Steam flows through an adiabatic turbine, entering at 1000 psia, 1100°F, and 300 ft/sec and exiting at 10 psia, 300°F, and 600 ft/sec. If the power output of the turbine is 8000 hp Determine: a) The change in kinetic energy in Btu/lbm b) The mass flow of steam through the turbine c) The areas at the inlet and outlet of the turbine d) Diagram of T vs s of the processes

Q: . Find the volume of a bronze bushing if it's inside diameter is 1 inch, outside diameter is 1.50…

A:

Q: For the truss in figure below, the cross-sectional area of the truss members is A = 500 mm² and…

A: Consider a virtual load Q, acting vertically downwards, is applied at point A.Draw the given truss…

Q: Add the vectors using triangle rule or parallelogram rule

A: Draw the diagram of the vector system.

Q: Forces and moments are scalar Forces are moments are vector quantities.

A: Forces and moments are both physical quantities that can be used to describe the behavior of objects…

Q: What is the maximum magnitude of the bending moment caused by force G? If none, enter zero. Do not…

A: It is required to determine the magnitude of the maximum bending moment by the force G.

Q: - х a = 6 in b = 0.7 in C = 2 in

A:

Q: The landing gear system of a plane is made of an actuator AC and 2 rods CB and OAB. They are pin…

A:

Q: both answers are wrong :(

A: Given DataT1=310KP1=320kPaM1=0.3 To findV2=?P2=?

Q: Describe the Parallel-Axis Theorem for an Area?

A:

Q: can the solve the last three quetsions please

A: mass of refrigerant R-22, m= 2kgThe initial pressure, P1= 6.8 barThe initial state is saturated…