A channel having a cross-section shown below has a flow rate of 0.049 m^3/s. Compute the hydraulic radius if f=0.020 Answer in THREE(3) decimal places. 1m 2 m 2 m 1m 2m 4 m 3 m

Q: A hydraulic jump is shown in figure below. The depth of flow z₂ after the hydraulic jump is 5 m…

A: Depth, Z1 = 6 mDepth after the hydraulic jump, Z = 5 mLength, l = 0.4 mFlow rate, Q = 450…

Q: For the dam indicated in the figure below, the flow network was drawn according to Casagrande…

A: Step 1: Determine the parameters based on the student's RAFor RA where:- X = 6- Y = 1- Z = 0…

Q: Calculate the hydraulic head, h along with the pore-water pressure, u at points 2, 4 and 6, after…

A:

Q: A concrete pipe of 6 m long is used to block flood water from the left to contaminate a pond of oil…

A: Objective: To determine the magnitude and direction of the resultant force on the concrete pipe.…

Q: For the one-dimensional flow system shown below (units in centimeters):a. What is the value of H…

A: Note: The height H is nothing but the upward seepage pressure developed by the water on the soil…

Q: A well is installed in a unconfined aquifer. Determine the drawdown (ft) at the well if: the radius…

A: Drawdown: The drop in the level of the water table at a point from its previous or original state of…

Q: Water flows at a rate of 0.1 m³/s through the horizontal pipe transition as shown below. Pressures…

A: Q = 0.1 m3/s D1 = 0.1 m D2 = 0.2 m P1 = 19620 PaP2 = 49050 Pa

Q: The rectangular channel is 2 m wide, and the depth of the water is y₁ = 1.6 m as it flows with an…

A:

Q: 2. A 40 cm diameter pipe 600 m long carries 260 liters per second of water from reservoir A,…

A: Length of the main pipe=600 m Diameter of the main pipe(do)=40 cm Discharging pipes diameter=500 m…

Q: Determine the elevation, pressure, and total hydraulic heads at all points, a through g using Datum…

A: step 1-

Q: Question-1 Hydraulic Engineering (Open Channel Hydraulics) Water is flowing in the trapezoidal…

A:

Q: b. Figure 3.2 is the flow of a channel having a large width, b, under a sluice gate. Assuming…

A:

Q: 1 3 2 Figure Q1

A: Supercritical Flow:- Depths of flow less than critical depths resulting from relatively steep…

Q: Estimate the uplift pressure under bottom left corner of this dam If the entire dam sits 6ft below…

A: Find the hydraulic head as follows:

Q: A sketch of a transformed flow net in x-direction under a dam is shown in Figure, the soil has k =…

A: As per bartleby guidelines, for multiple sub parts. We have to solved 1st 3 sub parts. Kindly upload…

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.