A crazed (and out of control) snowmobiler is sliding down a mountain side. The components of position for the snowmobile are as follows: x(t) = 0.25 t y(t) = 0.75 t z(t) = -0.15 t³ a) Find the expression for the velocity vector of the snowmobile. b) What is the magnitude of velocity at t = 3s? c) What are the directional cosines for velocity at t = 3s?

A crazed (and out of control) snowmobiler is sliding down a mountain side. The components of position for the snowmobile are as follows: x(t) = 0.25 t y(t) = 0.75 t z(t) = -0.15 t³ a) Find the expression for the velocity vector of the snowmobile. b) What is the magnitude of velocity at t = 3s? c) What are the directional cosines for velocity at t = 3s?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Dynamics
Please ASAP: (image provided) a) Create a function to solve a projectile problem where you are given initial x and y velocity, and the initial and final y position (inputs). You would like to use this function to find the final x and y velocity (outputs). This function will be used in the solution of the following problem. b) In the figure below, belt A moves with a constant velocity of 5 ft/s, and discharges sand onto belt B as shown. Assume that the angle of belt B is 15 degrees as shown. Write a MATLAB program to determine the required velocity of belt B if the relative velocity with which the sand hits belt B is (a) vertical, and (b) as small as possible. For part (b), use MATLAB to create a plot of the velocity of the sand relative to belt B, as a function of the velocity of belt B. Verify (either by hand, or by using MATLAB) that the minimum shown in this plot corresponds to the point at which the velocity of the sand relative to belt B is perpendicular to the velocity of…
Need it fast plzz
A car moves along a straight line. The car starts to move from Thi- Qar toward Baghdad with a constant velocity of 120 km/hr, compute the following: 1- If you know the car needs 3 hrs to reach out to Baghdad, What is the total displacement between Thi-Qar and Baghdad? 2- what is the value of the constant acceleration?
a) Find the rope equation for the figure below b) If the speed of point B on the rope is a constant 5 m/s to the right, determine the speed and direction of motion of block D (direction) c) What is the relative velocity of D with respect to B (magnitude and direction) 5m/s D
[Q 4] (a) The equation of a hill path is given by: Y = -0.001 x? + 0.2 x A small vehicle of mass 80 Kg starts from rest at the bottom of hill (point (0,0)) and accelerated toward the top of hill. Find maximum allowable acceleration to keep the vehicle in contact with the surface when reaching top of hill.
P:0. O ZAVO a ll Asiacell HW3.pdf > HW3. Due date: Mid night of 4 March 2021 Q1) The concrete pier P is being lowered by the pulley and cable arrangement shown. If points A and B have velocities of 0.4 m/s and 0.2 m/s, respectively, compute the velocity of P, the velocity of point C for the instant represented, and the angular velocity of the pulley. 100 mm 200 mm Q2) The slotted arm pivots about O and maintains the relation between the motions of sliders A and B and their control rods. Each small pivoted block is pinned to its respective slider and is constrained to slide in its rotating slot. Show that the displacement x is proportional to the reciprocal of y. Then estab- lish the relation between the velocities va and eg. Also, if v, is constant for a short interval of motion, determine the acceleration of B. Q3) 16-45. Determine the velocity of rod R for any angle 6 of the cam C if the cam rotates with a constant angular velocity a. The pin connection at O does not cause an…
I need the answer as soon as possible
" | 13% & 9:1A HW3.pdf > HW3. Due date: Mid night of 4 March 2021 a1) The concrete pier P is being lowered by the pulley and cable arrangement shown. If points A and B have velocities of 0.4 m/s and 0.2 m/s, respectively, compute the velocity of P, the velocity of point C for the instant represented, and the angular velocity of the pulley. 200 Q2) The slotted arm pivots about O and maintains the relation between the motions of sliders A and B and their control rods. Each small pivoted block is pinned to its respective alider and is constrained to slide in its rotating slot. Show that the displacement * is proportional to the reciprocal of y. Then estab- lish the relation between the velocities va and v Also, if v, is constant for a short interval of motion, determine the acceleration of B. Q3) 16-45. Determine the velocity of rod R for any angle 8 of the cam C if the cam rotates with a constant angular velocity s. The pin connection at O does not cause an interference with the motion…
+51 suspension You are an engineer designing the suspension of an ATV. You want to ensure that the vehicle doesn't "bottom out" even when landing from being airborne. An approximation describing the vertical acceleration of the suspension upon impact is I a(s) 9.8(1 12s) m/s² where the initial velocity at impact is v=1.5 m/s with the spring initially uncompressed, s = 0 m A) What is the vertical velocity of the ATV chassis after the spring is compressed 0.1 m? B) What is the maximum distance the spring gets compressed? (This occurs when the ATV's vertical motion comes momentarily to rest)
A particle moves along the x axis from x; to xf. Of the following values of the initial and final coordinates, which results in a negative displacement? x = -4m, xf = 2m x₂ = -4m, f =-2 m ○ x₁ = 4m, f = 6 m x₂ = 8 m, f = 4 m x = -4m, f none of these = 4 m
Pages Le EXtract Object View Edit OCR Sign Comment Page Organization Convert Protect Start ASSIGNMENT FINAL 20... Q7) A horizontal table rotates freely in a horizontal plane about a frictionless vertical axle. The table has a moment of ineria 200 kg.m² and a radius R = 2.0 m. A student whose mass is m = rim of the disk toward its center. If the angular speed of the system is 2.0 rad/s when the student is at the rim, what is the angular speed when he reaches a point r = 60 kg walks slowly from the M 0.50 m from the center? 11 1 7/7 We HA 144a. Hem t A A L