A diesel power plant provides power for Meralco in 20 hrs per day of operation.  The industrial fuel used is 40 deg. API at 15.6 deg. C. The total consumption is  3500 L per day at 30 deg. C. Determine the following: a. Mass Flow Rate b. Total cost of fuel for an eight-week operation if total cost of fuel per gallon is  52 pesos

Q: A Wind Energy Conversion System with the following data: Downward wind velocity:8 m/s Upward wind…

A:

Q: A petrol engine with with 8 cylinders is having bore of 30 cm and stroke length of 30 cm. The engine…

A: Write the given values along with the suitable variables.

Q: 8. After checking on the properties and Phase descriptions of water, the quality is found to be x =…

A: Dryness fraction is defined as the ratio of the mass of the actual dry steam to the mass of steam…

Q: The fan/blower installed in the central air conditioning system is of the axial flow type. This…

A: Given: Po = 110.29 kPa Patm = 101.3 kPa V = ?

Q: A mining pit about 5000ft below sea level was flooding as a result of heavy down pour. The situation…

A:

Q: For a 6-cylinder, 4-stroke, diesel engine, the following data is available: brake power = 120 hp,…

A: Given : P = 120 hp = 89.484 kW N = 2500 rpm bsfc = 240 g/kWh ρf=0.85 g/cm3 To find : Fuel pump size

Q: A fixed volume insulated tank, initially empty, was connected to a distribution line carrying helium…

A: Given data:

Q: Superheated steam at 350 0C and 20 bar enters the turbine of steam power plant and expands to a…

A:

Q: The generato efficiency of a diesel fuel power plant is 98% with engine generator rating of 0.212…

A:

Q: b) enters the turbine at a velocity of 70 m/s. The steam leaves the turbine at a point 2 m below the…

A: Solution is given below

Q: .1 A heat engine receives heat transfer rate at 1 MW at a high temperature of 550 °C and rejects…

A: According to company's guidelines,  only First question has to be answered.

Q: One kilogram of air at 100 kPa, 20°C is compressed in a otto cycle with a commpression ratio of 7 to…

A: Otto cycle - One kilogram of air at, P1 =100 kPa, T1 = 20°C = 293 K.  commpression ratio (rk )= 7…

Q: The specific heat capacity value is generally high for _________ a. polymers b. ferrous metals c.…

A:

Q: In the recorded data the above Diesel power plant consumed 38 liters per hr. in 21 hrs operation per…

A:

Q: compressive heating occurs within the combustion process in SI engines due to: a) Increasing the…

A: We need to define compression heating.

Q: 5. What is the injection duration (deg) needed for fuel injection in a single cylinder dies perating…

A: Given   Speed, N = 1450 rpm   Power, P = 52 kW        BSFC = 0.25bkg/kW.h      Area, A = 1.5 mm2…

Q: 9- Which of the following cycle consists of two isothermal and constant pressure processes? a) Joule…

A: Correct answer: 9. (e) Ericsson cycle 10. (c) Brayton cycle

Q: In wind energy conversion system, if less blades are available on a wind turbine that leads to O a.…

A: Option c is correct.

Q: 10. An engine developing 30 brake horsepower must be cooled by a radiator through which water is…

A: given:Power=30 brake HPHeat transferred from engine to cooling tower=40 HPTop water…

Q: Multiple Choice 1. What kind of Filter you used in Air a. Replaceable paper element b. Duplex Filter…

A: To clean air, eater, and oil various types of filters are used and each filter has its own…

Q: 1.A boiler burns fuel oil with 20% excess air. The fuel oil may be represented by C15H32.Calculate…

A: Given data: excess air=20% Need to determine the air fuel ratio by weight.

Q: ow you will integrate the wind, solar, Biogas. Explain with neat diagram of an integrated Hybrid…

A:

Q: The heat capacity rate is the O a. the ratio of the mass flow rate to the specific heat of a fluid O…

A: To find  :  the heat capacity rate is the

Q: 02/Explain the operation and benefits of AMT.

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Which of the following are correct and valid for the Clacius statement? □ a. Any b. Clausius Oc. It…

A: Heat pump: It is a device which is used to absorb heat from the outside atmosphere and supply to the…

Q: A fuel tank is filled with propane gas and heat is transferred from the surroundings at a rate of 50…

A: GIVEN DATA - HEAT TRANSFERRED Q=50W WE HAVE TO FIND INCREASE IN ENERGY DURING 24 HOUR PERIOD

Q: O Explain how the following jet engine works. Refer to each section of the engine and explain the…

A:

Q: Compute the engine cap of fuel engine power plant with 72 82% gen efficiency and supercharge engine…

A: Given: Efficiency = 72.82% = 0.7282  Supercharge engine capacity = 227 kW

Q: mber of barrels of oil required per day if the efficiency of  the fuel oil plant is 25%.  ii.…

A: The powerplant is a set of mechanical devices which is used to produce the power output to run the…

Q: Compute the engine load in KW per cylinder of a fuel engine power plant if it has 8 cylinders and…

A: Super charge engine capacity, Pn= 192.88 kW Number of cylinders, n= 8   To find: Engine load (P) in…

Q: shows the diesel engine cycle. It is very similar to the Otto cycle (presented in the textbook), but…

A:

Q: The fuel used in the diesel engine is C10H22. The air in the engine inlet and the exhaust gases in…

A: Given dataFuel used C10H22 To determine a] How much energy lost due to incomplete combustion of one…

Q: There is a steam power cycle that uses water as the working fluid, where the condenser pressure is…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: Fuel System on Diesel Power Plants:   1. How the selected system works.   2. Variants of the…

A: Since we only answer up to 3 subparts, we will answer the first 3. Please resubmit the question and…

Q: An ideal Otto cycle engine with 13% clearance operates on 0.227 kg/s of air; intake state is 105.90…

A:

Q: A fixed volume insulated tank, initially empty, was connected to a distribution line carrying helium…

A: GIVEN:Ti=135°CCp=5.1926 KJ/KgK

Q: Liquid ammonia at a temperature of 26 OC is available at the expansion valve . The temperature of…

A: Answer: (a) The percentage of liquid vaporized is 9.0185%. (b) The internal energy entering the…

Q: 8. A steam condenser receives 39.68 English Ton per hour of steam with an enthalpy of 1,104.97…

A: Given:Mass flow rate of the steam, m˙steam=39.68 Tons/hr=39.68×2000 lb/hr=79360 lb/hr    1…

Q: kw per cylir of the crank and combu

A:

Q: A cogeneration system consists of an engine and a boiler, both working with naturalgas. Heat is…

A: Given: Calorific value of natural gas 38MJ/m3 Mechanical efficiency of the engine: 35 % Alternator…

Q: I) C,H, is burned in an engine with a rich fuel-air ratio. Dry analysis of the exhaust gives the…

A:

Q: 9.1 We want to get an idea of the actual mass of 235U involved in powering a nuclear power plant.…

A: Reactor Power Calculation Multiplying the reaction rate per unit volume by the total volume of the…

Q: In a gasoline engine with a compression ratio of 9, the compression process At the beginning, the…

A: Given data for otto cycle Compression ratio (r) = 9  P1 = 100 kPa  T1 = 300 K  Qs = 1310 kJ/kg…

Q: Below figure shows Ts diagram of an aircraft engine. Draw the engine diagram only. Answer the…

A: Given:

Q: 4.A boiler uses coal for fueling a power plant. The heating value of coal is 74500 kJ per kg of fuel…

A: given; A boiler uses coal for fueling a power plant. The heating value of coal is 74500 kJ per kg of…

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.