The switch S₁ remains open at all times and the switch S2 closes at t= 0. From the figure, determine the initial and final conditions of the voltage across the capacitor. S₁ R₁ 20 V + VC C₁ R₂ www C₂ R3 R₁3 14 A The values of Vs = 20 V, R₁ = 25 ohm, R2 = 24 ohm, R3 = 23 ohm, R4 = 26 ohm, C₁=C₂=4 F, and Is=4 A. The initial and final values are V and 13.87 V.

The switch S₁ remains open at all times and the switch S2 closes at t= 0. From the figure, determine the initial and final conditions of the voltage across the capacitor. S₁ R₁ 20 V + VC C₁ R₂ www C₂ R3 R₁3 14 A The values of Vs = 20 V, R₁ = 25 ohm, R2 = 24 ohm, R3 = 23 ohm, R4 = 26 ohm, C₁=C₂=4 F, and Is=4 A. The initial and final values are V and 13.87 V.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

THE SUBJECT IS BASIC ELECTRICAL ENGINEERING Chapter 11. Capacitor
switch In the figure, suppose the switch has been closed for a time interval sufficiently long for the capacitor to become fully charged. Find (a) The steady-state current in each resistor. (b) The charge Q on the capacitor. (c) The switch is now opened att = 0. Immediately after the switch is opened, what is the current through 1. R = 8.00 N E = 42.0 V! R2 6.00 0 %3D R3 = 3.00 N :C 4.00 µF each resistor?
THE SUBJECT IS BASIC ELECTRICAL ENGINEERING Chapter 11. Capacitor
Switch S in in the figure is closed at time t = 0, to begin charging an initially uncharged capacitor of capacitance C = 15.1 µF through a resistor of resistance R = 22.4 2. At what time is the potential across the capacitor equal to that across the resistor? +0 www R
In the diagram below, the switch S has been closed for a long time. A) What is the output voltage Vout? What is the charge on the capacitor? b) The switch is opened, so the output voltage increases. What is the time constant that describes the charging of the capacitor in terms of R and C? c) When Vout reaches 10 V, the switch closes and the capacitor begins to discharge. What is the time constant that describes the discharging in terms of R and C? Hint: Apply Kirchhoff's Rules to both loops and the sum of the currents at the junction above the capacitor in the diagram, and use I=dq/dt. If the switch opens when Vout reaches a lower value, say 5V, the capacitor will charge again, and thus one can cycle the voltage with a time constant determined by the circuit: this demonstrates the principle of operation of an electronic timer. 4R S 15 V Vout R
Find the voltage v1 across the capacitor as shown in figure below due to DC voltage source.
True or false question. When a capacitor is charging, the voltage of the capacitor increases linearly (i.e., at a constant rate).
The magnitude of the voltage applied to the electrodes of a welding machine can be adjusted in the circuit below. In the range of minimum and maximum value that variable value resistor can take What is the time interval that the capacitor will charge from 0 to 8 V?
In the figure ɛ = inductor is ideal. If the switch is closed for a long time, what is the current through the inductor. Give your answer in A. 10.0 V, R, = 4.00 N, and R2 = 1.00 N. The %3D %3D
The current in a 20 mH inductor has the waveform shown in Figure Q1(c). Draw the waveform for the inductor voltage. i(t) (mA) 20 – 2 t (ms) Figure Q1(c)