7. The following data was obtained from laboratory tests for a cohesive specimen: moisture content, w, was 22.5%; G=2.60; and to determine the approximate unit weight, a sample having a mass of 224.0 g was placed in 500 cm³ container with 382 cm³ of water required to fill the container. a. What is the Total Unit Weight of the soil sample in kN/m³? b. What is the Dry Unit Weight of the soil sample in kN/m³ ? c. What is the void ratio?

7. The following data was obtained from laboratory tests for a cohesive specimen: moisture content, w, was 22.5%; G=2.60; and to determine the approximate unit weight, a sample having a mass of 224.0 g was placed in 500 cm³ container with 382 cm³ of water required to fill the container. a. What is the Total Unit Weight of the soil sample in kN/m³? b. What is the Dry Unit Weight of the soil sample in kN/m³ ? c. What is the void ratio?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1. The following are the results of a sieve analysis U.S. Sieve No. 4 10 20 40 60 100 200 Pan Mass of Soil retained (g) 0 18.5 53.2 90.5 81.8 92.2 58.5 26.5 a) Determine the percent finer than each sieve and plot a grain-size distribution curve. b) Determine D10, D30, and Doo. c) Calculate the uniformity coefficient Cu d) Calculate the coefficient of gradation Ce
Geotechnical Engineering Please help me answer this question, and please show your solutions write it properly. Problem 3 A soil sample with a grain specific gravity of 2.67 was filled in a 1000mL container in the loosest possible state and the dry unit weight of the sample was found to be 14.75 N. It was then filled at the densest obtainable state and the weight was found to be 17.70 N. The void ratio of the soil in the natural state was 0.63. Determine the relative density in the natural state.
In order to calculate void ratio of a soil sample, which laboratory test(s) need(s) to be conducted? a. Liquid limit test b. Drying in oven c. Pumping well test d. Pycnometer test e. Ground Penetrating Radar tests f. Hydrometer analysis
A soil specimen has a total volume of 70 cm3 and a total mass of 135.5g. After complete drying in an oven, the specimen has a mass of 122.0g. The Gs is 2.60. Determine the void ratio. Report your answer to three significant figures, and draw the full phase diagram.
The table shows the laboratory results of the sieve analysis of a sample. Plot the grain size curve of the soil. The soil has a liquid limit of 35% and plasticity index of 26%. SIEVE SIZE (mm) WEIGHT RETAINED 0.25 18.96 0.149 33.18 0.074 45.03 0.052 54.51 0.02 42.66 0.01 11.85 0.004 4.74 0.001 4.74 Pan 21.33 a.) Classify the soil using AASHTO method b.) Classify the soil using USCS method c.) Classify the soil using USDA method Please answer this asap. For upvote. Thank you in advance
The wet weight of a soil specimen is 207 g. The dried weight of the specimen is 163 g. If the volume of the specimen is measured before drying is 110 cubic centimeter, determine the Void ratio if specific gravity of solids is 2.68.
A cylindrical specimen of a cohesive soil of 11 cm diameter and 20 cm length was prepared by compaction in a mold. If the wet mass of the specimen was 3.85 kg. and its water content was 15.45%. (Specific gravity of soil solids is 2.76). Determine the void ratio of the soil. Round off to three decimal places.
Problem Set 2: 4. A sample of gray silty clay has a mass of 126 kg. Laboratory tests results give a moist density (p) of 2.05 g/cm³, a specific gravity of solids (G,) of 2.71, and a moisture content (w) of 15.7%. First determine all entries in the phase diagram. Then determine the void ratio (e), the porosity (n), the degree of saturation (S), the dry density (Pa), the dry unit weight (ya), and the moist unit weight (y). Draw the Phase diagram.
05: The Figure below represents the data that was obtained from a liquid-limit test on a soil. 50 percent of its particles is passing sieve #200. Two determinations for the plastic limit gave water contents of 20.3 % and 20.8 %. Determine 1- Liquid Limit (LL). 2- Plasticity index. 3- Liquidity index if the water content is 27.4% 4- Void ratio at the liquid limit, if G, 2.7 5- Classify the soil based on AASHTO system. 30 10 20 40 60 80 100 Penetration, d (mm) Moisture content, w ()
1. A dry sand is placed in a container having a volume of 0.0092 cubic centimeter. The dry unit weightof the sample is 0.015 gram. Water is carefully added to the container so as not to disturbed thecondition of the sand. When the container is filled, the combined weight of soil plus water is 0.0182gram.a. Determine the specific gravity of soil particle.b. Determine the dry unit weight of soil.2. If the soil sample has a water content of 11% and a unit weight of 19.67 kN/m3 , determine thepercentage of air in voids and the degree of saturation if the specific gravity of soil solid is 2.75.3. If the soil sample has a specific gravity of 2.71 and a porosity of 0.345, determine the saturated unitweight and the bouyant unit weight.4. A soil sample having a liquidity index of 0.85, a plasticity index of 16.50 and a plastic limit of 11.45.The soil sample has a specicfic gravity of 2.68 and a void ratio of 0.77.a. Compute the degree of saturation.b. Compute the air void ratio.
The following results were obtained by testing a sample of clay: water content 25.6%, liquid limit 43.5%, plastic limit 19.1%. From this compute the following: (a) Liquidity Index (b) Plasticity Index (c) Shrinkage Limit
Q # 1. Organic soils are typically characterized by high void ratio, low specific gravity, and high compressibility. Following are the results of a consolidation test on a sample of organic soil. Pressure, o (kN/m2) Change in dial reading, AH (mm) 0.284 12 0.150 24 0.315 48 0.564 100 0.823 200 2.25 400 5.34 Given that the initial height of the specimen = 20.6 mm, mass of dry specimen = 12 g, area of specimen = 31.67 cm2 and G, = 2.49. Plot the e, log o' curve. b. Determine the preconsolidation pressure. a.