A cylinder with a piston contains 0.338 mol of ideal gas at 5.10 x 10° Pa and 349 K. Consider these paths: (1) The gas expands isobarically to 3.6 of its original volume. (2) It is then compressed isothemally back to its original volume. (3) It is cooled isochorically to its original pressure in the end. a. Show the series of processes on a pV-diagram. b. Compute the temperature during the isothermal compression; c. Compute the maximum pressure; Compue the totel wosl- dena br the

A cylinder with a piston contains 0.338 mol of ideal gas at 5.10 x 10° Pa and 349 K. Consider these paths: (1) The gas expands isobarically to 3.6 of its original volume. (2) It is then compressed isothemally back to its original volume. (3) It is cooled isochorically to its original pressure in the end. a. Show the series of processes on a pV-diagram. b. Compute the temperature during the isothermal compression; c. Compute the maximum pressure; Compue the totel wosl- dena br the

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The thermodynamic cycle of a heat engine using ideal helium gas is shown in the P-V diagram. The ratio of heat capacities y (also called ratio of specific heats) is the ratio of the heat capacity at constant pressure Cp to the heat capacity at constant volume Cy. For ideal helium gas, y = 1.67. Select the stage that is paired correctly with the process it represents in the P-V diagram. 1-2: adiabatic process O2-3: isochoric process 3-4: isothermal process 4-1: isobaric process p (kPa) 0.8 0.6- 0.4- 0.2 0.0 2 0.2 0.4 0.6 1 0.8 V(m³) 1.0
A monatomic ideal gas is initially in state A. The gas undergoes a transition from state A by the three different processes shown, where process III is isothermal. In which process is energy added to the gas by heating? Explain briefly.
1.50 mol of an ideal gas with a constant ratio of heat capacities at constant pressure and volume y =2 = 1.40 is taken through the (reversible) cycle shown in the figure below. The process A - B is an expansion at constant temperature, whereas B →C and C → A are constant-pressure compression and constant-volume processes, respectively. 040 a) What is the temperature TA of the gas at A? P (atm) For the cycle as a whole, Isothermal b) calculate the (net) work done W (by the gas), 04021 c) calculate the (total) heat transfer Q, process d) find the change in the (internal) energy U of the gas, B e) verify that the 1" law of thermodynamics C is satisfied. 1 liter=1.00x10 m , 1 atm=1.01x105 N/m² , kɛ = 1.38x1023 J/K , NA=6.02x1023 mol. -V (liters) 50 10
Consider a process that uses n moles of a monatomic ideal gas operating through a Carnot cycle. The initial temperature and pressure of the gas are T1 and P1, respectively. Consider steps 1 → 2, 2 → 3, 3 → 4, and 4 → 1. a. In the adiabatic heating, the temperature of the gas is doubled. Write an expression for the volume V3 after this step in terms of V1. b. Write an expression for the volume V4 in terms of V1.
A sample of monatomic ideal gas occupies 5.00 L at atmospheric pressure and 300 K (point B in the figure). It is heated at constant volume to 3.00 atm (point B). Then it is allowed to expand isothermally to 1.00 atm (point C) and at last compressed isobarically to its original state. a.) Find Q, W and ∆U for each of the processes. b.) For the whole cycle find Q, W and ∆U. For monatomic gases, use Cv=3/2 R.
A monatomic gas is take through a cycle from A to B to C and back to A. At A the pressure is 100,000 pa, the volume is 4.0 liters, and the temperature is 300K. The gas is compressed adiabatically until the volume is 1.0 liters (at B). How much energy was given to or removed from the gas during the adiabatic process?
B2
An experimenter adds 990 J of heat to 1.75 mol of an ideal gas to heat it from 10.0°C to 26.1 °C at constant pressure. The gas does 234 J of work during the expansion. Part A Calculate the change in internal energy of the gas. Express your answer in joules. You may want to review (Page). For related problemsolving tips and strategies, you may want to view a Video Tutor Solution of Cooling ? your room. AU = J %3D Submit Request Answer Part B Calculate y for the gas. Enter your answer numerically. ΑΣφ = Submit Request Answer
See photo attached. What is the change in internal energy of the gas from A to B?
I need solutions question B
Consider a refrigerator undergoing a cycle. a. What is the maximum coefficient of performance that an ideal refrigerator can achieve if it operates between thermal reservoirs at 150K and 220K? b. Is it possible for a refrigerator operating between the same two temperatures of part (a) to have heat transfer in to the cycle of 34 kJ and heat transfer out of 42 kJ? Why or why not?
One cubic meter of oxygen at initial pressure of 1 bar and a temperature of 17°C are compressed isentropically to a volume of 0.50m 3. Use the specific heat at constant volume and pressure are 0.919 kJ/kgk and 0.659 kJ/kgK, respectively. determine the: a. The thermodynamic process the problem represents b. the pressure, temperature, and volume after the process c. change in internal energy, change in enthalpy and change in entropy d. work nonflow and heat transferred