A circular water pipe of 300 mm diameter branches into a 200 mm-diameter pipe as shown in the figure below. At the upstream location A, the volume flow rate is measured as 400 L/s, and pressure as 400 kPa. At the downstream location C of the 300 mm-diameter pipe, the pressure is measured as 410 kPa. The branched pipe is located 1 m above the main 300 mm-diameter pipe. Evaluate the mass flow rate and static pressure of water at location B.

Q: The ethanol solution is pumped into a vessel 25 m above the reference point through a 25 mm diameter…

A: As per Bartleby Policy, in case of multiple subparts, only the first three subparts can be solved,…

Q: Q6) The flow-metering device shown consists of a stagnation probe at station 2 and a static pressure…

A:

Q: For the following system, calculate the flow rate from the nozzle. Give the result Q in m3/s

A:

Q: Water is being pumped the through one inch diameter piping arrangement to a higher elevation (5…

A: Density Explanation:Step 1:Step 2:Step 3: Step 4:

Q: 5. The large tank shown in the figure is filled with water to a height of ho. Water exits the 5-cm-…

A: Step 1: Step 2: Step 3: Step 4:

Q: Sketch a section of a pipe with diameter D₁ with a Venturi meter of throat diameter D2. Indicate on…

A: let pipe diameter=D1throat diameter=D2water column level at pipe =h1water column level at throat=h2

Q: 3m/s 100 mm 非 100 mm

A: To find the x and y component of the force in the cross section of the pipegiven diameter at the…

Q: A hose pipe of 75 mm bore and length 450 m is supplied with water at 1.4 MPa. A nozzle at the outlet…

A:

Q: Problem 3: Control Volumes When a water jet strikes a stationary inclined plate, it breaks into two…

A: if you have any doubts please comment

Q: Water steam is running through the nozzle. Inlet pressure is P1=25 bars; T1=300C; V1=90m/s;…

A: a) Exit velocity 577.148 m/sb) Inlet diameter 0.5046 m    Outlet diameter 0.029 mExplanation:

Q: Water is being pumped the through one inch diameter piping arrangement to a higher elevation (5…

A: Detailed step by step solution is given below, still if you have any query please feel free to…

Q: 4. The system in Fig. consists of 1200 m (length) of 0.05 m (diameter) cast iron pipe, two 45°…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.