7.11.1 For the RL circuit shown in the image below, the switch has been closed for along time, and it opens at t= 0. If R1 = 6 S2 and R2 = 4 S2, determine the energystored in the inductor when t = 0. Please pay attention: the numbers may changesince they are randomized. Your answer must include 3 places after the decimalpoint, and the proper Sl unit.t = 0R14 Hell24 V(+4ΩR2Your Answer:Answerunits 7.11.2 For the RL circuit shown in the image below, the switch has been closed for along time, and it opens at t = 0. If R1 = 1 2 and R2 = 3 2, determine the currentthrough the inductor, i, when t = 0.04 s. Please pay attention: the numbers maychange since they are randomized. Your answer must include 3 places after thedecimal point, and the proper SI unit.t = 0R,4 Hll24 V(+4 2R2Your Answer:Answerunits

Answered: Image /qna-images/answer/1ce07831-16d3-4548-8e31-fee792af1686.jpg

7.11.1 For the RL circuit shown in the image below, the switch has been closed for a long time, and it opens at t = 0. If R1 = 6 S2 and R2 = 4 S2, determine the energy stored in the inductor when t = 0. Please pay attention: the numbers may change since they are randomized. Your answer must include 3 places after the decimal point, and the proper Sl unit. t = 0 R1 4 H ell 24 V(+ 4Ω R2 Your Answer: Answer units

7.11.1 For the RL circuit shown in the image below, the switch has been closed for a long time, and it opens at t = 0. If R1 = 6 S2 and R2 = 4 S2, determine the energy stored in the inductor when t = 0. Please pay attention: the numbers may change since they are randomized. Your answer must include 3 places after the decimal point, and the proper Sl unit. t = 0 R1 4 H ell 24 V(+ 4Ω R2 Your Answer: Answer units

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A battery, resistor, capacitor and switch are connected in series to form an RC circuit as shown below. The switch is closed at time t=0 s. Which of the following statements regarding the circuit is correct? Switch S t M R C + 1 O The potential difference across the capacitor is always greater than the potential difference across the resistor O The potential difference across the resistor is always greater than the potential difference across the capacitor. O Once the capacitor is essentially fully charged, there is no appreciable current in the circuit. O The capacitor charges to its maximum value in one time constant and the current is zero at that time. O The potential difference across the resistor and the potential difference across the capacitor are always equal.
4) Consider the circuit shown in the Figure, where C₁ = 6.00 µF, C₂ = 3.00 μF, and AV=20.0 V. Capacitor C₁ is first charged by the closing of switch S₁. Switch S₁ is then opened, and the charged capacitor is connected to the uncharged capacitor by the closing of S₂. Calculate the final charge on C₂. A) 120 µC B) 80 µC C) 40 μC D) 60 μC E) 20 μC AI LI 5
7 Use Kirchhoff's loop rule to R2 write two equations describing this cir- cuit (assuming the switch is closed). You may use any of the symbols in the fig- ure and any currents or capacitor charges that you define. opyright C1 C2
-In the circuit shown on the right the switch S has been open for a long time. What is the current flow through the inductor (0, 2 to 1, or 1 to 2) ? -In the circuit shown on the right the switch S has been open for a long time. At the instant the switch S is closed, the current flow through the inductor is (0, 1 to 2, or 2 to 1)? -In the circuit shown on the right the switch S has been open for a long time. The current flow through the inductor is (increasing, steady, or decreasing)? -In the circuit shown on the right the switch S has been open for a long time. Immediately after the switch S is closed, the current flow through the inductor is (increasing, steady, or deacreasing)? -In the circuit shown on the right the switch S has been closed for a long time. The current flow through the inductor is (1 to 2, 2 to 1, or 0)? -In the circuit shown on the right the switch S has been closed for a long time. At the instant the switch S is opened, the current flow through the inductor is (1…
Hello I need help with part A and part B and part C is there any possible way that you could help me with those three parts and can you label them as well
All capacitors were initially discharged.at t = 0, S1 is placed at position 1 and S2 is closed.At t = 15 ms, S1 is placed at position 2 and S2 is kept closed. At t = 25 ms, S1 is kept at position 2 and S2 is opened.after 25 ms, the voltage vT will Question options: increase until it reaches the battery voltage at steady state exponentially decay to zero stay constant be a sine wave