A circular loop of mass m and radius r is kept in a horizontal position (X-Y plane) on a table as shown in figure. A uniform magnetic field B is applied parallel to x- axis. The current I in the loop, so that its one point iust lifts from the table, is:

A circular loop of mass m and radius r is kept in a horizontal position (X-Y plane) on a table as shown in figure. A uniform magnetic field B is applied parallel to x- axis. The current I in the loop, so that its one point iust lifts from the table, is:

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A battery is connected to wires that hand vertically (gravity acts down in the diagram). Hooks at the ends of the wires hold a horizontal copper bar (the thick bar) of mass 0.6 kg and length 0.5 meters. Another apparatus (not shown) can create a uniform magnetic field in the region of space given by the dashed rectangle. The total resistance of the circuit is 1.20 Ohms and the battery supplies 24 Volts. The magnetic field can be adjusted in strength until the bar lifts off of the hooks and levitates magnetically – not moving just above the hooks as shown. a) Determine the necessary direction of the magnetic field in the dashed rectangle. b) Calculate the required magnitude of the magnetic field.
A long, straight wire carries a current of 69 A. The magnetic field produced by this current at a certain point is 9.0 x 10-5 T. How far is the point from the wire?
A uniform magnetic field is perpendicular to the plane of a circular loop of diameter 9.8 cm formed from wire of diameter 2.7 mm and resistivity of 2.41 × 10-8Ω·m. At what rate must the magnitude of the magnetic field change to induce a 11 A current in the loop?
A very long, straight wire carries a current of 0.29 A. This wire is tangent to a single-turn, circular wire loop that also carries a current. The directions of the currents are such that the net magnetic field at the center of the loop is zero. Both wires are insulated and have diameters that can be neglected. How much current is there in the loop?
2.0 cm A wire Is bent into the shape shovn in the figure and placed in a uniform magnetic fleld B, directed into the page. The left and right vertical parts are parallel to each other and separated by 2.0 cm. When a current of 10 A passes through the wire, a force of 0.10 N acts on the wire. What is the strength of the uniform magnetic field? 0.50 gauss О 1.00 tesla 0.25 tesla Not enough Information is provided 1.50 gauss 1.50 tesla 0.50 tesla O 0.25 gauss O 1.00 gauss
Two coaxial, parallel, circular conductors of radius R are carrying the current I. At what distance a from each other must the conductors be placed so that in series connection the magnetic field in between them becomes as uniform as possible?
A Current of 11 A flows in a coil Has 36 turns and is 25 cm long on each side. The magnetic field is uniform and has a strength of .75 T. If the coil is angled at 37 degrees, what is the torque on the coil, assuming it can pivot on an appropriate axis?
A loop of wire has the shape shown in the drawing. The top part of the wire is bent into a semicircle of radius r = 0.28 m. The normal to the plane of the loop is parallel to a constant magnetic field (p = 0°) of magnitude 0.82 T. What is the change AO in the magnetic flux that passes through the loop when, starting with the position shown in the drawing, the semicircle is rotated through half a revolution? B (into paper) ΔΦ = i
Point a is on the +y-axis at y = +0.200 m and pointb is on the +x-axis at x = +0.200 m. A wire in the shape of a circulararc of radius 0.200 m and centered on the origin goes from a to b andcarries current I = 5.00 A in the direction from a to b. (a) If the wireis in a uniform magnetic field B = 0.800 T in the +z-direction, whatare the magnitude and direction of the net force that the magnetic fieldexerts on the wire segment? (b) What are the magnitude and direction ofthe net force on the wire if the field is B = 0.800 T in the +x-direction?
A loop of wire has the shape shown in the drawing. The top part of the wire is bent into a semicircle of radius r = 0.30 m. The normal to the plane of the loop is parallel to a constant magnetic field (p = 0°) of magnitude 0.79 T. What is the change AO in the magnetic flux that passes through the loop when, starting with the position shown in the drawing, the semicircle is rotated through half a revolution? B (into paper) ΔΦ = > i * х
A solenoid is used to produce a magnetic field of T at its center. Its radius is R cm, and its length is L. In order to prevent excessive heating, the maximum current that can carry is A. What is the minimum value of its turn density that will allow it to carry the maximum current safely? What length of wire is required? Assume there are no spaces between each turn.
A positive charge moving with a constant velocity v enters a region of a uniform magnetic field pointing upward. What is the direction of the magnetic force on the charge?