A condenser is used to convert a gas into a liquid. The energy equation for a condenser is: Qcv = m(h₂ h₁) where 1 and 2 represent the state at the inlet and exit to the condenser (control volume). In addition to the steady state and steady flow assumptions, it has been assumed that: A) the change in kinetic energy is negligible OB) the change in potential energy is negligible OC) the net power input to the condenser is zero OD) all of the above, i.e. A), B) and C)

A condenser is used to convert a gas into a liquid. The energy equation for a condenser is: Qcv = m(h₂ h₁) where 1 and 2 represent the state at the inlet and exit to the condenser (control volume). In addition to the steady state and steady flow assumptions, it has been assumed that: A) the change in kinetic energy is negligible OB) the change in potential energy is negligible OC) the net power input to the condenser is zero OD) all of the above, i.e. A), B) and C)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

5. "Wet steam" at 200 kPa has 40% of its mass as liquid. The water is contained in a spring-loaded piston-cylinder, with an initial volume of 3 m'. The steam is now heated until its volume is 4.535 m and its pressure is 500 kPa. Determine: a) The final temperature b) c) The work done by the steam The total heat transferred Spring d) Show the process on a P-v diagram Steam
A) Steam enters a turbine at a pressure of 30 bars, temperature of 400 degrees Celsius and exits at a pressure of 1bar. The turbine is isentropic, how much power is produced per unit mass flow rate, w. Their is no change in kinetic or potential energy and no heat transfer. Answer in kJ/kg B) Steam enters a turbine at a pressure of 30 bars, temperature of 400 degrees celsius and exits at a pressure of 1bar. If the turbine is operating at 95% isentropic efficiency, how much power is being produced per unit mass flow rate, w. Their is no change in kinetic or potential energy and no heat transfer. Answer in kJ/kg C) Steam enters a turbine at a pressure of 30 bars, temperature of 400 degrees celsius and exits at a pressure of 1 bar. If the turbine at 95% isentropic efficiency, what is the quality of the steam exiting the turbine? Their is no change in kinetic or potential energy and no heat transfer.
1. In general, the internal energy U depends on both temperature and volume, U=U(TV). The volume dependence comes from the potential energy due to the interactions among the particles. For free particles, there are no interactions, thus, the internal energy U should be independent of the volume, i.e., = 0. Verify this result for ideal gas pV = RT. au av
within a piston-cylinder assembly undergoes a thermodynamic cycle consisting of A gas three processes: Process 1-2: Constant volume, V = 0.06 m², U2 - U, = 40.4 kJ Process 2-3: Expansion with PV = constant, U3 - U2= 0 Process 3-1: Constant pressure, P =3 bar, W31 = (-20) kJ There are no significant changes in kinetic or potential energy. %3D Identify the process on a sketch of p-V diagram plotted for the cycle. Formulate the expression for heat transfer for process 2-3 and process 3-1. (Hint: Apply first law of thermodynamics for closed systems) (a) (b) (c) Solve to find the net-work for the cycle and heat transfer for the process 2-3 and Heat transfer for process 3-1, in kJ Identify if the above system executes a power cycle or a refrigeration cycle. Give (d) reason.
One mole of an ideal gas is heated slowly so that it goes from the PV state (P, V;) to (2P;, 2V;) in such a way that the pressure is directly proportional to the volume. (a) How much work is done on the gas in the process? (Use any variable or symbol stated above along with the following as necessary: n and R.) W = (b) How is the temperature of the gas related to its volume during this process? (Do not substitute numerical values; use variables only. Use the following as necessary: n, R, V, Vi, and P.) T = Need Help? Read It
Water undergoes two processes in series: • 1 to 2: isentropic (internally reversible and adiabatic) compression from 0.1 MPa and the phase of water is “saturated vapor” to 0.5 MPa• 2 to 3: a reversible isothermal process to 1.5 MPaa) Draw the overall process on a T-s diagram. Clearly indicate all states and the values of the relevant intensive properties on your diagram. b) Is process 2 to 3 a compression, expansion, or isochoric process? How do you know? c) Determine the overall specific work (w13) and specific heat transfer (q13) for this complete process. (Hint: recall that Q int rev =∫ T ds21 for an internally reversible process between states 1 and 2.)
a) A refrigeration cycle is chosen to maintain a freezer compartment at 10.0°F in a room that is at 90.0°F. If 200. Btu/min are extracted from the freezer compartment by heat transfer and the freezer is driven by a 1.00 hp electric motor, determine the dimensionless coefficient of performance (COP)of the unit, defined as the cooling rate divided by the input power. b) Determine the energy transport rate for the system shown in Figure below. Fuel flow Top heat loss Exhaust flow Epuet=15,000 Btu/min 180,000 Btu/h Ecshaut =500. Btu/min System boundary Engine-generator set 200. hp Bottom heat loss 54,000 Btu/h 50.0 hp Electrical workout
b) A tank shown in Figure-2 below is used to mix methanol and salt. The tank initially contains 1 m³ of methanol. Salt is provided into the tank with a volumetric flow rate of Fsalt= 0.2 m³ s¹. A stream with perfectly mixed methanol and salt leaves the tank with a volumetric flow rate of F = 0.1 m³ s1. As the flow is unsteady, the volume of mixture in the tank, V(t), is a function of time. Fsalt=0.2 m³/s Psalt=2160 kg/m³ V(t) F=0.1 m³/s Figure-2: A mixing tank of methanol and salt. d(V (t)Psalt) dt Salt+methanol The mass balance of salt in the tank is given by, d(V (t) (Psalt +Pmethanol)) dt = Fsalt Psalt - FPsalt where Psalt is the density of salt and equal to 2160 kgm ³. The total mass in the tank is given by, = Fsalt Psalt - FPsalt - FPmethanol where Pmethanol is the density of methanol and equal to 800 kgm-³. When the tank contains V = 0.5m³ of mixture, what is the mass of salt in the tank? Use the explicit Euler finite difference method to discretise the balance equations. (Hint:…
For each situation below, briefly explain how you obtained the values and provide the numerical answer. A) What is the internal energy of saturated water vapor at 305 degree Celsius? B) What is the pressure of a system of saturated liquid water with a specific volume of 0.001488 m^3/kg? C) What is the enthalpy of a saturated mixture of water at 423 k with quality of 43%? D)When 1 kg saturated water vapor is condensed to a saturated liquid water at 325 Kpa, what is the change in its volume? E) What is the specific internal energy of liquid water at 280 degree Celsius and 7500 Kpa?
Some unknown gas undergoes a polytropic process, pV^1.5 = constant, the initial pressure, p1, is 1 bar, and the initialvolume, V1, is 1 m3. We also know the final volume, V2, is 4 m3. Please determine 1) the final pressure of the gas, p2, inbar; and the total work done by the gas, W, in kJ; 2) judge the direction of energy flow for the work: into the system or outof the system.
Based on the first law of thermodynamics, which of the following is wrong? A the heat transfer equal the work plus energy change B the net heat transfer equals the net work of the cycle c) the heat transfer cannot exceed the work done D the net heat transfer equals the energy change if no work is done
The steam turbine shown below has a single inlet and two exit streams. It is assumed that the turbine is well insulated and the change in potential energy is negligible. The energy equation governing the turbine based on these assumptions is: OA) B) OD) inlet Turbine J QT - WT=0 C.V. Qr − W₁=m₂ (h + F7)2 +m3 (h+VZ)3-m₂ (h+ QT - Wr=m₂h₂+ m3h3- M₁h₁ w C.V. W₁=m₂ (h+)₁-m₂ (h+)₂ - m₂ (h+)₂