The experiment you did in lab is repeated, using a uniform metal bar that is 80.0 cm long instead of the meterstick. Since the bar is uniform, its center of gravity is at its center. The new experiment uses different hooks for hanging the masses from the bar, with mhook = 5.0 g. As in the experiment you did in lab, x1 = 5.00 cm, m, = 300.0 g, and x, = 25.0 cm. In the new experiment, you make the same measurements as in your lab and plot x versus The line that is the best fit to your data has slope 3800 cm · g. What is the mass of m2 + mhook the bar?

The experiment you did in lab is repeated, using a uniform metal bar that is 80.0 cm long instead of the meterstick. Since the bar is uniform, its center of gravity is at its center. The new experiment uses different hooks for hanging the masses from the bar, with mhook = 5.0 g. As in the experiment you did in lab, x1 = 5.00 cm, m, = 300.0 g, and x, = 25.0 cm. In the new experiment, you make the same measurements as in your lab and plot x versus The line that is the best fit to your data has slope 3800 cm · g. What is the mass of m2 + mhook the bar?

Similar questions

A 20.4 kg mass (m) is suspended by the cable assembly as shown in the figure. The cables have no mass of their own. The cable to the left (T) of the mass makes an angle of 0.00° with the horizontal, and the cable to the right (T2) makes an angle (02) of 30.1°. If the mass is at rest, what is the tension in each of the cables, T and T2? The acceleration due to gravity T, T, is g = 9.81 m/s². N T1 = m N T2 =
A boy sits in a tire that is attached to a rope that passes over a pulley fastened to the ceiling and then passes back down to the boy's hands. The weight of the boy plus the tire is W. What is the force with which the boy must pull on the free end of the rope to support weight in the tire?
Two stacked blocks are pushed along a horizontal table. Force F' is applied horizontally to the 6m block as shown: Assume there is kinetic friction at the interface between the 6m block and the table, and static friction at the interface between the two blocks. If m = 4.3 kg, μ s= 0.57, and μ k= 0.34, what is the maximum force F' that can be exerted without the top block slipping? Express your answer in N, to at least one digit after the decimal point.
A 150.8-N bird feeder is supported by three cables as shown in the figure below. Find the tension in each cable. A bird feeder is suspended from a vertical cable. The top left cable of the cable is tied to two other cables. The left and right cables go up and to the left and up and to the right, respectively, from the connection point to a horizontal bar. The left cable makes an angle of 60° with the bar. The right cable makes an angle of 30° with the bar. right cable bottom cable N 60° 30° Bird food