A cylinder is made of steel plate is intended to be used as a container for compressed air. The dimensions of the cylinder are L-2m, D=60cm, and t = 0.005m. If the ultimate tensile stress of the steel is 400 N/mm², Young's modulus is 200000 MPa and Poisson's ratio is 0.25. 1- Determine the maximum air pressure that can be stored in the cylinder (use factor of safety = 2) 2- Determine the change in the volume of the cylinder due to storing maximum pressure.

A cylinder is made of steel plate is intended to be used as a container for compressed air. The dimensions of the cylinder are L-2m, D=60cm, and t = 0.005m. If the ultimate tensile stress of the steel is 400 N/mm², Young's modulus is 200000 MPa and Poisson's ratio is 0.25. 1- Determine the maximum air pressure that can be stored in the cylinder (use factor of safety = 2) 2- Determine the change in the volume of the cylinder due to storing maximum pressure.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

As an engineer you are asked to choose 1 component from what you studied ( Screw, rolling bearing, Sliding Bearing, key, or shaft). 1. Explain what you know about that component and its types? 2. Make a sketch of the component with the important dimensions required? 3. Explain in detail what information you need to know to design this component?
Q/ Define the stiffness? Discuss the criteria for selection of materials for stiffness
Show the typical Stress versus Strain curve for the following materials, and define the materials properties "The stress-strain curve can be used to read off the structural load ability of materials. For many materials, including metals, their loading bearing capability is one of the most important material properties". by reference to the diagram: a) Hammer head is made from hardened tool steel b) Smelter is made from refractory ceramic c) Cable is made from pure copper d) Box is made from polypropylene
D) Discuss the main parameters Effect the Fatigue life.
16. There are 4 materials that were exposed to different forces and their corresponding elongation is given. Which will have the greatest and lowest value of k. Material A was exposed to 100 N force and elongation is 0.02 meters. B was exposed to 200 N force and elongation is 0.05 meters. C was exposed to a force of 300 N and elongation is 0.07 meter, D was exposed to 400N force and elongation is 0.09 meter.
Please answer in the column by using the answer provided.
The requirement in the specification for the design of components and materials are no need to meet requirements. Select one: True O False
DIRECTION: Identify the following term. 3. It is the study of the relationship between the external loads applied to a body and the stress and strain caused by the internal loads within the body.
solve please
Compare each strength gain and relate its significance on Strength and Economy. The design strengths are: a.) 290.7 kNm (using 4-25mm dia. Tension bars) b.) 378.7 kNm (using 6-25mm dia. Tension bars) c.) 385.97 kNm (using 9-25mm dia. Tension bars)
Answer is Around 5.8lb [diagram must be drawn] An automobile weighing 3900 lbs has 29-inch diameter wheels. Assuming the coefficient of rolling resistance between the tires and the road of 0.02 inch, determine the force necessary to overcome rolling friction on a level road. Answer should be in lbs
Question 02: Discuss the type of stresses that occur when two gears mate with each other, write the equations for these stresses and define each term in the equations. How will you compare which stress is more threatening to the failure of gears?