900 Ib. 400 Ib. 60 Ib./ft 4 ft 8 ft 6 ft

Q: The tank in the figure is 40 cm wide. What is the magnitude of the resultant hydrostatic force, in…

A:

Q: 1. Determine the maximum speed that the cars of the roller-coaster can reach along the circular…

A: Given:Radius of curvature, r=20 mmaximum acceleration, amax=2.5 g

Q: 9.177. Nitrogen is being pumped adiabatically in an insulated 100 mm (4 in.) pipeline in which f=…

A: Given Data: Nitrogen pumped adiabatically in an insulated pipe Pipe Diameter D=100 mm (4 in)  f=0.01…

Q: Calculate the magnitude of the tension T and the angle 0 for which the eye bolt will be under a…

A:

Q: The steel shaft has four gears with corresponding number of powers as shown. The allowable shear…

A: Find the minimum required diameter of shaft Allowable shear stress = 75 Mpa Allowable twist = 0.05…

Q: A particle moves along the path whose equation is r = 20 ft. If the angle 0 = t² radians, determine…

A:

Q: The 200-kg snowmobile with passenger is traveling down the hill such that when it is at point A, it…

A:

Q: The towline exerts a force of P = 6.8 kN at the end of the 8-m-long crane boom. (Figure 1) Figure A…

A:

Q: PART 2: ANALYSIS OF FRAMES QUESTION 1. Determine the reaction at pins at A, B and C and fixed…

A:

Q: PROBLEM 2 The elements of a floor jack are shown in the figure. If the hydraulic cylinder AB is…

A: Given DataFAB=37kNTo findL=?FEF=?FC=? ***As per our company policy we are supposed to do only three…

Q: The beam in the figure below is subjected to a load P=2.5 kN at its end. Young's modulus is 210 GPa…

A:

Q: PART 1: ANALYSIS OF BEAMS QUESTION 1. Given the simple beam ABC, determine the reaction at the hinge…

A:

Q: In the figure, rigid bar ABC is supported by axial member (1), which has a cross-sectional area of…

A: Given data: Rigid bar ABC is supported by the axial member (1). The axial member (1) has a…

Q: Example For the parallel Multiple pipe loop system. of Fig. P6.116, all pipes are 8-cm-diameter…

A: Very small variation in final answer from given answer because I took 4 digit accuracy.

Q: Refer to the diagram and consider that the pressure in each chamber is equal. Determine the…

A: The force acting on both of the piston faces must be calculated first and then the resultant force…

Q: Question 8 A steam engine isentropically expands 9.308 kg/s of steam from 0.68 MPa, 220°C. the…

A: Find the non flow work for the isentropic process.

Q: Determine the force in each member of the loaded truss. All triangles are equilateral with side…

A: Dear Student since you have posted a question with multiple sub-parts, but as per Q& A…

Q: Please give the answer as in the format asked

A:

Q: What is the the volume flow rate (m³/s) and the mass flow rate (kg/s) at the inlet at the duct exit…

A: Given data: d=50 cmP1=2.4 barT1=298.15 KV1=8 m/sP2=2 barT2=312.15 K Need to determine the volume…

Q: instantaneous discharge velocity

A: Given; Large tank with a nozzle attached contains three immiscible,   inviscid fluids as…

Q: Two flywheels of negligible mass and different radii are bonded together and rotate about a common…

A:

Q: QUESTION 2. Determine the reaction at pins at A, B and C and fixed joints. Answer in component form.…

A:

Q: Air enters the compressor of an ideal air- standard brayton cycle at 100 kPa, 300 K, with a…

A: Brayton Cycle is a type of constant pressure heat addition cycle which consists of 4-processes:-…

Q: a. The required gap so that the rails just touch one another when the temperature is increase p.…

A:

Q: 1. The amusement-park ride consists of a fixed support near 0, the 6-m arm OA, which rotates about…

A: According to the information we have an amusement park ride consist of fixed support.  arm  OA is…

Q: he atomic heat capacity of solid Mo is given by the equation 0.503x105 Cp = = 5.69 + 1.88x10-3 T –…

A: Given that , The atomic heat capacity of solid M0 is given by the equation Cp = 5.69 +1.88x10-3 T-…

Q: Generate a plot of y(x) = e-0.7x sin Wx where W 15 rad/s, and 0<x< 15. Use the colon notation to…

A: If the given expression is Y(x)=e-0.7*xplots is given above MATLAB code as follows: clc…

Q: Two steel wires AD and CD together with a copper wire BD is subjected to a force load as shown in…

A:

Q: Determine the specific volu ideal-gas equation of state

A:

Q: A rigid strut ABCD supports two concentrated loads P at points B and D. It is being supported by a…

A: Given: The area of cable, A = 120 mm^2 = 120 x 10-6 m2 The elastic modulus of the cable, E = 50 GPa…

Q: The second law of motion gives the measure of which of the following? O Acceleration O Angular…

A: State the second law of motion.

Q: A reheat steam cycle has 13,580 kPa of throttle pressure at the turbine inlet and a 37.50308414 atm…

A: Given data: Cycle : Reheat steam cycleThrottle Pressure = 13580 kPaReheat Pressure = 37.50308414…

Q: hear and moment diagrams for the beam. 8000 Ib 2500 Ib/ft 8000 Ib 40000 Ib-ft

A: To draw SFD and BMD

Q: 1) For purposes of measuring length, the human torso was a convenient tool, and gave us units…

A: Solution: Note: Dear Student! As per our guidelines, we are only allowed to answer first three parts…

Q: The forces acting on a 1-ft length of a dam are shown in Figure 1-62. The upward ground reaction…

A: Given data as per the question Horizontal force at A side =12500 lb Vertical force =30000 lb The…

Q: A certain amount of an ideal gas is initially at a pressure p, and temperature T,. First, it…

A:

Q: 5. An angle bracket ABC is restrained by a high- strength steel wire CD, and it supports a load P at…

A:

Q: 3.) THE SPRING RATE OF EACH SPRING ARE ALL THE SAME. (SR = 270N/m) WHAT IS THE-CHANGE IN LENGTH IN…

A:

Q: Situation 5. Determine the forces in cables AC and AB needed to hold the 20-kg ball D in…

A: GivenF=300Nm=20kgd=1m

Numerical Calculations

In the mid-20th century, the availability and the growth in power of digital computers led to the increase in the mathematical model in the field of engineering and science. The analysis of these detailed models needs to be increased.