A certain liquid X has a normal freezing point of -3.00 °C and a freezing point depression constant K, 4.23 °C-kg-mol. Calculate the freezing point of asolution made of 72.3g of ammonium sulfate ((NH4), SO4) dissolved in 750. g of X.Round you answer to 4 significant digits.°CX3∞oEoloAr When 172. g of benzamide (C₂H,NO) are dissolved in 1050. g of a certain mystery liquid X, the freezing point of the solution is 3.4 °C lower than the freezingpoint of pure X. On the other hand, when 172. g of iron (III) chloride are dissolved in the same mass of X, the freezing point of the solution is 8.0 °C lower thanthe freezing point of pure X.Calculate the van't Hoff factor for iron(III) chloride in X. Be sure your answer has a unit symbol, if necessary, and is rounded to the correct number of significantdigits.XS

Since you have posted multiple questions, we will provide the solution only to the first question as…

A certain liquid X has a normal freezing point of -3.00 °C and a freezing point depression constant K, 4.23 °C-kg-mol. Calculate the freezing point of a solution made of 72.3g of ammonium sulfate ((NH4), SO4) dissolved in 750. g of X. Round you answer to 4 significant digits. °C X S

A certain liquid X has a normal freezing point of -3.00 °C and a freezing point depression constant K, 4.23 °C-kg-mol. Calculate the freezing point of a solution made of 72.3g of ammonium sulfate ((NH4), SO4) dissolved in 750. g of X. Round you answer to 4 significant digits. °C X S

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter11: Properties Of Solutions

Section: Chapter Questions

Problem 5ALQ: You have read that adding a solute to a solvent can both increase the boiling point and decrease the...

See similar textbooks

Similar questions

Instead of using NaCl to melt the ice on your sidewalk you decide to use CaCl2. If you add 35.0 g of CaCl2 to 150. g of water, what is the freezing point of the solution? (Assume i = 2.7 for CaCl2.)
What mass of a 4.00% NaOH solution by mass contains 15.0 g of NaOH?
Samples of each of the substances listed below are dissolved in 125 g of water. Which of the solutions has the highest boiling point? (a) 3.0 g sucrose, C12H22O11 (b) 1.0 g glycerol, C3H3(OH)3 (c) 1.0 g propylene glycol, C3H6(OH)2 (d) 2.0 g glucose, C6H12(OH)2
The freezing point of a 0.21 m aqueous solution of H2SO4 is -0.796C. (a) What is i? (b) Is the solution made up primarily of (i) H2SO4 molecules only? (ii) H+ and HSO4- ions? (iii) 2H+ and 1SO42- ions?
Insulin is a hormone responsible for the regulation of glucose levels in the blood. An aqueous solution of insulin has an osmotic pressure of 2.5 mm Hg at 25C. It is prepared by dissolving 0.100 g of insulin in enough water to make 125 mL of solution. What is the molar mass of insulin?
Cooking A cook prepares a solution for boiling by adding12.5 g of NaCl to a pot holding 0.750 L of water. Atwhat temperature should the solution in the pot boil?Use Table 14.5 for needed data.
6-111 As noted in Section 6-8C, the amount of external pressure that must be applied to a more concentrated solution to stop the passage of solvent molecules across a semipermeable membrane is known as the osmotic pressure The osmotic pressure obeys a law similar in form to the ideal gas law (discussed in Section 5-4), where Substituting for pressure and solving for osmotic pressures gives the following equation: RT MRT, where M is the concentration or molarity of the solution. (a) Determine the osmotic pressure at 25°C of a 0.0020 M sucrose (C12H22O11) solution. (b) Seawater contains 3.4 g of salts for every liter of solution. Assuming the solute consists entirely of NaCl (and complete dissociation of the NaCI salt), calculate the osmotic pressure of seawater at 25°C. (c) The average osmotic pressure of blood is 7.7 atm at 25°C. What concentration of glucose (C6H12O6) will be isotonic with blood? (d) Lysozyme is an enzyme that breaks bacterial cell walls. A solution containing 0.150 g of this enzyme in 210. mL of solution has an osmotic pressure of 0.953 torr at 25°C. What is the molar mass of lysozyme? (e) The osmotic pressure of an aqueous solution of a certain protein was measured in order to determine the protein's molar mass. The solution contained 3.50 mg of protein dissolved in sufficient water to form 5.00 mL of solution. The osmotic pressure of the solution at 25°C was found to be 1.54 torr. Calculate the molar mass of the protein.
Sodium chloride (NaCl) is commonly used to melt ice on roads during the winter. Calcium chloride (CaCl2) is sometimes used for this purpose too. Let us compare the effectiveness of equal masses of these two compounds in lowering the freezing point of water, by calculating the freezing point depression of solutions containing 200. g of each salt in 1.00 kg of water. (An advantage of CaCl2 is that it acts more quickly because it is hygroscopic, that is. it absorbs moisture from the air to give a solution and begin the process. A disadvantage is that this compound is more costly.)
The solubility of lead nitrate at 100C is 140.0 g/100 g water. A solution at 100C consists of 57.0 g of lead nitrate in 64.0 g of water. When the solution is cooled 10C to 25.0 g of lead nitrate crystallize out. What is the solubility of lead nitrate in g/100 g water at 10C?
Arrange 0.10 m aqueous solutions of the following solutes in order of decreasing freezing point and boiling point. (a) Al(ClO3)3(b) CH3OH (c) (NH4)2Cr2O7 (d) MgSO4
Fluoridation of city water supplies has been practiced in the United States for several decades. It is done by continuously adding sodium fluoride to water as it comes from a reservoir. Assume you live in a medium-sized city of 150,000 people and that 660 L (170 gal) of water is used per person per day. What mass of sodium fluoride (in kilograms) must be added to the water supply each year (365 days) to have the required fluoride concentration of 1 ppm (part per million)that is, 1 kilogram of fluoride per 1 million kilograms of water? (Sodium fluoride is 45.0% fluoride, and water has a density of 1.00 g/cm3.)
You have read that adding a solute to a solvent can both increase the boiling point and decrease the freezing point. A friend of yours explains it to you like this: The solute and solvent can be like salt in water. The salt gets in the way of freezing in that it blocks the water molecules from joining together. The salt acts like a strong bond holding the water molecules together so that it is harder to boil. What do you say to your friend?