Answered: compare between coherent and incoherent… | bartleby

Related questions

Question

compare between coherent and incoherent demodulation of FSK signal when the signal to noise ratio (SNR) of AWAG channel is high or low.

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A space mission control center on the earth has its antenna noise power of -108 dBm, receives a message signal bandwidth of 5 MHz from an interplanetary space probe at a distance of 22.2 x 109 km away. Determine the antenna noise power (in Watts), noise temperature and the time taken (in hours) for the message signal from the space probe to arrive on earth. Then state the frequency band that is suitable to be used and give reasons.
design an ordinary end fire uniform linear array with only one maximum so that its directivity is 20 dB (above isotropic). The spacing between the elements is lambda/4 and its lenth is much greather than the spacing. Determine the (a) the number of elements (b) overall length of the array (in wavelengths) (c) approximate half-power beamwidth(in degrees) (d)amplitude level (compared to the maximum of the major lobe) of the first minor lobe (in dB) (e) progressive phase shift between the elements (in degrees)
A Fabry-Perot device contains two parallel part-reflective surfaces, each with a power reflection coefficient R = 0.9, separated by an air gap of 0.05 mm. The device is used at near-normal inci- dence with a transmission maximum at wavelength 600 nm. Calculate the coefficient of finesse, and the resolving power.