A sample of moist sand taken from the field was found to have a moisture content of 14% and a porosity of 38%. In the laboratory test that simulates field conditions, it was found that at its densest state, its void ratio is 85% and at its loosest state its void ratio is 40%. Determine the void ratio. Select one: O a. 0.42 b. 0.61 c. 0.79 d. 0.57 It is the densification of soil by removal of air which require mechanical energy. Select one: a. solidification b. consolidation c. compression d. compaction What particular sand is ideal for field density test using sand cone method? Select one: O a. clean sand b. Ottawa sand c. Owatta sand d. white sand

A sample of moist sand taken from the field was found to have a moisture content of 14% and a porosity of 38%. In the laboratory test that simulates field conditions, it was found that at its densest state, its void ratio is 85% and at its loosest state its void ratio is 40%. Determine the void ratio. Select one: O a. 0.42 b. 0.61 c. 0.79 d. 0.57 It is the densification of soil by removal of air which require mechanical energy. Select one: a. solidification b. consolidation c. compression d. compaction What particular sand is ideal for field density test using sand cone method? Select one: O a. clean sand b. Ottawa sand c. Owatta sand d. white sand

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A fully saturated cylindrical triaxial sample of clay soil has approximate initial dimensions of 38mm in diameter by 76mm long. A quick undrained triaxial test is conducted on the specimen where the cell pressure is 140 kN/m2. In this the deviator stress at failure is 76 kN/m2. After the triaxial test, a water content test is conducted on the entire sample. The combined weight of the wet sample and sample container was 181.7 g. The combined weight of the oven dried sample and sample container was 147.8 g. The sample container weighs 9.2 g. The soil solids specific gravity is 2.7. What is the undrained strength of the soil? Also, what are the water content of the soil, its total (or bulk) unit weight, and its voids ratio?
A triaxial compression test was conducted on a saturated soil sample to determine its shear strength parameters: effective cohesion (C') and effective friction angle (O'). The confining pressure used during the test was 30 psi. The deviator stress on the sample at the time of failure was 40 psi. The porewater pressure measured at the time of failure was 5 psi a) The figure below shows the stress conditions on the sample at the time of failure. Provide the values of total stresses, o1 and oz on the sample. Total horizontal stress, o3 (psi) = (Report to the nearest whole number, i.e. no decimals) Total vertical stress, o1 (psi) (Report to the nearest whole number, i.e. no decimals) %3D b) The figure below shows the effective stress Mohr's Circle for the above soil sample at failure. What are the values of effective normal stresses at points A and B?
The results obtained from a series of CU test on a soil gave the following results : CCU = C'CU = 0 cu 15°; 'cu = 30° CU A sample of this soil was tested in a CU test under a cell pressure of 150 kN/m². Determine (i) deviator stress at failure (ii) pore water pressure at failure (iii) minor principal effective stress at failure (iv) major principal effective stress at failure (v) the magnitude of Skempton's pore water pressure parameter(at failure) A
# 3) A sand soil sample is subjected to a direct shear test under a normal load of 185 kPa. The specimen failed when the shear stress reached 100 kPa. If the normal load is increased to 240 kPa, what will be the shear strength of the specimen?
Following are the results of a consolidation test on a sample of undisturbed clay obtained from the field. Pressure ơ' (kN/m²) Final Height of Specimen (mm) 24 10 23.78 20 23.30 50 22.22 100 20.58 200 19.04 400 17.52 800 16.31 17.75 The height of the specimen at the beginning of the test was 24 mm and the area of specimen was 50 cm? volume of specimen was 120 cm³. The mass of dry specimen was 180.4 g. Gs= 2.68. 1. Plot the e-log ơ' curve, 2. Using Casagrande's method, determine the preconsolidation pressure. 3. Calculate the compression index, Cc
The time for 65% consolidation of a 19-mm clay specimen (drained at top and bottom) in the laboratory is 10 minutes. How long will it take for a 4-m-thick clay layer in the field to undergo 40% consolidation under the same pressure increment? In the field, there is a rock layer at the bottom of the clay.
A consolidated-drained triaxial test was conducted on a normally consolidated clay. The results were as follows: Determine: a. Angle of friction, f? b. Angle u that the failure plane makes with the major principal plane c. Normal stress, s?, and shear stress, tf , on the failure plane
A consolidated undrained triaxial test was performed on a normally consolidated clay with a critical state friction angle of 230. After an initial isotropic consolidation at a cell pressure of 50 kPa, drainage was turned off, the cell pressure was increased to 85 kPa, and the sample was loaded to ultimate conditions. A pore pressure of 55 kPa was measured at ultimate state. What value of major principal total stress was measured at the ultimate state?
In Triaxial test, which of the following parameters do not need to be recorded the confining pressure specimen diameter changes ) the generated pore pressure the axial force A Triaxial test was performed on a dry, cohesionless soil. If the sample failed vhen the minor principal stress was half of the major principal stress, the soil's angle of internal friction is: O 22.5 19.5 33.3 O 25 A technician obtained a soil void ratio of 1.5. It is okay because it is possible to measure void ratio values above 1. True False |
A sand sample is subjected to direct shear testing. Two tests areperformed. For test 1, The sample shears at a stress of 2500 psf whenthe normal stress is 4000 psf.Test 2, The sample shears at a stress of 3500 psf when the normalstress is 6000 psf. Determine the following:a) Angle of Internal frictionb) Value of cohesionc) Compute the shear stress at a depth of 12 ft. if the unit weight ofthe soil is 150 pcf
A consolidated undrained tri-axial test was conducted on a normally consolidated clay sample and the results are as follows: chamber confining pressure = 110kpa deviator stress at failure = 96kpa pore water pressure = 66kpa these test results were used to determine the drained friction angle of the soil. compute the deviator stress in (kpa) at failure when the drained test was conducted with the chamber confining pressure changed to 163kpa.
A consolidated-undrained test was conducted on a normally consolidated clay sample. The results are as follows: Undrained angle of friction = 38.65°, Drained angle of friction = 62.59°, Deviator stress at failure = 509 lb/ft^2. Determine the pore water stress at failure in lb/ft^2.