i) The measure of how fast data can be transmitted in a given bandwidth is referred to as____ . Select one: a) power efficiency. b) spatial efficiency. c) code efficiency. d) spectral efficiency. ii) Attenuation in a channel causes changes in the shape of the transmitted signal. select one: TRUE FALSE

Q: Review V: 120 coS Li000) R- 6R RLC circuits L = 2 mH C: 5000 uF W= 1000 : 21€ Find I V: Vmax cos…

A:

Q: Answer 1-3. Answer with VERY BRIEF explanation only.

A:

Q: What is the trigger function of an oscilloscope? Setting the time base ☐ ☐ Synchronization of the…

A: An oscilloscope is a laboratory instrument commonly used to display and analyze the waveform of…

Q: 5. Below graph shows transimittance of ZnSe on glass substrate. Eestimate transmittance of ZnSe at…

A: The graph showing Wavelength v/s Transmittance is plotted. The transmittance percentage for the…

Q: The speech quality for a particular mobile communication system is just acceptable when the received…

A: (a)Received power at the mobile receiver is PR = -110 dBm (b)Maximum acceptable path loss Lmax is…

Q: Record 2 peak to peak time measurements of this trace.

A: Given: The peak voltage in the image is V = 3 V. The frequency of the sine wave is f = 800 Hz.

Q: Give at least two explanations for the discrepancy between the bandwidth a service provider claims…

A: To find: The difference between the bandwidth a service provider advertises and the throughput…

Q: why multiplexing is impotant for maximum throughput

A: Multiplexers, which are also called muxes, are extremely important for telecommunications. Their…

Q: When phase difference (0) is 90° the power dissipation (P) will be maximum Select one: True False

A: We need to tell whether the power dissipation is maximum or not when the phase difference between…

Q: What are the main system hardware requirements which must be taken into consideration when changing…

A: To explain the correct answer is given below,

Q: A transmitter transmits an AM signal with a carrier frequency of 1470 kHz. When a superheterodyne…

A: The AM receiver frequency of 455 kHz is tuned to 1530 kHz with a superheterodyne radio receiverIn…

Q: An AM transmitter puts a carrier of 20V into an antenna whose resistance is 1500. The transmitter is…

A: Given data V=20 VR=150 Ωm=60% Here, V is the voltage and  R is the resistance. While m is the…

Q: 3. Consider a compact dise that uses pulse-code modulation to record audio signals whose bandwidth W…

A:

Q: The output of a transmitter is 2 mV mms and the noise was 0.5 mV rms the SNR is o 16 none of the…

A: Noise value (N) = 0.5 mV S = 2 mV

Q: Q4. A resistor of resistance 7 ohm is connected in series with a capacitor of capacitance 50 micro F…

A:

Q: Assuming a PON system has performance parameters as follows: transmit power at OLT is

A: Given Data Given Input power is: IP=1 mW=10-3wattIP=1dBm Splitter ratio is:N=32 Length of optical…

Q: A radar system observing a target is characterized by the following parameters: Transmitted power =…

A: Given Data: The transmitted power is, Pt=40 dBW The antenna gain of a radar system is, G=28 dB The…

Q: An outdoor WiFi unit for a picnic area has a 100-mW output and a range of about 30 m. What output…

A: Given,

Q: Vcc=15V 5. For the circuit given in Figure 4, find the values of R, and R, where Icsat = 1.5mA and…

A: Answer: Given, Vcc=15V Ic= 1.5mA =0.0015A Input signal is square wave  Given, amplification factor,…

Q: What is the reading on this device if the range is assigned at 15V? 1.8 V 2.8 V 6V 9V 15 V 10 2 8 10…

A: given thatrange assigned is 15 Vwe have to find the reading on the device.

Q: A firing angle controlled triac is feeding a single-phase R-L load with L=15 mH and R=11 ohm.The…

A: Given: Single phase R-L load L=15 mH and R= 11 ohm Triac input voltage is 220V rms and 60Hz To find:…

Q: Problem H a) Determine the closed-loop 3-db bandwidth. The op amp has a unity-gain frequency of 0.8…

A:

Q: k? a (ATD1) interrupt to th nis interrupt is $FFD0.

A: It is known that the SPI refers communication channel fundamental property and has bound rate which…

Q: what is the minimum power required for a loudspeaker to produce 103DB sound at a distance of 10.1 M…

A:

Q: 2) Suppose f(E) of problem 4 is sent through an ideal filter with magnitude gain THC jw)l -1.5 w.…

A: The wave given to the filter,                               fa(t) = 10 cosω0t + 5 cos2ω0t The wave…

Q: A carrier signal given by (cos21105t) volt is AM modulation by the message signal given by…

A: The solution for the given below is :- Pc = 128 , Ps = 64, BW = 2 KHz, u = 0.03

Q: "Light waves"

A:

Q: Electrical Physical variable signal (analogue) Digital output S/H ADC Transducer Sample-and-Hold The…

A: (iii) For a successive approximation analog to digital converter, the conversion time be defined as,…

Q: 25 analog signals (each is bandlimited to 15kHz) are transmitted simultaneously over a channel via…

A: Given that:-Number of analog signals, N=25The band limited frequency, fm=15KHzWe know that:-By…

Q: A pipeline of length 20 km is used for transmission of water. If the 100 kW power is to be…

A:

Q: Write the function of (i) Transducer and (ii) Repeater in the context of communication system.

A: i. The transducer is an electronic device that is capable of transforming one form of energy into…

Q: Problem 4: Two wattmeters are connected to measure the input power of a balanced 3-phase load by the…

A:

Q: Find the direction and the equation will be used. Also find the i's, Vr1 to Vr7 and P1 to P7.…

A: Given: The resistance is given as, R1=226 Ω R2=35 ΩR3=933 ΩR4=597 ΩR5=762 ΩR6=456 ΩR7=100 Ω The…