A 480 kg concrete table needs to be supported at the four corners by compressed-air cylinders. Each cylinder is 20 cm in diameter and has a 1.20 m initial length when the pressure inside is 1.0 atm. A hoist lowers the table very slowly, compressing the cylinders while allowing them to stay in thermal equilibrium with their surroundings. Part A How much work has been done on the gas of the four cylinders when the table reaches its equilibrium position? Express your answer with the appropriate units. HẢ W = 4600 Pa Submit Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining

A 480 kg concrete table needs to be supported at the four corners by compressed-air cylinders. Each cylinder is 20 cm in diameter and has a 1.20 m initial length when the pressure inside is 1.0 atm. A hoist lowers the table very slowly, compressing the cylinders while allowing them to stay in thermal equilibrium with their surroundings. Part A How much work has been done on the gas of the four cylinders when the table reaches its equilibrium position? Express your answer with the appropriate units. HẢ W = 4600 Pa Submit Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A crate of fruit with a mass of 40.0 kg and a specific heat capacity of 3550 J/(kg. K) slides 9.00 m down a ramp inclined at an angle of 40.0 degrees below the horizontal. Part A If the crate was at rest at the top of the incline and has a speed of 2.55 m/s at the bottom, how much work Wf was done on the crate by friction? Use 9.81 m/s² for the acceleration due to gravity and express your answer in joules. ► View Available Hint(s) Wf = -2140 J Submit Correct The frictional force opposes the motion of the crate, so the work done on the crate by friction must be a negative quantity. Part B Previous Answers If an amount of heat equal to the magnitude of the work done by friction is absorbed by the crate of fruit and the fruit reaches a uniform final temperature, what is its temperature change AT? ► View Available Hint(s) AT = ΑΣΦ W
A cylinder contains 0.250 mol of carbon dioxide (CO₂) gas at a temperature of 27.0°C. The cylinder is provided with a frictionless piston, which maintains a constant pressure of 1.00 atm on the gas. The gas is heated until its temperature increases to 127.0°C. Assume that the CO₂ may be treated as an ideal gas. Part A How much work is done by the gas in this process? Express your answer in joules. — ΑΣΦ W = Submit Part B On what is this work done? The work is done on the piston. The work is done on the cylinder. Submit Part C Request Answ AU = What is the change in internal energy of the gas? Express your answer in joules. ΑΣΦ Submit Request Answer Request Answer P Pearson W ? ? J J
For a planet to have an atmosphere, gravity must be sufficient to keep the gas from escaping The escape speed a particle needs to escape the earth's gravitational attraction is 1.1 x 10 m/s. The motion of projectiles never depends on mass, so this escape speed applies equally to rockets and to molecules in the earth's upper atmosphere. Part A At what temperature does the rms speed of nitrogen molecules equal the escape speed? Express your answer in kelvins. ΜΕ ΑΣΦΑ T- Submit Part B T- Request An At what temperature does the mms speed of hydrogen molecules equal the escape speed? Express your answer in kelvins. VAZO Submit ? K K
A heat engine does 160 J of work per cycle while exhausting 420 J of waste heat. Part A What is the engine's thermal efficiency? Express your answer as a percentage.
I Rev Part A How much work is done by the gas in the process shown in the figure? (Figure 1) Express your answer in joules. V AZO ? W = J Submit Request Answer Figure 1 of 1 > Provide Feedback Р (КРа) 400- 200 i V (cm³) 100 200 300
In an engine, an almost ideal gas is compressed adiabatically to half its volume. In doing so, 2710 J of work is done on the gas. Part A ▼ How much heat flows into or out of the gas? Express your answer with the appropriate units. ? Q = Value Units Submit Request Answer Part B What is the change in internal energy of the gas? Express your answer with the appropriate units. HẢ ? AU = Value Units Submit Request Answer
An ideal gas at 20°C consists of 2.2 x 1022 atoms. 3.2 J of thermal energy are removed from the gas. Part A What is the new temperature in °C? Express your answer in degrees Celsius. DA ΑΣφ T = °C Submit Request Answer
Homework 4, Problem 3 Part (a) For n = 1 moles, T = 305 K, and V2 = 3.5V1, determine the work done by the gas on the external body. The gas constant is R = 8.314 J K-1 mol-1. W = ______
4.5 mol of monatomic gas A interacts with 2.9 mol of monatomic gas B. Gas A initially has 9000 J of thermal energy, but in the process of coming to thermal equilibrium it transfers 800 J of heat energy to gas B. How much thermal energy did gas B have initially? Express your answer with the appropriate units. ► View Available Hint(s) EBi = Submit Value 4 Previous Answers Units ?
A physicist uses a cylindrical metal can 0.350 m high and 0.090 m in diameter to store liquid helium at 4.22 K; at that temperature the heat of vaporization of helium is 2.09 x 104 J/kg. Completely surrounding the metal can are walls maintained at the temperature of liquid nitrogen, 77.3 K, with vacuum between the can and the surrounding walls. Part A How much helium is lost per hour? The emissivity of the metal can is 0.200. The only heat transfer between the metal can and the surrounding walls is by radiation. Express your answer in gram per hour. Am At Submit ΠΕ ΑΣΦΑΦ Request Answer PZ ? Review | Constants g/h
I need solutions question B
A cylinder contains 0.250 mol of carbon dioxide (CO₂) gas at a temperature of 27.0°C. The cylinder is provided with a frictionless piston, which maintains a constant pressure of 1.00 atm on the gas. The gas is heated until its temperature increases to 127.0°C. Assume that the CO₂ may be treated as an ideal gas. Express your answer in joules. AU = Submit Part D Submit How much heat was supplied to the gas? Express your answer in joules. Part E W₁ = ΑΣΦ | Submit Request Answer ΑΣΦ Request Answer Request Answer < Return to Assignment Provide Feedback www How much work would have been done if the pressure had been 0.50 atm? Express your answer in joules. VE ΑΣΦ P Pearson = ? ? J ? J J