A 2300/208-V 500-kVA 60-Hz single-phase transformer was tested by means ofthe open-circuit test (on the low-voltage winding) and short-circuit test (on thehigh-voltage winding). The test data obtained are:Open-circuit test: Voc = 208 V, Ioc = 52.5 A,Short-circuit test: Vsc = 95 V,Poc = 3800 WPsc = 6200 Wос%3DосIsc= 217.4 A,%3D%3DCalculatea. the efficiency of the transformer at rated kVA and half-rated kVA, when thepower factor is 0.866 lagging; and

Answered: Image /qna-images/answer/26e62b7a-e812-4993-9131-a1200db8b691.jpg

A 2300/208-V 500-kVA 60-Hz single-phase transformer was tested by means of the open-circuit test (on the low-voltage winding) and short-circuit test (on the high-voltage winding). The test data obtained are: Open-circuit test: Voc = Short-circuit test: Vsc = 95 V, 208 V, Ioc = 52.5 A, Isc = 217.4 A, Poc = 3800 W Psc = 6200 W %3D %3D OC %3D %3D SC Calculate a. the efficiency of the transformer at rated kVA and half-rated kVA, when the power factor is 0.866 lagging; and

A 2300/208-V 500-kVA 60-Hz single-phase transformer was tested by means of the open-circuit test (on the low-voltage winding) and short-circuit test (on the high-voltage winding). The test data obtained are: Open-circuit test: Voc = Short-circuit test: Vsc = 95 V, 208 V, Ioc = 52.5 A, Isc = 217.4 A, Poc = 3800 W Psc = 6200 W %3D %3D OC %3D %3D SC Calculate a. the efficiency of the transformer at rated kVA and half-rated kVA, when the power factor is 0.866 lagging; and

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Describe the operation of a transformer tap changer and its role in voltage regulation.
What are the objectives of conducting an open circuit test on single phase transformer?
The equivalent circuit impedances of a 20-kVA, 8000/240-V, 60-Hz transformer are to be determined. The open-circuit test and the short- circuit test were performed on the primary side of the transformer, and the following data were taken: Open-circuit test (on primary) Short-circuit test (on primary) 8000 V V= 489 V I0.214 A 2.5 A P= 400 W P= 240 W Find the impedances of the approximate equivalent circuit referred to the primary side, and sketch the circuit.
Find the elements of the equivalent circuit attributed to the secondary of a single-phase transformer. The no-load voltages in the primary and secondary circuit are 200 volts and 400 volts, respectively, with a frequency of 50 Hz. The primary no-load current at the voltage of 200 volts is 0.7 amperes and the loss of the core is equal to 70 watts. The resistance and reactance of the primary are 3.2 ohms and 1.25 ohms, respectively. The resistance and reactance of the secondary are 0.6 ohm and 0.07 ohm, respectively. Draw the equivalent circle, showing the values of its elements.
Explain what the voltage regulation down of a power transformer is.
3) Transformer cores are laminated in order to A) Simplify its construction. B) Minimize eddy current loss. C) Reduce cost. D) Reduce hysteresis loss.
how eddy-current losses and hysteresis losses can be reduced in a transformer core.
Consider the following open circuit transformer as shown in figure below which operate at: the voltage sources at no load (Voc)=170 V no load current (Ioc) = 85 m A iron losses power (Poc) = 14 W power factor = cos∅= 0.968 Compute the No load transformer parameter magnetizing (Im) and copper losses current (Ic) , (R0) and (X0) ?
A 25 kVA, 2 kV(rms)/100 V(rms) single phase transformer is connected between a 120 V(rms) utility supply and a resistive load. The load current was measured to be 20 A(rms). i. Determine the active power of the load. ii. Determine the primary RMS current. iii. Determine the equivalent resistance of the transformer as seen by the utility supply.