Part A Describe how to use this galvanometer to make an ammeter to read currents up to 35 A. A galvanometer has an internal resistance of 31 N and deflects full scale for a 45-µA current. O A resistor must be placed in series with the galvanometer. O A resistor must be placed in parallel with the galvanometer. Submit Request Answer Part B What is the value of this resistor? Express your answer to two significant figures and include the appropriate units. R = Value Units Submit Request Answer Part C Describe how to use this galvanometer to make a voltmeter to give a full-scale deflection of 300 V. O A resistor must be placed in parallel with the galvanometer. O A resistor must be placed in series with the galvanometer.

Part A Describe how to use this galvanometer to make an ammeter to read currents up to 35 A. A galvanometer has an internal resistance of 31 N and deflects full scale for a 45-µA current. O A resistor must be placed in series with the galvanometer. O A resistor must be placed in parallel with the galvanometer. Submit Request Answer Part B What is the value of this resistor? Express your answer to two significant figures and include the appropriate units. R = Value Units Submit Request Answer Part C Describe how to use this galvanometer to make a voltmeter to give a full-scale deflection of 300 V. O A resistor must be placed in parallel with the galvanometer. O A resistor must be placed in series with the galvanometer.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 55P: A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any...

See similar textbooks

Similar questions

A 12-guage gold wire has a length of 1 meter. (a) What would be the length of a silver 12-gauge wire with the same resistance? (b) What are their respective resistances at the temperature of boiling water?
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
moodle.nct.edu.om/m arning Portal Courses Reports e-Services - Academic Departments ETC CIMS - äö pio Moving Forward purses / PHYS1100 / Homework No.2/ Homework No.2 An iron wire has a diameter 3.05 mm and resistivity 9.71x 10-8 Qm. What will be the length of this wire to make a resistance of 302. What will be the new resistance, if the radius is doubled? (a) Length of the wire (in m) = (b) Resistance of the wire (in )N = Next page Upload your Homework 2 Answer - Jump to.. pad - Quiz-2 OneDrive CH6VZR403C NG 4) G E DELL
C Resistance of potentiometer wire is 192 per meter. A Daniel cell of e.m.f. 1.08 V balances at 216 cm on this potentiometer. Calculate current through the wire. Also calculate balancing length for another cell of e.m.f. 1.5 V on the same potentiometer.
In the circuit shown, Determine the following: A. Magnitude and direction of the current (Ans. I = 0.3889 A, CCW) B. The potential differences Vad, Ver and Vre
PROBLEM 08 A 1-inch diameter wire of 10-ft length (which has an internal resistance of 3 kQ, and thermal conductivity of 300 W/m-C) experiences a current of 10 amperes. Because of this, the heat generated from the caused the melting of the wire starting from the center (the melting temperature of the wire is 2300°C). It was found that the melted part of the wire has a radius of 0.1 in from which conduction of electricity no longer generates heat. Other given: Q = 2.02 x 108 W/m3 a. What would be the temperature profile of the wire (T = f(r)) if the constants from integration where found to be C1 = 271,088.04 W/m, and C2 = 929,466.79 W/m? b. What would be the temperature of the wire at r = 0.5 in? c. What would be the heat flowrate at r= 0.1 in?
A steel wire, of length L and diameter D, has a resistance of 100 . What current would flow through a silver wire of the same diameter and the same length if a 13.0 V potential difference were applied across its length? Express your answer in amperes. I = ΠΫΠΙ ΑΣΦ ! You have already submitted this an No credit lost. Try again. Submit ? Previous Answers Request Answer A Enter a new answer.
The storage battery of a car has an emf of 12 v. If the internal resistance of the battery is 0.42, what is the maxim um current that can be drawn from the battery?
Most of the wiring in a typical house can safely handle 15A of current. Atthis current level, how much charge flows through a wire in one hour?
A piece of wire of length 31.5 cm and cross-sectional area 227.4 cm² is made into a resistor of resistance 713.8 ohm. What is the resistivity of the material used to create the resistor? O a. 5113020.78 ohm-metre O b. 10.04 ohm-metre O c. 5152.96 ohm-metre d. 98.88 ohm-metre Oe. 51.53 ohm-metre Of. 515295.62 ohm-metre O g. 0.10 ohm-metre Oh. 0.99 ohm-metre
What is the equivalent resistor between the terminals a and b if you replace R1 by 38 Ohm and R2 by 34 Ohm ? This combination of resistors goes to infinity by repeating itself. Write your answer in units of Ohm. No decimal points is necessary. Maximum od 4% of error is accepted in your answer.