a) Binary data is to be sent at the rate R, = 100 K bits/s over a channel with %3D 40 dB transmission loss and noise density N. -10-12 W/Hz at the receiver. What transmitted power is needed to get P = 104for coherent BPSK modulation technique. %3D
Q: The figure below shows a mobility Nyquist plot representing the response of a single mode. The three…
A: The displayed Nyquist plot illustrates how one mode responded.According to the information in the…
Q: At what wavelength 300<λ<600 will the minimum power transmission occur? What is the power…
A: Solution is given below with appropriate assumptions.Explanation:
Q: Question A2 Blue light of vacuum wavelength 450 nm is travelling in a non-magnetic dielectric glass…
A: In this question, we have to find impedance, wavelength, and the critical angle. We solve it…
Q: 8.2-8 Mode Cutoff. Show that the cutoff condition for TE mode m > 0 in a symmetric slab waveguide…
A:
Q: 3. The dimension of a rectangular metallic waveguide is 1.5 cm by 0.75 cm. Please write down the…
A: Given that, The dimension of a rectangular metallic waveguide is 1.5 cm by 0.75 cm. So, a=1.5…
Q: True or false? A narrow band pass spectrophotometer produces more sensitive measurement and is less…
A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…
Q: Exo 2: Number of modes in a hopped-index fiber A fiber has a fractional index jump of A = 5 x 10-2…
A: The objective of this question is to calculate the radius of a fiber optic cable that will allow for…
Q: Pulse Propagation. A pulse of initial temporal width To is transmitted through a graded- index fiber…
A: Temporal width = D = λ0c0d2n1dλ20
Q: Using the physics terms and expressions show that the efficiency of half wave rectifier is given by…
A:
Q: 4) By using the Fourier transform method Fourier Series solve the PDES ou t
A: Solution:e -iωx e -k ω2t will solve the heat equation ut=k uxx sou(x, t) = ∫-∞∞c(ω)e -iωx e -k ω2t…
Q: The CT signal x(t)=6cos (800πt) + 8cos2 (mπt) is critically sampled (Nyquist rate) by fs=8000 Hz.…
A: Given:- The CT signal xt = 6 cos 800πt +8 cos 2fs = 8000 Hz
Q: Q12: Find all elements of the Maxwell's Stress tensor for a monochromatic plane EM wave travelling…
A:
Q: An optical fibre communication link 5 km long is to be constructed with an analogue modulation…
A: GivenAn optical fibre communication link 5 km long is to be constructed with an analogue modulation…
Q: A film suspended in air has a spectrally-averaged transmittance of 0.886 in a non- absorbing region.…
A:
Q: i) The measure of how fast data can be transmitted in a given bandwidth is referred to as____ .…
A: The answer to the above questions let us understand the terms given in the question
Q: The following Bode plot was derived from a system whose input is r(t) and output y(t). What is the…
A: 6 Given;
Q: When aligning one of the antennas, it was found that the standing wave ratio is 1.2 VSWR, which…
A:
Q: Given: - cellular phone with 0.6W transmit power - unity gain antenna, 900 MHz carrier frequency -…
A: To calculate the maximum distance, we need to consider the power received at the receiver and…
Q: compare between coherent and incoherent demodulation of FSK signal when the signal to noise ratio…
A: The non-coherent FSK demodulator is more suited for wide-band FSK signals, since the matched filter…
Q: 3- Determine the first ten natural frequencies and mode shapes of an square membrane with length 500…
A: The formula relating the velocity of the wave and tension is given by the following expression. v=Tμ…
Q: A (9 km) WiFi point-to-point link between two buildings operates at (5.725 GHz). Both ends have…
A: WiFi is placed in between point to point link, they operates at 5.72GHz this represents the uplink…
Q: (a) What is the wavelength of 125-MHz radio waves used in an MRI unit? m (b) If the frequencies are…
A: Given data: The frequency of the radio waves, ϑ=125 MHz. Radio wave is an electromagnetic…
Q: When a narrowband laser beam with total intensity 1(z) propagates through an active medium, the…
A: The length of the fibre is given as, z=10 m. The saturation intensity of the fibre is given as,…
Q: A cectangular air-filled copper waveguide with dimenssion 2.28 cm x 1.01cm cross section 30.48 cm…
A: the first three has been answered. a) cut off frequency is, fc=c2a=3×108 m/s22.28×10-2 m=6.6×109…
Q: A carrier signal given by (cos2Tt105t) volt is AM modulation by the message signal given by…
A: *Minor correction* the carrier signal is given by cos 2π 105t and the modulated/message signal is…
Q: Q2/If the beamwidth at which a particular antenna operates is 21.39, since the lowest frequency…
A: If the lower frequency is f1 and the upper cutoff frequency is f2 then, a) center frequency=f1f2 if…
Q: What is the minimum link bandwidth to multiplex 10 channels each has 3KHz bandwidth using FDM with a…
A:
Q: A wireless link has a 50W transmitter that sends a signal with a frequency of 900 MHz, Both TX and…
A:
Q: Consider an AM signal with multi-tone modulation where the modulation signa m(t) is given by: m(t) =…
A: The Modulating wave is given by m(t) = 2 sin(3wmt) The carrier wave is given by c(t) = 3 cos(wct)…
Q: A continuous-time signal x(t) has a bandlimited spectrum with the highest frequency of 5KHZ is…
A:
Q: When the mean optical power of 120 µW is used as an input to a fiber of length 8km, the mean optical…
A: Given that Input Optical Power: 120μW Output Optical Power: 3μW (a) A = 10*log10(Inpur Power Output…
Q: Optical Power. Show that the optical power flow in the z direction associated with the TE mode E,(y,…
A: Detailed solution is given below:
Q: Jusco Melaka is linked with the Head Quarter in Klang Valley using 140 km single mode optical fiber…
A: Given: Jusco Meleka is linked with the head Quarter in Klang Valley using 140 km single mode optical…
Q: Frequency difference between longitudinal modes (mode spacing a. b. Number of modes C. Frequency of…
A:
Step by step
Solved in 3 steps