A diesel engine was tested for a continuous 3 hours of operation. It consumed at total of 5 liters and developed a constant power of 7.5 kW. If the fuel contains 45.46 MJ/kg, what is the approximate thermal efficiency?

A diesel engine was tested for a continuous 3 hours of operation. It consumed at total of 5 liters and developed a constant power of 7.5 kW. If the fuel contains 45.46 MJ/kg, what is the approximate thermal efficiency?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: a) Rankine cycle ratio (RCR) b) Theoretical steam rate (TSR) c) Actual steam rate (SR) d) Steam flow…

A: Definition:The Rankine cycle ratio (RCR) is the cycle's net work output divided by its heat intake.…

Q: Your answer has been saved. See score details after the due date. The expression used to solve for…

Q: Explain the reasons why the Diesel station is superior to the thermal power station? mention it?

A: Given Diesel station To find Advantage of diesel engine over thermal power plant station

Q: At the beginning of the compression process of an air standard Otto cycle, pz = 1 bar, T1= 300 K.…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: can you include all the calculations step by step please, such as scaling law and propulsive…

A: We apologize for the earlier confusion. The correct solution is given below.μ = 5V = 100 m/sVh =…

Q: net heat rejected to reservoir C by CE-2

A: Given data; Carnot engine (CE-1) works between two temperature reserviors A and B;TA=900…

Q: The actual power output of a wind turbine with an efficiency of 59% is 1250kW. The predicted output…

Q: 3. WHAT TURBINE WORK AND ENGINE EFFICIENCY IF THE INLET PRESSURE AND TEMPERATURE ARE 24MPA AND…

Q: The generato efficiency of a diesel fuel power plant is 98% with engine generator rating of 0.212…

Q: If the compression ratio of diesel engine is 18.7 and the cut off ratio is 2.3, the expansion ratio…

Q: A solar plate collector maintains a hot water reservoir at 90 °C. A. Calculate the efficiency of a…

Q: At the beginning of the compression process of an air standard Otto cycle, p, = 1 bar, T, = 300 K.…

Q: 5. Dynamic force presents a greater risk of strain than static force. True False

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: this answer i need relative efficiency =62.95 only dont send wrong solution

Q: Q2. Thermal power station contains three units, one 700kw and two units with 500kw for cach one. The…

Q: Q1/ A turbojet engine powers an aircraft that is flying at a speed of 240 m/s, has an exhaust speed…

Q: 5. Find the guaranteed indicated thermal efficiency of an oil engine which must develop 4500 ihp at…

A: Write the calorific value of fuel 20o API gravity. CV=9520 kcal/kg=9520 kcal/kg4.18 kJ1…

Q: In the recorded data the above Diesel power plant consumed 38 liters per hr. in 21 hrs operation per…

Q: what is the steps to do thermal cycle analysis of MGT of range extender fueled by hydrogen using…

A: Thermal Cycle Analysis of MGT in a Hydrogen Fueled Range Extender with MATLABHere's a breakdown of…

Q: Perform on quad paper. Let's take a VW Jetta; it can have a turbodiesel with 50 mpg and a 4-cylinder…

A: Solution:

Q: A diesel power plant uses fuel with heating value of 45,325 kJ/kg. What is the density of the fuel…

A: Heating value, Q= 45325 kJ/kg T= 40∘C To find: Density of the fuel at 40∘C, ρat 40∘C Note:…

Q: An Otto cycle engine is operating on the following conditions: The pressure and temperature at the…

A: As per given question P1=150 kpa T1=300k Maximum condition P3=5100kpa T3=2900 k We have to find…

Q: Discuss the function of the diesel and gasoline engines of each part.

A: Solution: In a gasoline engine, fuel is mixed with air, compressed by pistons and ignited by…

Q: A constant volume fuel-air cycle operate at a compression ratio of 8. The maximum cycle temperature…

A: For solution refer below images.

Q: How much revenue can be generated in a year from a wind turbine if the power generated is sold at 25…

Q: miller cycle pv and ts diagram explication

A: The objective of this question is to explain the Pressure-Volume (PV) and Temperature-Entropy (TS)…

Q: Calculate the efficiency of the Carnot Engine for ideal gas. Consider the figure below for a…

A: where segment ad and bc are the Adiabatic process.and ab and cd are the isothermal processes.and the…

Q: The Kelvin temperature of the hot reservoir of a Carnot engine is twice that of the cold reservoir,…

A: Given data: ◆ The Kelvin temperature of the hot reservoir of a Carnot engine is twice that of the…

Q: At the beginning of the compression process of an air standard Otto cycle, p1 - 1 bar, T1 – 300 K.…

Q: The Otto engine intakes 0.4 kg of air at 100 kPa and 300 K. The air is compressed compression ratio…

A: Disclaimer: “Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: The motor of an electrical appliance consumes 18 000 J. during its operation, 9450 J dissipated in…

A: Given: Energy consumed by the motor is 18 000 J. Heat dissipation is 9450 J. Energy to produce light…

Q: For the engine of an incomplete expansion cycle, the engine thermal efficiency is 35%. If the…

A: Given: Engine thermal efficiency = 35% Indicated thermal efficiency = 31.45 % The question is not…

Q: steam Power plant calculate e fficiency of the Ran Kine cycle and the carnot cycle and For (case1)…

Q: O Explain how the following jet engine works. Refer to each section of the engine and explain the…

Q: . Operate at higher initial pressure. P1=80 bar (saturated) P2=1bar. Determine Point 1 and 2 then…

Q: A stationary diesel engine with a thermal efficiency of 40% produces 200 horsepower. The exhaust…

Q: 2. Operate at higher initial Temperature (super heat the steam) P1=50 bar T1=400°C P2=1bar.…

Q: A diesel power plant has a super charge engine capacity of 128.15 KW, with 83.5% gen. efficiency,…

Q: 2. A Ste am power plant uses a Rankine cycle to produce electrical power. The boiler pressure is 2…

Q: 58,300 kg/hr of steam is being throttled in a turbogenerator at 6.5 MPa and 500 °C and leaves at…

A: (a) Write the enthalpy of steam at 6.5 MPa and 500 oC. h1=3417.12 kJ/kgu1=3078.55 kJ/kg Write the…

Q: At the beginning of the compression process of an air standard Otto cycle, p1 = 1 bar, T1 = 300 K.…

A: As per guideline i have to solve only three subpart of your question

Q: Exercise We consider an ideal Diesel cycle whose compressio Xmax osion ratio The heat transfer to…

A: The compression ratio of diesel cycle is The heat addition to the cycle is The initial temperature…

Question

2. A diesel engine was tested for a continuous 3 hours of operation. It consumed at total
of 5 liters and developed a constant power of 7.5 kW. If the fuel contains 45.46
MJ/kg, what is the approximate thermal efficiency?
a. 40%
b. 35%
c. 33%
d. 25%
e. none of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Expression of efficiency.

VIEW

Step 2 Calculation of thermal efficiency.

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

thermodynamics
At the beginning of the compression process of an air standard Otto cycle, p1 = 1 bar, T1 = 300 K. The maximum temperature in the cycle is 2250 K and the compression ratio is 9.8. The engine has 4 cylinders and an engine displacement of Vd = 2.4 L. Determine per cylinder: a) the volume at state 1.b) the air mass per cycle.c) the heat addition per cycle, in kJ.d) the heat rejection per cycle, in kJ.e) the net work per cycle, in kJ.f) the thermal efficiency.g) the mean effective pressure, in bar.h) Develop a full exergy accounting per cycle, in kJ. Let T0 = 300 K, p0 = 1 bar.i) Devise and evaluate the exergetic efficiency for the cycle.
The part load efficiency curve for a microturbine running on natural gas is given below: Calculate the consumption of natural gas in m3/s when this microturbine is producing 10, 20, 30, 40, 50 and 60kW. Explain how you calculated your results and present your results in a table; then plot these fuel consumption values as a function of output power. Include your table of results and the plot in your assignment report. What are the key features of this plot of fuel consumption versus output power? [Assume that the energy content of natural gas is 38.7 MJ/m3]
(b) The pressure, volume and temperature at the beginning of compression of a four stroke petrol engine are 105kN/m²,0.0005m³ and 25°C respectively. The maximum temperature of the cycle is 1400°C. The volume ratio of the engine is 8:1. i) Calculate the mean effective pressure in the cylinder.
Important question,solve carefully.
Provide a complete and logical solution for the problem. If linear interpolation is required in the problem, tabulated values is considered as a solution. Also, provide T-S or P-V diagrams for each problem. In an ideal Diesel engine compression is from 14.7 psia, 80°F, 1.43 ft3 to 500 psia. Then 16 BTU/cycle are added as heat. Make computations for k = 1.42. Find: a. Heat Rejected b. Net Work c. Efficiency d. Hp for 300 cycles/min
The compression ratio of an Otto cycle is 8, at the beginning of the zanthropic compression process, the pressure of the air is 100 kPa, the temperature is 27 "C, the volume is 550 cm. At the end of the lzantropic expansion process, the temperature of the air is 700 K. Using the specific temperature values at room temperature (according to the cold air standard assumptions) Find the gravity of the air.
Draw the pV diagram for the Stirling engine with proper labels?
The output of a compressor plant delivering 600 m3 of free air/hr at 7 bar gauge at 20 oC passes through arefrigeration type dehumidifier where it is cooled to 1 oC. How much water should be collected from thedehumidifier per hour ?Please choice one below:a. 5.124 kg/hrb. 0.909 kg/hrc. 0.408 kg/hrd. 3.275 kg/hre. 1.317 kg/hr
Plsss show solution with PV and TS diagram. Thanksss!
S8
Consider a diesel electric plant which consumes a thousand liters of fuel with 20 degree API at 200K in a day. Calculate the fuel rate in kg/min.