Show the Solution 7. What is the value of the diameter in millimeter of a certain wire having aresistance of 0.56 Q, 40 meters in length and 2 mm? in cross section? A 200meter length of wire of the same material has a resistance of 2 Q at the sametemperature.8. Determine the resistance of a 1.25 km long cable composed of 14 strands ofsimilar copper wire conductor; each strand is 1.3 mm in diameter. Allow a 5.4%increase in length for the twist of each strand in completed cable. The specificresistance of copper is 1.72 x 10 -* Q-m.

As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Answered: 7. What is the value of the diameter in…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Please remake this screenshot and send screenshot in this post. Thank you!
The student engineer of a campus radio station wishes to verify the effectiveness of the lightning rod on the antenna mast (see the figure below). The unknown resistance Ry is between points C and E. Point E is a "true ground," but is inaccessible for direct measurement because the stratum in which it is located is several meters below Earth's surface. Two identical rods are driven into the ground at A and B, introducing an unknown resistance Ry. The procedure for finding the unknown resistance Rx is as follows. Measure resistance Ry between points A and B. Then connect A and B with a heavy conducting wire and measure resistance R, between points A and C.
What is the second equation?
solve a,b and c please. In a concentric spherical electrode system, the outer radius is 15cm, the perforation of the insulator between the spheres since its resistance is 90 kV / cm, a) Obtain the equation for the breakdown voltage. b) Since 300kV is applied between the electrodes, r1 (inner radius) can be taken to prevent piercing of the system. what range are the values? c) What is the maximum voltage value that the system can withstand?
Answer ASAP, I'll upvote. Thanks. Take the first part of the energy band figure shown below where material A is attached to material B. If a positive voltage was applied to A, and B was attached to ground, is the AB junctionforward-biased or reverse-biased? The built-in voltage of a PN junction is due to a charge gradient between the two sides of the junction, as shown by the graphs. What is the cause of this charge gradient? Answer in 1 sentence.
Difficult problem that I need some help on please
please sir solve these 2 questions
Number 2 A piece of beef steak 7 cm thick will be frozen in the freezer room -30°C. This product has a moisture content of 73%, a density of 970 kg/m³, and a thermal conductivity (frozen) of 1.1 W/(m²K). Estimate the freezing time. using the Plank equation. This product has an initial freezing temperature of -1.75°C, and the movement of air in the freezing room gives a convective heat transfer coefficient of 15 W/(m²K). t f = answer in hour
1. A Germanium sample is 5 mm long and has a rectangular cross-section, 50 μm by 150 μm. A Phosphorus atom with concentration of 4.4 x 10¹5/cm³ at 300 K is added and corresponds to one impurity atom for 107 Ge atoms. A steady current of 3 juA exists in the bar. a. Set up the equations for concentrations, conductivity, resistance, and voltage. b. Solve for the electron and hole concentration, conductivity, resistance, and voltage. 2. A basic junction diode is operating at a room temperature of 25°C and has a reverse current of 1 nA. a. Set up the different diode equations. b. Solve for the diode current at room temperature, reverse current, and threshold voltage when the temperature becomes 72°C.
Subject : Power electronics
4. For a Silicon sample, N=2 x 1012cm-3 and Na= 0 at T=300K. Determine what type of sample it is, n type or p type or intrinsic? Now the temperature is raised to T=80OK, determine what type of sample it is. Will temperature change have any effect on its type? Show mathematical calculation for your statement.
Ex

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

7. What is the value of the diameter in millimeter of a certain wire having a resistance of 0.56 0, 40 meters in length and 2 mm? in cross section? A 200 meter length of wire of the same material has a resistance of 2 Q at the same temperature.