A 120-kg refrigerator, 2.00 m tall and 85.0 cm wide has its center of mass at its geometrical center. You are attempting to slide it along the floor by pushing horizontally on the side of the refrigerator. The coefficient of static friction between the floor and the refrigerator is 0.300. Depending on where you push, the refrigerator may start to tip over before it starts to slide along the floor. What is the highest distance above the floor that you can push the refrigerator so that it won't tip before it begins to slide? O 0.710 m O 1.42 m 1.63 m 1.21 m 1.00 m

A 120-kg refrigerator, 2.00 m tall and 85.0 cm wide has its center of mass at its geometrical center. You are attempting to slide it along the floor by pushing horizontally on the side of the refrigerator. The coefficient of static friction between the floor and the refrigerator is 0.300. Depending on where you push, the refrigerator may start to tip over before it starts to slide along the floor. What is the highest distance above the floor that you can push the refrigerator so that it won't tip before it begins to slide? O 0.710 m O 1.42 m 1.63 m 1.21 m 1.00 m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 4 m long horizontal uniform beam of mass 20 kg is supported by a wire as shown in the figure. The wire makes an angle of 23 degrees with the beam. Attached to the beam 1.2 m from the wall is a ball with a mass of 48 kg. What is the tension in the string? K 0 (m)
Three children are trying to balance on a seesaw, which consists of a fulcrum rock, acting as a pivot at the center, and a very light board 3.4 m long (Figure 1). Two playmates are already on either end. Boy A has a mass of 45 kg, and boy B a mass of 35 kg. ▼ Part A Where should girl C, whose mass is 25 kg, place herself so as to balance the seesaw? Express your answer to two significant figures and include the appropriate units. for Part A for Part Addo for Part redo for Part A reset for Part A keyboard shortcuts for Part A help for Part A x= Value Units
A 1.5 kg block is connected by a rope across a 50-cm-diameter, 2.0 kg pulley, as shown. There is no friction in the axle, but there is friction between the rope and the pulley; the rope doesn’t slip. The weight is accelerating upward at 1.2 m/s2. What is the tension in the rope on the right side of the pulley?
The experiment you did in lab is repeated, using a uniform metal bar that is 80.0 cm long instead of the meterstick. Since the bar is uniform, its center of gravity is at its center. The new experiment uses different hooks for hanging the masses from the bar, with mhook 5.0 g. As in the experiment you did in lab, X1 = 5.00 cm, m1 300.0 g, and Xp = 25.0 cm. In the 1 new experiment, you make the same measurements as in your lab and plot x versus The line that is the best fit to your data has slope 3800 cm · g. What is the mass of m2 + mhook the bar?
Suppose a 905-kg car is on the bridge in the figure with its center of mass halfway between the hinges and the cable attachment. (The bridge is supported by the cable and hinges only.) The mass of the bridge is 2500 kg. Find the tension, in newtons, in the cable.
A ladder leans against a wall 5 meters above the ground so a homeowner can clear his gutters of leaves from last fall. The bottom of the ladder just begins to slip when it is 1.7 meters from the wall. What is the coefficient of static friction between the bottom of the ladder and the ground?
A tightrope walker is walking between two buildings holding a pole with length ?=15.5 m, and mass ??=19.5 kg. The daredevil grips the pole with each hand a distance ?=0.575 m from the center of the pole. A bird of mass ??=525 g lands on the very end of the left‑hand side of the pole. Assuming the daredevil applies upward forces with the left and right hands in a direction perpendicular to the pole, what magnitude of force ?left and ?right must the left and right hand exert to counteract the torque of the bird?
One end of a uniform meter stick is placed against a vertical wall. The other end is held by a lightweight cord that makes an angle 0 with the stick. The coefficient of static friction between the end of the meter stick and the wall is µ, = 0. 400. A. What is the maximum value the 0 can have if the stick is to remain in equilibrium? A block of the same weight as the meter stick is suspended from the stick, as shown, at a distance x from the wall. Assume that 0 = 15.0° in this problem. What is the minimum value of x for which the stick will remain in equilibrium? When 0 = 15.0°, how large must the coefficient of static friction be so that the block can be C. attached 0. 100 [m] from the left end of the stick with out causing it to slip? B.
What is the student’s weight?
A board 2 meters long weighing 100 N is hanging off the edge of a table. The center of mass of the board is at its center and is 0.2 m from the edge. Can a 20 N cat climb out to the end of the board without it falling? Yes No Not enough information
To get up on the roof, a person (mass 87.0 kg) places a 5.60 m aluminum ladder (mass 14.0 kg) against the house on a concrete pad with the base of the ladder 2.00 m from the house. The ladder rests against a plastic rain gutter, which we can assume to be frictionless. The center of mass of the ladder is 2 m from the bottom. The person is standing 3 m from the bottom. What are the magnitudes (in N) of the forces on the ladder at the top and bottom? top N bottom N
Item 9 A garage door is mounted on an overhead rail (Figure 1). The wheels at A and B have rusted so that they do not roll, but rather slide along the track. The coefficient of kinetic friction is 0.54. The distance between the wheels is 2.00 m, and each is 0.50 m from the vertical sides of the door. The door is uniform and weighs 900 N. It is pushed to the left at constant speed by a horizontal force F, that is applied as shown in the figure. Figure B k A K 2.00 m -3.00 m h F 1 of 1 If the distance his 1.60 m, what is the vertical component of the force exerted on the wheel A by the track? Express your answer to two significant figures and include the appropriate units. μA ? nA = Value Units Submit Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining Part B If the distance h is 1.60 m, what is the vertical component of the force exerted on the wheel B by the track? Express your answer with the appropriate units. μÅ ? nB = Value Units Submit Request Answer Part…