A 15 KVA, 2400: 240/120 V, 60 Hz, the two-winding transformer is to be reconnected as a 2400:2520 V step-up transformer. From test work on the two-winding transformer, it is known that its rated voltage core losses and coil losses are 280 and 300 W, respectively. For this autotransformer, (a) determine the apparent power rating and (b) the full-load efficiency if supplying 2520 V to a 0.8 PF lagging load.

A 15 KVA, 2400: 240/120 V, 60 Hz, the two-winding transformer is to be reconnected as a 2400:2520 V step-up transformer. From test work on the two-winding transformer, it is known that its rated voltage core losses and coil losses are 280 and 300 W, respectively. For this autotransformer, (a) determine the apparent power rating and (b) the full-load efficiency if supplying 2520 V to a 0.8 PF lagging load.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 23 KVA, 2300/230 V, 60 Hz step down transformer has the following resistance and leakage reactance values: R1 = 4 ohm, R2= 0.4 ohm, X1= 2 ohm, X2=0.2 ohm. The equivalent core-loss resistance and the magnetizing reactance on the primary side of the transformer are 12 KO and 8 KQ respectively. The transformer is operating at 50% of its rated load at the rated voltage at the load. If the power factor of the load is 0.5 lagging. Calculate the primary current of the power transformer. \(I_p=\ Amper
Single phase half wave AC-AC converter has a resistance of R = 50 ohms. Input voltage is given as 230 Vrms. Transformer conversion ratio is 1:1. If T1 thyristor is triggered at 60 degrees; a)Rms output voltage? b)Output power? c)RMS load current and average load current? d)Input power factor? e)Average and RMS thyristor current?
A 5-kVA, 4.16kV/120-V, 60-Hz single-phase transformer has the following parameters as referred to the primary side: Re1 = 3 02, Xe1 = 422, Rc1 = 2.5 kn, and Xm1= 2 kn. The transformer is operating at full load with a power factor of 0.87 lagging. Determine the efficiency and the voltage regulation of the transformer. Use the approximate equivalent circuit as seen from the primary side given in Fig. 2. R₁₁ 110 000 jXml Ret jX₁1 000 Ī,- 1 a²2₁ V₂=av₂
Blue is the numerical answer, I need a detailed solution.
Determine the regulation of a transformer in which thepercentage resistance drop is 1% and the percentagereactance drop is 5% when the power factor 0.8 leading.
What are the advantages and disadvantages of back to back test on two similar single phase transformer?
What are the advantages of Transformer Tests?
Quesion 2. Draw an open-delta transformer bank circuit diagram and identify the requirements of open delta transformer.
5. Transformer cores are laminated in order to (a) simplify its construction (b) minimise eddy current loss (c) reduce cost (d) reduce hysteresis loss. 6. A transformer having 1000 primary turns is connected to a 250-V a.c. supply. For a secondary voltage of 400 V, the number of secondary turns should be (a) 1600 (b) 250 (c) 400 (d) 1250 7. The primary and secondary induced e.m.fs. E, and E₂ in a two-winding transformer are always (a) equal in magnitude (b) antiphase with each other (c) in-phase with each other (d) determined by load on transformer second- ary. 8. A step-up transformer increases (a) voltage (b) current (c) power (d) frequency. F
Please do not copy chegg solutions
Complete the blank An isolating transformer is a (..........................)ratio transformer with several important applications.
Centage resistance and percentage reactance of a transformer are 1% and 4%, respectively. What is voltage regulation at power factor 0.8 lagging and 0.8 leading?