The output of a compressor plant delivering 600 m3 of free air/hr at 7 bar gauge at 20 oC passes through arefrigeration type dehumidifier where it is cooled to 1 oC. How much water should be collected from thedehumidifier per hour ? Please choice one below: a. 5.124 kg/hr b. 0.909 kg/hr c. 0.408 kg/hr d. 3.275 kg/hr e. 1.317 kg/hr

Q: At the beginning of the compression process of an air standard Otto cycle, p1 = 1 bar, T1 = 300 K.…

A:

Q: In charging a car air conditioner, 2.4% of a 15-pound cylinder of refrigerantR-134a is used. How…

A: Let M and N are two numbers. Let M is a part of the whole number N, Percentage =MN Now we convert…

Q: 1. If the Pressure Entering the Condenser is 15 KPa. What is The Temperature at the oxit of the…

A:

Q: Question 2 A refrigeration cycle operates with R-134a. Saturated liquid QH 4 li Saturated vapor…

A: INTRODUCTION: Refrigeration is the process of maintaining low temperatures as compared to the…

Q: During a steam generator performance test, the following data were recorded: Fuel Data: Coal mass…

A: For the coal mass flow rate = 2.5 kg/s; HVC = 32.5 MJ/kg For the steam, Pressure = 13 bar; quality =…

Q: An air compressor in Albuquerque with an 8-gallon tank is initially at atmospheric pressure (12.2…

A:

Q: A room is maintained at design conditions of 75oF dry bulb and 50% RH. The air outside is at 95oF…

A: The temperature of room initially is Ti=75°F The relative humidity of room is 50%. The wet bulb…

Q: Q.1. A refrigeration process with interstage cooling uses refrigerant HFC-134a, and the outlet of…

A:

Q: Refrigerant 22: T= 20°C v = 0.0008263 m°/kg On the Triple Line O Saturated Vapor Saturated Liquid O…

A: Given The temperature of the refrigerant is T=20°C. The specific volume of the refrigerant is…

Q: Diesel Cycle 1-2: Isentropic compression 2-3: Constant pressure heat addition 34:Isentropic…

A:

Q: ddition per cycle, in kJ. d)    the heat rejection per c

A:

Q: State the cold air standard assumptions.

A:

Q: At the beginning of the compression process of an air standard Otto cycle, p1 = 1 bar, T1 = 300 K.…

A:

Q: Air at a dry bulb temperature of 80 ° C and RH 8% is passed over the cooling coil so that the air…

A: T1=Air at a Dry Bulb Temperature=80°CR.H=Relative Humidity= 8 % T2=Air dry boal temperature…

Q: The LiBr-water absorption cycle shown in Fig. 17-2 operates at the following temperatures:…

A: Find the concentration of Li-Br in the generator Tg=100°C Tc=55°C Te=10°C Ta=30°C

Q: Question 2 2.1 A single stage double acting air compressor of 150KW power takes air in at 16 bar &…

A:

Q: Define the waste heat from a compressor can be used to heat a building in winter.

A: Compressor heat is very critical in the hot days of summer.  If the heat arising due to…

Q: A saturated liquid-vapor mixture of water, called wet steam, in a steam line at 1500 kPa is…

A: Given        Pressure, P1 = 1500 kPa                         P2 = 50 kPa Temperature, T2 = 100oCFind…

Heat Exchangers

Heat exchangers are the types of equipment that are primarily employed to transfer the thermal energy from one fluid to another, provided that one of the fluids should be at a higher thermal energy content than the other fluid.

Heat Exchanger

The heat exchanger is a combination of two words ''Heat'' and ''Exchanger''. It is a mechanical device that is used to exchange heat energy between two fluids.