Please answer in typing format !Required informationNOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part.Consider the figure shown below.v (V)12 35Determine the current flowing through a 11 nF capacitor. (You must provide an answer before moving on to the next part.)The current through the 11 nF capacitor issin it nA.

Given waveform is a cosine function,- Amplitude = 4 V- Period = 2 s V(t) = 4cos(πt)…

Answered: ! Required information NOTE: This is a…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PA: You are an electrician working in an industrial plant. You discover that the problem with a certain...

See similar textbooks

Similar questions

You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
5. A series combination of an 18.0 mF capacitor and a resistor are connected to a 125 V battery. After three seconds, the voltage across the capacitor is 49.5 V. (a) What is the resistance of the resistor? (b) If at that three second mark the battery is subsequently removed and the capacitor is allowed to discharge through the resistor then how many excess electrons will remain on the capacitor at the five second mark?
1. Capacitors
Find the charge on each of the capacitors in the figure below. A rectangular circuit contains a battery and four capacitors. A 24.0 V battery is on its left side, where the positive terminal is above the negative terminal. Its right side splits into two parallel vertical branches below the top right corner of the circuit, where there is a 1.00 µF capacitor on the left branch and a 5.00 µF capacitor on the right branch. The branches recombine, the side continues down, and then splits again into two parallel vertical branches. There is an 8.00 µF capacitor on the left branch and a 4.00 µF capacitor on the right branch. These branches then recombine and the side continues down to reach the bottom right corner of the circuit. 1.0-µF capacitor 5.0-µF capacitor 8.0-µF capacitor 4.0-µF capacitor
A circuit is comprised of an inductor, a capacitor, a battery and a switch. When a he switch is in position "a", the battery is in series with the capacitor, but the inductor is excluded. When the switch is in position "b", the capacitor and the inductor are in series, but the battery is excluded. Two voltmeters and an ammeter have been added to the circuit, as shown. Vc VL Vo > A 8% Part (a) Initially the switch is moved to position "a" where it remains until the capacitor attains its maximum charge. Enter an expression for the maximum charge on the capacitor. Inax = - A 8% Part (b) Once the capacitor is fully charged, the switch is moved from position "a" to position "b". Let q represent the charge on the capacitor, and et I represent the current measured by the ammeter at any given time after the switch is moved to position "b". Enter an expression for a Kirchhoff Loop Rule quation for the circuit that now includes both the capacitor and the inductor. -A 8% Part (c) Current is the…
In the diagram below, the switch S has been closed for a long time. A) What is the output voltage Vout? What is the charge on the capacitor? b) The switch is opened, so the output voltage increases. What is the time constant that describes the charging of the capacitor in terms of R and C? c) When Vout reaches 10 V, the switch closes and the capacitor begins to discharge. What is the time constant that describes the discharging in terms of R and C? Hint: Apply Kirchhoff's Rules to both loops and the sum of the currents at the junction above the capacitor in the diagram, and use I=dq/dt. If the switch opens when Vout reaches a lower value, say 5V, the capacitor will charge again, and thus one can cycle the voltage with a time constant determined by the circuit: this demonstrates the principle of operation of an electronic timer. 4R S 15 V Vout R

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS