A 8-stage impulse voltage generator is connected to a test object of load capacitance of 5000pF with wave front resistance equal to 700 Ω. If the wave tail and wave front times of the impulse wave are 50 μs and 1500 ns respectively. Calculate (i) wave tail resistance value and (ii) the capacitance of the impulse generator?

A 8-stage impulse voltage generator is connected to a test object of load capacitance of 5000pF with wave front resistance equal to 700 Ω. If the wave tail and wave front times of the impulse wave are 50 μs and 1500 ns respectively. Calculate (i) wave tail resistance value and (ii) the capacitance of the impulse generator?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

2, In a circuit, the capacitance of a capacitor is 3.2 microfarads and the rms voltage of the generator is 50 volts. Frequency (a) 100 Hz and (b) what is the rms current in the circuit when it is 1000 Hz?
Identify the following on the blank
The Subject is Basic Electrical Engineering Chapter 15. Conductance, Susceptance and Admittance of AC Circuit.
Question is in the picture.
26- If we have a multi - stage impulse generator with a highest charging voltage ( Vrms) of 115.475 KV & a discharge capacitance of the generator ( Cg) of 1 microfarad. If we need to generate a high voltage of 7.07107 MV (r.m.s): 1) What is the number of stages? ? 2) What is the energy of this generator a- 5 stage, 200 KJ. b- 4 stage, 200 KJ. C50 stage, 20KJ. d- All these answers are wrong. 27- For economic consideration, we -13 prefer to use HVDC Transmission than using HVAC Transmission when the distance of the transmission line a- Equal to 280 km. b- Under than 300 km. C- Greater than 300 km. . d- Between 50 to 500 km. e- 28- The working stress of the d.c. cable-3 insulation may be a- 2 to 3 times higher than under a.c b- .4 to 5 times higher than under a.c. C 3 to 4 times higher than under a.c. . 1 to 2 times higher than under a.c. d- 29- The most dangerous/short circuit fault that increases the voltage (overvoltage) on the other lines is: a- Single line to earth. b- Two line to…
A single-phase AC voltage controller has a resistive load R = 10 Ohm, and the RMS input voltage is Vs = 230 V, 60 Hz. The delay angle is 120 degree. Then power factor of the circuit is: Select one: O a. 1 O b. 0.75 O c. 0.44 O d. None of the above O e. 0.9
6 to 8
a) A sinewave is having a frequency of 50 Hz and instantaneous value of 250 Volts at 1.1 milli seconds. Find i) The maximum value of sinusoidal voltage waveform and ii) The value of voltage at 2.1 milli seconds. b) Determine the instantaneous equation for the voltage waveform shown in figure, if Vp=150 Volts, Time period is 15 milli seconds and =50 degrees. Vp t = 0 Ф II
ANSWER 1,4,6 with clear handwriting
A single-phase motor draws 220 W at a power factor of 0.8 lagging when connected across a 240 V rms, 60-Hz source. A capacitor is connected in parallel with the load to produce a unity power factor. Determine the required capacitance.
Define the term Capacitance and Inductance? Capacitance: It is the amount of charge that is stored inside a capacitor at a given voltage. Inductance: It is defined as the property of a coil to resist any changes in electric current flowing through it. Mutual inductance happens when a secondary coil opposes current change in the primary coil. Mention what is the difference between generator and alternator? Both generator and alternator work on the same principle they convert mechanical energy into electrical energy. Generator: It converts induced emf (Electro Motive Force) into direct current, where it based on stationary magnetic field and revolving conductor which rolls on the armatures with slip rings and brushes riding against each other. Alternator: It has rotating magnetic and stationary armature for high voltage and stationary magnetic field and a rotating armature for low voltage
2.2 please