure when the cylinder retracts? is it more or less than the pressure when…

A:

Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…

A: Given data:- The diameter of the droplets is,   D=230 μmD=230×10-6 m we know,…

Q: Q4: A. Calculate the pressure of steam at a temperature of 500°C and a density of 24 kg/m³ using (a)…

A:

Q: How much bleaching powder is needed to chlorinate 5000l of water whose chlorine demand is 2 mg/l,…

A:

Q: difference in pressure between the inside and outside of the droplets?

A: Let σ be the surface tension From physical properties, Carbon tetra chloride has surface tension σ…

Q: A 2-ft diameter column packed with l-teu ceramic Raschig rings was operated with air and water and…

A: Consider the given data D=2 ft.  Qy=356 ft3/minT=80oF,  P=1 atmR=0.7302…

Q: A small lake with volume 10,000 m3 has a stream flowing into it with flow rate 100 m3/day and a…

A: a) The increase in discharge concentration will cause a slight increase in the lake concentration.…

Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…

A:

Temperature Difference and Heat Transfer

Whenever there is a flow of heat flux resulting from a temperature gradient within the material or between two materials, there is heat transfer. Heat transfer primarily arises due to temperature differences between two bodies or within bodies. The term temperature gradient denotes temperature differences or variation of temperature due to change in some quantity. The fundamental use of the concept of temperature is found in the zeroth law of thermodynamics.