A 1500 W electric heater is plugged into the outlet of a 120 V circuit that has a 20 A circuit breaker. You plug an electric hair dryer into the same outlet. The hair dryer has power settings of 600 W, 900 W, 1200 W, and 1500 W. You start with the hair dryer on the 600 W setting and increase the power setting until the circuit breaker trips. What power setting caused the breaker to trip?

A 1500 W electric heater is plugged into the outlet of a 120 V circuit that has a 20 A circuit breaker. You plug an electric hair dryer into the same outlet. The hair dryer has power settings of 600 W, 900 W, 1200 W, and 1500 W. You start with the hair dryer on the 600 W setting and increase the power setting until the circuit breaker trips. What power setting caused the breaker to trip?

Similar questions

Why do power lines near your home contain transformers? A Transformers increase the current flowing into your home. B The transformers reduce the voltage to a level the wires in your house can safely carry. C The transformers increase the voltage supplied to your home during peak usage times. D Transformers decrease resistance in the power lines.
A physics student has a single-occupancy dorm room. The student has a small refrigerator that runs with a current 4 A, a lamp that contains a 100-W bulb, an overhead light with a 60-W bulb, and various other small devices adding up to 8 w. All the appliances run on a voltage of 110 V. Overall Hint a. What is the total power used by the dorm room (while the refrigerator runs)? Total power used by the dorm room is W. b. Assuming that the power plant for the electricity is 10 km away and uses 00-gauge copper wire (diameter 9.266 mm), how much power is dissipated in transmission (remember to count the return wire), if the power plant is directly providing the 110-V? (To be more precise, the power plant is providing the voltage it needs to provide, so that the voltage at the dorm room is 110 V.) Hint for part (b) Power of W is dissipated in transmission at 110 V. c. The most common way to increase the efficiency of power transmission is by using higher voltage for long-distance transmission…
The capacitor in the circuit shown is fully charged by a 24 V battery. The switch is closed at t = 0. At sometime after the switch is closed, the voltage across the capacitor is measured to be 10 V. What is the current in the circuit at this time, in Ampere? C = 3.0 µF, and R = 2.0 02. Your answer needs to have 2 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement. Cil
1F IF 6V 6 V 10 (A) (B) Figure 1:
A student in the laboratory connects a 17 Ω resistor, a 26 Ω resistor, and a 34 Ω resistor in parallel and then connects the arrangement to a 46 V dc source. (a) What is the current? A(b) What is the power? W
In the figure, these three resistors are connected to a voltage source so that R2 = 4.25 Ω and R3 = 9.5 Ω are in parallel with one another and that combination is in series with R1 = 1.5 Ω. Answer both questions below: A) Calculate the power being dissipated by the third resistor R3, in watts. B) Find the total power supplied by the source, in watts.
A series RC circuit with C = 48 mF and R = 50 Ω is driven by a 24 V source. With the capacitor initially uncharged, an open switch in the circuit is closed to complete the circuit. What is the voltage across the capacitor immediately after the switch is closed? What is the voltage across the resistor immediately after the switch is closed? What is the current in the resistor immediately after the switch is closed? What is the voltage across the capacitor after the switch has been closed for 1 s? What is the voltage across the resistor after the switch has been closed for 1 s? What is the current in the resistor after the switch has been closed for 1 s?
Q7.1 The circuit shown below is an RC circuit that consists of R1 = 100 kn, R2 = 200 kn, R3 = 300 kn, C = 5.00 μF, and E = 9.00 V. When the switch is closed at t = 0, the capacitor starts from an uncharged state. The following inquiries relate to the performance of the circuit. a. What is the RC circuit's time constant? b. When will the capacitor be 80% charged? c. At that point, what is the current passing through the R3 resistor? E S R₁ R3 R₂ www
An open circuit containing five resistors starts at point a and ends at point b. The circuit extends to the right from point a and splits into two parallel horizontal branches. There is a 12.0 Ω resistor on the top branch and a 6.00 Ω resistor on the bottom branch. The branches then recombine and the circuit extends to the right to a 5.00 Ω resistor. To the right of the 5.00 Ω resistor, the circuit again splits into two parallel horizontal branches. There is a 4.00 Ω resistor on the top branch and an 8.00 Ω resistor on the bottom branch. The branches then recombine and the circuit extends to the right until it reaches point b.