The fan/blower installed in the central air conditioning system is of the axial flow type. This function is to help air circulation in the cooling process in the cooling tower. Atmospheric air enters a fan/blower and its pressure increases, so that the air total pressure leaving the blower is 110.29 kPa. Calculate: a) Blower total pressure? b) Speed of the air leaving the blower?

Q: 6. What is the stagnation (or total) temperature of 300 K air flowing at a.) 100 m/s and b.) 1000…

A:

Q: A) Fnd the flow rate in m. B) the maximum height h, to which The Water Can flow if thz Velocity at…

A:

Q: (b) Water flows from a pressurized tank through a pipe and rises to the surrounding as shown in…

A: Given, Assumptions: Steady flow Incompressible Frictionless (2) and (3) are exposed to…

Q: B) A hydraulic system contains a pump that discharges oil at 13.8 MPa and 0.00632 m/ s³ to a…

A:

Q: In a gas turbine, the gases flow at a rate of 5 Kg/s. The gases enter the turbine at a pressure of 7…

A: The work done and the capacity of the turbine.Given:The mass flow rate is .The inlet velocity is…

Q: Q2: For air standard diesel cycle the following data is available: compression ratio Heat added / kg…

A: Dear student as per the policy i have solved first three subparts for you , request you to post…

Q: S As an alternative to the process described in Problem 2.5, the exhaust will be treated in a…

A: Solution   The Flow sheet for 2.6

Q: A). What is the exit temperature of the CO2 gas in the following diffuser? B).  What is the…

A:

Q: 10 m3 of free air is compressed to 8 bar gauge, every minute. What will be the air volumetric…

A: Given data: The volume air compressed in one minute is 10 m3. The final gauge pressure of the air…

Q: 1.) A hand pump is used to inflate a bicycle tire to a gauge pressure of 70 psi. a) How much work…

A:

Q: Work Number 2 and 3

A: Step 1: Problem 2:Given:P=2 bars=6.2 kJ/kg.KObjective: Determine the state or zone.Solution:Find the…

Q: Air enters a compressor operating at steady state with a pressure of 100 kPa and a temperature of…

A: Given Data ;P1=100 KPaT1=27°C=300 KA1V°1=30 m3min=0.5 m3SP2=700 KPaT2=227°C=500 K

Q: A water system of 2 inches (inside diameter) pipe, having a length of 1/4mile, is to be flushed with…

A: Given data: Inside diameter of the pipe, d = 2 in. Length of the pipe, L = 1/4 mi. Calculate the…

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.