Answered: A 1.90 cm x 1.90 cm square loop of wire… | bartleby

Related questions

Question

A 1.90 cm x 1.90 cm square loop of wire with
resistance 1.00x10-2 N has one edge parallel to a
long straight wire. The near edge of the loop is 1.00
cm from the wire. The current in the wire is
increasing at the rate of 130 A/s.
Part A
What is the current in the loop?
Express your answer in microamperes.
ΑΣφ
?
µA
Submit
Request Answer

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A 90 M2 resistor has a current of 0.68 A and is connected in series with a 110 resistor. Part A What is the emf of the battery to which the resistors are connected? Express your answer using two significant figures. IVE ΑΣΦ ε = ? kV
Part A When a current passes through the body, it is mainly carried by positively charged sodium ions (Na+) with charge +e and negatively charged chloride ions (Cl) with charge-e. In a given electric field, these two kinds of ions do not move at the same speed; the chloride ions move 50% faster than the sodium ions. If a current of 170 μA is passed through the leg of a patient, how many chloride ions pass a cross section of the leg per second? Express your answer as a number of chloride ions. ΕΕ ΑΣΦΑ Na- Submit Request Answer Provide Feedback ? ions Next >
A power plant needs to generate Po= 340MW of power for a city 10km away. The city power outlets need to operate at 120V. Part A One idea might be to run the power lines at 120V so homes can directly tap into the power lines. What is the current needed to do this? (Hint: use P-IV). |VD ΑΣΦ ? |= Amps Submit Request Answer Part B The power lines have a resistance of 0.2 0/km. What are the ohm-ic losses (L.e. the power dissipated via resistance) in the power lines to transport the energy from the power plant to the city if we use the current from 1²R part (a)? (HINT: compute the total resistance of the power lines and then use P VG ΑΣΦ 5 A W P=
Two 9.0-cm-diameter metal plates 1.2 cm apart are charged to +12.5 nC. They are suddenly connected together by a 0.218-mm-diameter copper wire stretched taut from the center of one plate to the center of the other. Part A What is the maximum current in the wire? Express your answer with the appropriate units. ► View Available Hint(s) Imax = 2.67 10³ A ?
A1
Part A The starter motor of a car engine draws a current of 120 A from the battery. The wire to the motor is 5.00 mm in diameter and 1.2 m long. The starter motor runs for 0.770 s until the car engine starts. copper How much charge passes through the starter motor? Express your answer with the appropriate units. 円A <. 190 C. Submit Previous Answers Request Answer X Incorrect; Try Again; 2 attempts remaining Part B How far does an electron travel along the wire while the starter motor is on Express your answer with the appropriate units. HA 0.694 mm Submit Previous Answers Request Answer X Incorrect; Try Again; 5 attempts remaining Tarch
In an integrated circuit, the current density in a 2.3-um-thick x 75-um-wide gold film is 7.0x105 A/m² Part A How much charge flows through the film in 15 min? Express your answer to two significant figures and include the appropriate units. Q = μA Value Submit Request Answer Units ?
need help on c and e
J = An electron is moving at a constant speed of 23.7 m/s on a circle of radius 3.89 m. o Express the circumference of the circle in terms of its radius, r. Express the time interval, T, for the electron to finish one circle in terms of the circumference and the speed. Express the current in terms of the fundamental charge, e. Calculate the numerical value, in amperes, of the current. A
The wiring in a house must be thick enough so it does not become so hot as to start a fire. Part A What diameter must a copper wire be if it is to carry a maximum current of 40 A and produce no more than 1.4 W of heat per meter of length? Express your answer using two significant figures. ? d = m