A 2MW mini-power generation plant supplies an industrial area which has a demand pattern as shown on table 1 below: Demand [kW] 1400 0 200 1600 800 Plot the daily load curve Toble 1: Duration 5hrs 7hrs 4hrs 4hrs 4hrs

A 2MW mini-power generation plant supplies an industrial area which has a demand pattern as shown on table 1 below: Demand [kW] 1400 0 200 1600 800 Plot the daily load curve Toble 1: Duration 5hrs 7hrs 4hrs 4hrs 4hrs

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: b) The capacity factor for a plant capacity of 2850 c) The reserved load. d) The reserved factor. e)…

A: The Capacity factor for a given plant capacity is defined as the ration between the average annual…

Q: i) ii) iii) The complex power of each load; Load 1, Load 2, Load 3 and Load 4. The total complex…

Q: In the given circuit, the amplitude of the input voltage is 160 Volts RMS and its phase is 35…

Q: For a certain load, it is given that v(t)= 30cos(40t-10) V and i(t) = 12sin(40t+50). The average…

Q: A certain load varies as follows for 269 days per annum: 436 kVA at a power factor of 0.819 lagging…

Q: Reactive Power Delivered by the Generator, VAR Real Power Absorbed by the Load, W Reactive Power…

A: In the given questions we need to calculate the real and reactive power of the load and source.

Q: ▾ Part A Find the minimum value of V₁, (rms). Express your answer to three significant figures and…

A: Given circuit,Load absorbing the apparent power S=220 VALoad power factor = 0.6 lagging.Asked to…

Q: A daily load curve which exhibited a 15-minute peak of 3000 kW is drawn to scale of 1 cm = 2 hours…

Q: 5. For the circuit in Figure 5, calculate the current i in steady state and the power factor…

Q: A 100 kVA, 230V load operates at 0.80 lagging power factor. The power factor is to be improved to…

Q: A certain load varies as follows for 269 days per annum: 436 kVA at a power factor of 0.819 lagging…

A: In the question, Find the average load per annum. Average load = total energy/ time

Q: In the calibration of single-phase, energy meter, find the value of Eactual in watthour for the…

A: In the calibration Value of the all parameters are given. What is value of actual energy?

Q: A customer trans Former has resi dantia 1 12 customer Connected to it. Connected Load is 20 Kw Per…

A: Given data: Number of loadsN=12Demand factor=0.6Diversity factor=1.15Demand on the transformer=20 kW

Q: load of 500 kVA operates on 1100 V, 50 Hz mains with power factor of 0.6 lagging. It is required to…

Q: A balanced 3-phase load absorbs a complex power of 10 30° kVA. What is the average power consumed by…

A: Three phase complex power S= 10<300 KVA Average power consumed by load P =?

Q: Consider the circuit shown: V1 sine ✓ 60 Hz 120 Vrms ий 4:1 R1 100 Ω 1:2 Figure 2: Cascaded…

A: The circuit diagram,

Q: 500 KVA star connected 440 V alternator supplies full load power to the load at 0.8 lagging power…

Q: Determine the current I, in the network in Figure below. V oilot srt nev ntv, O 12 v 2 2 kN V2 V3 VA…

A: The equivalent circuit with assumed currents direction in each resistor is shown below: The “6 V”…

Q: Given: Gen 1 1500 KVA, 3Phase , 2.3 KV, 4 Poles No load speed= 1830 rpm Speed @ 1500 Kw = 1788 rpm…

A: No load speed of generator 2 = 3684 rpm,Speed at 5000 kW = 3532 rpm,Total load connected = 6000 kW

Q: p(t) Watt 1200 1000 800 600 400 200 10 -200 -400 Time (msec) Q Zoom image O Frequency 50 Hz Average…

Q: 1- Draw the load curve of power station 2- Draw the load curve of loads(A,D) 3- Find the ratio…

Q: Question The coils of a wattmeter have resistances 0.01 Q and 1000 Q; their inductance may be…

A: Given- Resistances- R=0.01 & 1000 Ω, Current I=25A, Power factor PF=0.8, Load terminal V=30 V.…

Q: *LINE 1 P 1 KW consuming Q=1 KVAR consuming *LOAD 1 P 5 KN consuming Q =9.45 KVAR delivering *LINE 2…

A: As per Bartleby policy we can answer only three subparts. So I am solving first three for you please…

Q: certain load varies as follows for 269 days per annum: 436 kVA at a power factor of 0.819 lagging…

A: In the question, Find the average annual load factor Load factor = average load/ maximum load…

Q: A single-phase inductive load draws to 1 kW at 0.6 power-factor lagging from a 230 V AC supply. 1.…

A: It is given that:

Q: A 2 MW generation station has a daily average load of 500 kw with plant use factor of 0.8. The hours…

A: Plant use factor the ratio of average load over a period of 24 hrs to the Plant capacity in ON time.…

Q: Voltage between 1 kV and 50 kV is defined as: A.Very High Voltage B.Medium Voltage C.Low Voltage…

A: The solution is given below

Q: Compute the power factor and the apparent if the real power and reactive power are 480 kW and 400…

A: Power factor = active power/ apparent power. Apprentice power = sqrt(active power2+reactive power2).

Q: A certain load varies as follows for 269 days per annum: 436 kVA at a power factor of 0.819 lagging…

A: In the question, Find the average load . Average load = total energy/ time

Q: 2. Determine the average power absorbed by cach resistor, the total average power absorbed and the…

A: Given figure as- I1=12∠45°4I1=3∠45°I2=12∠45°2-j1Ω=12∠45°2.236∠-26.56°I2=5.366∠71.56° A

Q: For the following network find a) Is b) Pr, Qr, ST and PFT c) Draw power triangle d) Raise the power…

Q: From the circuit given below, How can I find the value of load Z for the maximum power transfer and…

A: According to question: The value of 'Z' for maximum power transfer is calculated as…

Q: a) b) c) Draw the power triangles for Load 1, load 2, and the sum of the two power triangles. Find…

A: The complex power in an AC system is defined as the product of rms value of applied voltage and…

Q: Q1. A circuit is given as shown in Figure Q.1. The frequency of the circuit is 50 H followings: а.…

Q: The load in the circuit shown absorbs 50 kVA of complex power at power factor pf = 0.83 lagging when…

Q: The variable resistor Ro.in the circuit shown in Figure is adjusted until maximum average power is…

A: Given circuit,To find Ro we need to find VTH and Isc.

Q: A load in a factory consists of the following i. 9kW of lighting at unity power factor ii. A 12kVa…

A: The objective of the question is to calculate the total power, reactive power, apparent power, power…

Q: Given: Gen 1 1500 KVA, 3Phase , 2.3 KV, 4 Poles No load speed= 1830 rpm Speed @ 1500 Kw =…

Q: Question 4 For the circuit shown, what is the complex power, S, consumed by the load impedance? (A=…

Q: 2 A generation station of 1 MW supplied أعلى قيمة هي رادم فيها واط ۱۰۰۰۰۰ dregion as follow: from…

Question

A 2MW mini-power generation plant supplies an industrial area which has a demand pattern as shown on
table 1 below:
Demand [kW]
1400
0
200
1600
800
Plot the daily load curve
Toble 1:
Duration
5hrs
7hrs
4hrs
4hrs
4hrs

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Evaluate (130 points); Use 3 decimal places. 1. The annual load of a substation is given in the following table. During each month, the power is assumed constant at an average value. Find the (a) average load and (b) the annual load factor. Annual System Load January February March 8 Y 4 April May 26 2 6 2, Tv June 12 sing July 14 phas August 14 idea September 10 imp October 8 5Y5 November December 68 6 ma del
A certain load varies as follows for 269 days per annum: 436 kVA at a power factor of 0.819 lagging for eight hours per day. 208kVA at a power factor of 0.836 lagging for eight hours per day. 131 kVA at unity power factor for eight hours per day. For the remaining time of the year, the load varies as follows: • o 90 kVA at a power factor of 0.822 lagging for eight hours per day. o 25 kVA at a power factor of 0.866 lagging for eight hours per day. o No load for eight hours per day. Determine the form factor ,(Kf)
Q9: The reactance data for the power system shown in Figure below in per unit on a common base is as follows: T1 T2 3 1 4 -머머 ㅜ G1 G2 X,=X,=0.1 X=0.25 X=X;= 0.3 X=0.25 X=X;=0.1 Xo=0.05 Xo=0.5 Xo=0.05 Obtain the Th'evenin sequence impedances for the fault at bus 1 and compute the fault current in per unit for the following faults: (a) A bolted three-phase fault at bus 1. (b) A bolted single line-to-ground fault at bus 1. (c) A bolted line-to-line fault at bus 1. (d) A bolted double line-to-ground fault at bus 1.
Determine the complex power for the following give values and specify whether the power factor is leading or lagging. Vrms = 220 V, P = 1 W, Z| = 20 k2 (inductive) B1
A machine shop is fed by a 250 kVA 480 V three-phase electrical service. On one of thebranches leading away from the service, the shop runs several manufacturing machines,giving the branch a load profile of 175 kW with a 0.85 lagging PF.Determine the minimum allowed gauge of the branch conductors. Branch conductors arealuminum, THW, contained within a raceway with an ambient temperature of 40 ºC
A power station is to supply three loads. The daily cycle of loads are given below: 1- Load factor of the power station. 2- Diversity factor of the power station. 3- The capacity factor when the station is having reserve set 20% of the max. Demand.
answer this question please
Find Real, Reactive and Apparent power for following load configuration. Iline 2300 V Motor 50 hp 0.84 lagging Fan 13 kW 0.75 lagging Heating 24 kW unity
I need the answer quickly