▼ Part A For what electric field strength would the current in a 1.7-mm-diameter nichrome wire be the same as the current in a 0.50-mm-diameter aluminum wire in which the electric field strength is 0.0090 V/m ? Express your answer to two significant figures and include the appropriate units. E = 1 μA Value Submit Request Answer Units ?

▼ Part A For what electric field strength would the current in a 1.7-mm-diameter nichrome wire be the same as the current in a 0.50-mm-diameter aluminum wire in which the electric field strength is 0.0090 V/m ? Express your answer to two significant figures and include the appropriate units. E = 1 μA Value Submit Request Answer Units ?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

How long must a 0.64-mm-diameter aluminum wire be to have a 0.60 A current when connected to the terminals of a 1.5 V flashlight battery? Express your answer to two significant figures and include the appropriate units. HA ? L = Value Units Submit Request Answer Part B What is the current if the wire is half this length? Express your answer to two significant figures and include the appropriate units. ? I = Value Units
Ⓒ Macmillan Learning A current of 31.3 mA flows in a silver wire of diameter 2.65 mm. The conductivity of silver is 6.25 x 1072-¹m-¹. Find the electric field strength E inside the wire. E = V/m
The following three questions refer to the figure below. a) Calculate the current through R₂. Use the following values: &,-8.1 V, ₂-6 V, R=R₂=7.90 and R₂ =2R₂. Enter your answer accurate to two decimals figures. E₂ R₁ ww E1 O a. 0.51 O b. 0.26 O c.0.34 O d. 1.03 R₂ www R3 a bl
qs1
Consider the circuit in (Figure 1). Suppose that v₁ = 14 V, v2 = 5 V, and i = 5 mA. Figure i + 1 of 1 5 mA source is absorbing power. 5 V and 14 V sources are developing power. 5 V and 14 V sources are absorbing power. 5 mA source is developing power. All sources are absorbing power. O All sources are developing power. Submit Correct Part G Previous Answers What is the total power developed in the circuit if the polarity of the 14 V source is reversed? Express your answer to three significant figures and include the appropriate units. P= 25 Submit mW Previous Answers Request Answer ? X Incorrect; Try Again; 3 attempts remaining
The electron drift speed in a 3.00-mm-diameter gold wire is 3.00 × 107 m/s. ▼ Part A How long does it take 1 mole of electrons to flow through a cross section of the wire? Express your answer in days. ► View Available Hint(s) t = Π ΑΣΦ B ? days
The electromotive force of a battery is given by E = 6 volts. A resistor wtih resistance R = 71 N is connected in series with the battery. What is the current through the circuit? Give your answer to at least two significance digits. A What is power loss in the resistor? (give absolute value as the input.) Give your answer to at least two significance digits. J/s
A capacitor is charged to 5.0×10-4 C, then discharged by connecting a wire between the two plates. 50 μs after the discharge begins, the capacitor still holds 13 % of its original charge. Part A What was the average current during the first 50 μs of the discharge? Express your answer using two significant figures. ΜΕ ΑΣΦ ? I = Submit Request Answer A
The high resistivity of dry skin, about 5 x 105 m, combined with the 1.5 mm thickness of the skin on your palm can limit the flow of current deeper into tissues of the body. Suppose a worker accidentally places his palm against an electrified panel. The palm of an adult is approximately a 9 cm x 9 cm square. Part A What is the approximate resistance of the worker's palm? Express your answer with the appropriate units. μA 6 C ? R= Value 4 Units Submit Request Answer
Part C Find the current through the 20 ΩΩ resistor. Part D Find the potential difference across the 20 ΩΩ resistor. Part E Find the current through the 30 ΩΩ resistor.
Part A A 55.0-cm-long hollow nichrome tube of inner diameter 2.8 mm, outer diameter 3.0 mm is connected to a 3.0 V battery. What is the current in the tube? Express your answer with the appropriate units. ? µA I = Value A
The current density of a silver wire is 3.20x106 A/m² . If the current and the drift velocity of the electrons through the wire is 2.00 A and 3.20x10-4 m/s respectively. . Part A - Find the diameter of the wire and the density of free electrons